Sherin F. Hammad

Simultaneous determination of loratadine and pseudoephedrine sulfate in pharmaceutical formulation by RP-LC and derivative spectrophotometry ☆

Highly sensitive, simple and accurate reversed phase liquid chromatographic and first derivative spectrophotometric methods for determination of antihistaminic drug loratadine [I] and nasal decongestant drug pseudoephedrine sulfate [II] are described. The HPLC method involves separation of [I] and [II] on micro-BondaPak C18 column using mixture of (methanol:H(2)O:phosphoric acid:ammonium dihydrogen phosphate) (220:300:2:3 g) (V/V/V/W), 60 and 40% acetonitrile as mobile phase flowing at 2 ml/min with ultraviolet detection at 247 nm. The calibration graphs are linear from 5 to 100 microg/ml for [I] and from 120 to 1200 microg/ml for [II] the detection limits are 0.5 microg/ml for [I] and 60 microg/ml for [II]. The spectrophotometric method is based on recording the first derivative spectra for [I] and [II] at 307, 266 nm, respectively, of their solutions in 0.1 M hydrochloric acid using the acid as blank. The calibration graphs are linear in the range of 5-25 microg/ml for [I] and 240-720 microg/ml for [II]; the limits of detection are 0.16 microg/ml for [I] and 10 microg/ml for [II]. The mean percentage recoveries obtained for different synthetic mixtures by using this method are 97.6% with coefficient of variation 1.79 for [I] and 101.6% with coefficient of variation 1.95 for [II]. The two methods have been applied successfully for the determination of [I] in its combination with [II] Clarinase tablets and [I] alone in different pharmaceutical dosage forms.

Development and Validation of Chemometric-Assisted Spectrophotometric Methods for Simultaneous Determination of Phenylephrine Hydrochloride and Ketorolac Tromethamine in Binary Combinations.

The present work describes new spectrophotometric methods for the simultaneous determination of phenylephrine hydrochloride and ketorolac tromethamine in their synthetic mixtures. The applied chemometric techniques are multivariate methods including classical least squares, principal component regression, and partial least squares. In these techniques, the concentration data matrix was prepared by using the synthetic mixtures containing these drugs dissolved in distilled water. The absorbance data matrix corresponding to the concentration data was obtained by measuring the absorbances at 16 wavelengths in the range 244-274 nm at 2 nm intervals in the zero-order spectra. The spectrophotometric procedures do not require any separation steps. The accuracy, precision, and linearity ranges of the methods have been determined, and analyzing synthetic mixtures containing the studied drugs has validated them. The developed methods were successfully applied to the synthetic mixtures and the results were compared to those obtained by a reported HPLC method.

Fluorogenic derivatization of aryl halides based on the formation of biphenyl by Suzuki coupling reaction with phenylboronic acid

The fluorogenic derivatization method for aryl halide was developed for the first time. This method was based on the formation of fluorescent biphenyl structure by Suzuki coupling reaction between aryl halides and non-fluorescent phenylboronic acid (PBA). We measured the fluorescence spectra of the products obtained by the reaction of p-substituted aryl bromides (i.e., 4-bromobenzonitrile, 4-bromoanisole, 4-bromobenzoic acid ethyl ester and 4-bromotoluene) with PBA in the presence of palladium (II) acetate as a catalyst. The significant fluorescence at excitation maximum wavelength of 275-290 nm and emission maximum wavelength of 315-350 nm was detected in all the tested aryl bromides. This result demonstrated that non-fluorescent aryl bromides could be converted to the fluorescent biphenyl derivatives by the coupling reaction with non-fluorescent PBA. We tried to determine these aryl bromides by HPLC-fluorescence detection with pre-column derivatization. The aryl bromide derivatives were detected on the chromatogram within 30 min without any interfering peak derived from the reagent blank. The detection limits (S/N=3) for aryl bromides were 13-157 fmol/injection.

Earth-friendly spectrophotometric methods for simultaneous determination of ledipasvir and sofosbuvir: Application to average content and uniformity of dosage unit testing

Simple, rapid, sensitive, accurate, precise and earth-friendly spectrophotometric methods were developed for the simultaneous analysis of ledipasvir (LED) and sofosbuvir (SOF) without interference of both sunset yellow dye and copovidone excipients (the most probable interferents) in their combined dosage form. These proposed methods were based on measurement of LED in synthetic mixtures and combined dosage form by first derivative (1D) spectrophotometry at 314 nm over the concentration range of 2-50 μg mL-1 with coefficient of determination (R2) > 0.9999, mean percentage recovery of 99.98 ± 0.62. On the other hand, SOF in synthetic mixtures and combined dosage form was determined by five methods. Method I is based on the use of 1D spectrophotometry at 274.2 nm (zero crossing point of LED). Method II involves the application of conventional dual wavelength method (DW) at the absolute difference between SOF zero order amplitudes at 261 nm (λmax of SOF) and 364.7 nm. At these wavelengths, the absolute difference between LED zero order amplitudes was observed to equal zero. Method III depends on isosbestic point method (ISP) in which the total concentration of both drugs was measured at isosbestic point at 262.7 nm. Concentration of SOF could be obtained by subtraction of LED concentration. While, method IV depends on absorbance correction method (absorption factor method), which is based on determination of SOF concentration at 262.7 nm (λISP) and LED at 333 nm (λmax of LED). Finally, method V depends on absorbance ratio method (Q-analysis) in which 262.7 nm (λISP) and 261 nm (λmax of SOF) were selected to determine SOF concentration. The linearity range for all methods for SOF determination was 2-50 μg mL-1 with coefficient of determination (R2) > 0.9999. Methods I, II & III were also applied for determination of SOF concentration in single dosage form. Their mean percentage recoveries were 100.35 ± 1.85, 99.97 ± 0.54 and 100.03 ± 0.49, for the three methods respectively. The proposed methods were validated according to international conference of harmonization (ICH) requirements and statistically compared to published reference methods. The ANOVA test confirmed that there is no significant differences between the proposed methods, and can be used for routine analysis of LED and SOF in commercial tablets. These developed methods were applied to estimate the average content and uniformity of dosage unit for LED/SOF combined dosage form and SOF single dosage form according to British pharmacopeia (BP) requirements.

Simultaneous determination of amlodipine and metoprolol in their combined dosage form using a synchronous fluorescence spectrofluorimetric method

Highly sensitive, rapid, accurate and precise synchronous fluorescence spectrofluorimetric method has been developed for simultaneous analysis of a mixture of amlodipine (AMD) and metoprolol (MET). The method relies on measuring the relative synchronous fluorescence intensity of both drugs at Δλ of 90 nm in acetate buffer solution at pH 5. The experimental parameters influencing the developed method were investigated and optimized. The method was linear over the ranges 0.2-2 μg/ml and 0.5-10 μg/ml for AMD and MET, respectively. The limits of detection were 50 ng/ml for AMD and 130 ng/ml for MET while the limits of quantitation were 150 ng/ml for AMD and 390 ng/ml for MET. The developed method was applied successfully for the determination of the two drugs in their co-formulated tablet. The mean percent recoveries were found to be 100.51 and 99.57 for AMD and MET, respectively.

Three Spectrophotometric Methods for Determination of Alogliptin Benzoate and Pioglitazone HCl in Combined Tablet Dosage Form

Abstract Three simple, accurate and precise spectrophotometric methods have been developed and validated for simultaneous determination of alogliptin benzoate and pioglitazone HCl in bulk and in tablet dosage form. Method I was area under curve method and it involved measurement of area at selected wavelength range; the selected wavelength range was 275-285 nm for ALG and 263-273 nm for PIO. Method II involved the use of first derivative of ratio spectra (1DD) using PIO (10 μg/mL) as a divisor for ALG determination, then peak amplitude at 300 nm was directly proportional to ALG concentration; and ALG 5 μg/mL as a divisor for PIO determination, then peak amplitude at 277 nm was directly proportional to PIO concentration. Method III was ratio difference method and it involved measurement of difference in amplitudes (ΔP) in the ratio spectra; ΔP292-238 was directly proportional to ALG concentration and ΔP260-239 was directly proportional to PIO concentration. The three proposed methods were linear over the range 5-30 μg/mL for ALG and 5-50 μg/mL for PIO. The methods were validated according to ICH guidelines. Statistical comparison of the proposed methods with the reported HPLC method using F and t tests showed no significant difference regarding both accuracy and precision.

Development and Validation of Chemometric Spectrophotometric Methods for Simultaneous Determination of Simvastatin and Nicotinic Acid in Binary Combinations

BACKGROUND The development and introduction of combined therapy represent a challenge for analysis due to severe overlapping of their UV spectra in case of spectroscopy or the requirement of a long tedious and high cost separation technique in case of chromatography. Quality control laboratories have to develop and validate suitable analytical procedures in order to assay such multi component preparations. METHODS New spectrophotometric methods for the simultaneous determination of simvastatin (SIM) and nicotinic acid (NIA) in binary combinations were developed. These methods are based on chemometric treatment of data, the applied chemometric techniques are multivariate methods including classical least squares (CLS), principal component regression (PCR) and partial least squares (PLS). In these techniques, the concentration data matrix were prepared by using the synthetic mixtures containing SIM and NIA dissolved in ethanol. The absorbance data matrix corresponding to the concentration data matrix was obtained by measuring the absorbance at 12 wavelengths in the range 216 - 240 nm at 2 nm intervals in the zero-order. The spectrophotometric procedures do not require any separation step. The accuracy, precision and the linearity ranges of the methods have been determined and validated by analyzing synthetic mixtures containing the studied drugs. CONCLUSION Chemometric spectrophotometric methods have been developed in the present study for the simultaneous determination of simvastatin and nicotinic acid in their synthetic binary mixtures and in their mixtures with possible excipients present in tablet dosage form. The validation was performed successfully. The developed methods have been shown to be accurate, linear, precise, and so simple. The developed methods can be used routinely for the determination dosage form.