Shanxin Xiong

Water-Processable Polyaniline with Covalently Bonded Single-Walled Carbon Nanotubes: Enhanced Electrochromic Properties and Impedance Analysis

Hybrid electrochromic materials were readily synthesized via copolymerization of aniline with p-phenylenediamine-functionalized single-walled carbon nanotubes (SWCNTs) in the presence of poly(styrene sulfonate) (PSS) dopant in an aqueous medium. Polyaniline (PANI)-grafted SWCNTs are formed, and they are uniformly dispersed in the PANI/PSS matrix. Impedance analysis shows that the charge-transfer resistances of the hybrids at all states are reduced drastically with increasing SWCNT loading. With 0.8 wt % SWCNTs, the charge-transfer resistances of the hybrid at +1.5 and -1.5 V are only about 20% and 12% of those of PANI/PSS, respectively, which is due to the greatly increased redox reactivity given by the enhanced electron transport in the hybrid and further doping function of the SWCNTs. The remarkable increase in redox reactivity leads to much enhanced electrochromic contrast from 0.34 for PANI to 0.47 for PANI-SWCNT-0.8%.

High ionic conductivity P(VDF-TrFE)/PEO blended polymer electrolytes for solid electrochromic devices

Solid polymer electrolytes with excellent ionic conductivity (above 10(-4) S cm(-1)), which result in high optical modulation for solid electrochromic (EC) devices are presented. The combination of a polar host matrix poly(vinylidene fluoride-trifluoroethylene) P(VDF-TrFE) and a solid plasticized of a low molecular weight poly(ethylene oxide) (PEO) (M(w)≤ 20,000) blended polymer electrolyte serves to enhance both the dissolution of lithium salt and the ionic transport. Calorimetric measurement shows a reduced crystallization due to a better intermixing of the polymers with small molecular weight PEO. Vibrational spectroscopy identifies the presence of free ions and ion pairs in the electrolytes with PEO of M(w)≤ 8000. The ionic dissolution is improved using PEO as a plasticizer when compared to liquid propylene carbonate, evidently shown in the transference number analysis. Ionic transport follows the Arrhenius equation with a low activation energy (0.16-0.2 eV), leading to high ionic conductivities. Solid electrochromic devices fabricated with the blended P(VDF-TrFE)/PEO electrolytes and polyaniline show good spectroelectrochemical performance in the visible (300-800 nm) and near-infrared (0.9-2.4 μm) regions with a modulation up to 60% and fast switching speed of below 20 seconds. The successful introduction of the solid polymer electrolytes with its best harnessed qualities helps to expedite the application of various electrochemical devices.

Toward Electrochromic Device Using Solid Electrolyte with Polar Polymer Host

Polymer electrolyte is an important component in many multilayer devices such as batteries, fuel cells, and electrochromic devices. The effects of polymer electrolyte solidification on the ionic movement and device performance are presented based on near-infrared (IR) (860-2500 nm) electrochromic (EC) devices using the conducting polymer polyaniline. EC devices using electrolyte with polar polymer host of P(VDF-TrFE) show stable and reversible light modulation up to 65% in gel state and 30% in solid state. This is significantly improved when compared to devices with solidified nonpolar polymer host which retains less than 10% light modulation. Electrochemical impedance combined with in situ light modulation measurement identifies various key characteristics exerted by the electrolyte states on device performance. Gel-state devices are affected by the amount of dissociated ions while ionic movement in the electrolyte bulk and through the electrolyte/EC material interface dictates the light modulation in semisolid devices. For solid-state devices, electronic leakage, ionic dissociation, and interaction with electrochrome molecules have been found to limit the operation.

Supercritical Carbon Dioxide-Treated Electrospun Poly(vinylidene fluoride) Nanofibrous Membranes: Morphology, Structures and Properties as an Ionic-Liquid Host

A reverse-barrier technique is used to enable the treatment of electrospun poly(vinylidene fluoride) nanofibrous membranes with supercritical carbon dioxide. The treatment induces the formation of nanopores and extended-chain β crystallites of small lateral dimensions in the nanofibers. It also creates interfiber junctions, resulting in a remarkable improvement in mechanical properties of the membranes. The treated membranes are able to retain their shape very well after loading with an ionic liquid (IL). The ionic conductivity of the IL-loaded membrane is very close to that of the neat IL.

Modulating the Electrochromic Performances of Transmissive and Reflective Devices Using N,N-Dimethyl Formamide Modified Poly(3,4-Ethylenedioxythiophene)/Poly(Styrene Sulfonate) Blend as Active Layers

As one of the important factors which affect the properties and applications of conducting polymers, the electrical conductivity of a poly(3,4-ethylenedoxy-thiophene)/ poly(styrene sulfonate) (PEDOT: PSS) blend was adjusted by using various amount of an organic solvent (N,N-dimethyl formamide, DMF) as an additive. The conductivities of PEDOT: PSS thin films can be increased dramatically, from 1.0 S to 32.1 S cm−1, with a 2/1 volume ratio of PEDOT: PSS/DMF loading after totally removing the organic solvent by annealing the film at 80° for 48 h in a vacuum oven. The optical contrasts of transmissive and reflective devices assembled using DMF-modified PEDOT: PSS as active layers exhibited a close relationship with the conductivity of PEDOT: PSS. Interestingly, high conductivity of PEDOT: PSS enhanced the contrast of a transmissive device, while high conductivity of PEDOT: PSS decreased the contrasts of a reflective device. The underlying reason is related to the different electrochromic mechanisms of these two types of device configurations.

Electrochromic Behaviors of Water-Soluble Polyaniline with Covalently Bonded Acetyl Ferrocene

A novel ferrocene-containing hybrid electrochromic material was synthesized via copolymerization of aniline with p-phenylenediamine functionalized acetyl ferrocene in the presence of poly (styrene sulfonate) dopant in an aqueous medium, and neat polyaniline (PANI) was prepared for comparison. The polymerization characteristics and the structure of the copolymer were systematically studied by Fourier-transform infrared, meanwhile, their electrochromic properties and electrochemical behaviors were tested by UV–vis spectra, cyclic voltammetry and electrochemical impedance spectroscopy (EIS). It was found that the strong covalent bond and large conjugated system between PANI and ferrocene enhance the electron transfer rate and electron delocalization in the ferrocene-polyaniline (Fc-PANI) hybrid. In particular, the electrochromic device with Fc-PANI as the active layer shows significant enhancement in optical contrast over the PANI-based device.