Simon D. Connell

The Effect of Fluoride on the Developing Tooth

This review aims to outline the effects of fluoride on the biological processes involved in the formation of tooth tissues, particularly dental enamel. Attention has been focused on mechanisms which, if compromised, could give rise to dental fluorosis. The literature is extensive and often confusing but a much clearer picture is emerging based on recent more detailed knowledge of odontogenesis. Opacity, characteristic of fluorotic enamel, results from incomplete apatite crystal growth. How this occurs is suggested by other changes brought about by fluoride. Matrix proteins, associated with the mineral phase, normally degraded and removed to permit final crystal growth, are to some extent retained in fluorotic tissue. Fluoride and magnesium concentrations increase while carbonate is reduced. Crystal surface morphology at the nano-scale is altered and functional ameloblast morphology at the maturation stage also changes. Fluoride incorporation into enamel apatite produces more stable crystals. Local supersaturation levels with regard to the fluoridated mineral will also be elevated facilitating crystal growth. Such changes in crystal chemistry and morphology, involving stronger ionic and hydrogen bonds, also lead to greater binding of modulating matrix proteins and proteolytic enzymes. This results in reduced degradation and enhanced retention of protein components in mature tissue. This is most likely responsible for porous fluorotic tissue, since matrix protein removal is necessary for unimpaired crystal growth. To resolve the outstanding problems of the role of cell changes and the precise reasons for protein retention more detailed studies will be required of alterations to cell function, effect on specific protein species and the nano-chemistry of the apatite crystal surfaces.

Atomic Force Microscopy-Based Molecular Recognition of a Fibrinogen Receptor on Human Erythrocytes

The established hypothesis for the increase on erythrocyte aggregation associated with a higher incidence of cardiovascular pathologies is based on an increase on plasma adhesion proteins concentration, particularly fibrinogen. Fibrinogen-induced erythrocyte aggregation has been considered to be caused by its nonspecific binding to erythrocyte membranes. In contrast, platelets are known to have a fibrinogen integrin receptor expressed on the membrane surface (the membrane glycoprotein complex alpha(IIb)beta(3)). We demonstrate, by force spectroscopy measurements using an atomic force microscope (AFM), the existence of a single molecule interaction between fibrinogen and an unknown receptor on the erythrocyte membrane, with a lower but comparable affinity relative to platelet binding (average fibrinogen--erythrocyte and --platelet average (un)binding forces were 79 and 97 pN, respectively). This receptor is not as strongly influenced by calcium and eptifibatide (an alpha(IIb)beta(3) specific inhibitor) as the platelet receptor. However, its inhibition by eptifibatide indicates that it is an alpha(IIb)beta(3)-related integrin. Results obtained for a Glanzmann thrombastenia (a rare hereditary bleeding disease caused by alpha(IIb)beta(3) deficiency) patient show (for the first time) an impaired fibrinogen--erythrocyte binding. Correlation with genetic sequencing data demonstrates that one of the units of the fibrinogen receptor on erythrocytes is a product of the expression of the beta(3) gene, found to be mutated in this patient. This work demonstrates and validates the applicability of AFM-based force spectroscopy as a highly sensitive, rapid and low operation cost nanotool for the diagnostic of genetic mutations resulting in hematological diseases, with an unbiased functional evaluation of their severity.

Dental enamel—a biological ceramic: regular substructures in enamel hydroxyapatite crystals revealed by atomic force microscopy

Hydroxyapatite crystals from developing rat incisor enamel and polished sections of mature human dental enamel were investigated using Atomic and Chemical Force Microscopy. Regular substructures were seen on crystals comprising ∼40 nm wide morphologically and chemically defined bands across the crystal long axes. Exposure to low pH resulted in selective dissolution between bands and the emergence of 2–3 spherical structures within each band. The spherical structures were chemically distinct exhibiting high friction in lateral force mode. Enamel crystals appear to comprise stacks of roughly hexagonal arrays of chemically or structurally distinct spherical subunits.

The atomic force microscope as a tool for studying phase separation in lipid membranes (Review)

Atomic force microscopy has developed into a powerful tool in the study of phase separation in lipid bilayers. Its ability to image a semi-fluid surface under buffer at nanometre lateral resolution and Angstrom resolution vertically allows us to distinguish phase separated lipid domains, models of the elusive rafts postulated to exist as functional platforms in the cellular membrane, which may only rise 0.3 nm above the surrounding membrane. This review charts the history of this development, and includes a description of sample preparation techniques, factors affecting image contrast mechanisms, its use in the investigation of the pre-transition ripple phase, and in the localization of cell surface proteins.

The influence of ligand valency on aggregation mechanisms for inhibiting bacterial toxins.

Divalent and tetravalent analogues of ganglioside GM1 are potent inhibitors of cholera toxin and Escherichia coli heat‐labile toxin. However, they show little increase in inherent affinity when compared to the corresponding monovalent carbohydrate ligand. Analytical ultracentrifugation and dynamic light scattering have been used to demonstrate that the multivalent inhibitors induce protein aggregation and the formation of space‐filling networks. This aggregation process appears to arise when using ligands that do not match the valency of the protein receptor. While it is generally accepted that multivalency is an effective strategy for increasing the activity of inhibitors, here we show that the valency of the inhibitor also has a dramatic effect on the kinetics of aggregation and the stability of intermediate protein complexes. Structural studies employing atomic force microscopy have revealed that a divalent inhibitor induces head‐to‐head dimerization of the protein toxin en route to higher aggregates.

An In Situ Dissolution Study of Aspirin Crystal Planes (100) and (001) by Atomic Force Microscopy

AbstractPurpose. To observe in situ and on individual aspirin crystal faces the comparative rates and processes of dissolution of the dominant faces. Methods. The kinetics of the dissolution rate of two aspirin crystal planes (001) and (100) under 0.05M HCl are studied in situ at room temperature using Atomic Force Microscopy. The dissolution process of each crystal plane was followed by observed changes in topographic features. Results. The results revealed that crystal plane (001) dissolves by receding step edges, and has a dissolution rate of 0.45 nm s−1. Conversely, plane (100) displays crystal terrace sinking at an average rate of 2.93 nm s−1. Calculated intrinsic dissolution values (g s−1 cm−2) for planes (001) and (100) are 1.37 × 10−7 g s−1 cm−2 and 8.36 × 10−7 g s−1 cm−2, respectively. Conclusions. These values indicate that the rate of flux of material from plane (100) is approximately six times greater than that from plane (001), under 0.05M HCl. Interpretation of the data, based upon intrinsic dissolution rates and dissolution rate velocities, correlate with reported variations in the dissolution behavior of commercial aspirin products. These observations illustrate the suitability of the technique for characterizing the dissolution behavior of crystalline drugs.

Chemical force microscopy: applications in surface characterisation of natural hydroxyapatite

Detailed mapping of surface chemistry with nanometer resolution has application throughout the physical and life sciences. The atomic force microscope (AFM) has provided a tool that, when using functionalised probes, is capable of providing chemical information with this level of spatial resolution. Here, we describe the technique of chemical force microscopy (CFM) and demonstrate the sensitivity of the technique using chemical force titrations against pH. We describe in detail the specific application of mapping the surface charge on natural hydroxyapatite from skeletal tissue and show that this new information leads to a better understanding of the binding of matrix proteins to the mineral surface.

Aβ42 oligomers, but not fibrils, simultaneously bind to and cause damage to ganglioside-containing lipid membranes

Aβ (amyloid-β peptide) assembles to form amyloid fibres that accumulate in senile plaques associated with AD (Alzheimers disease). The major constituent, a 42-residue Aβ, has the propensity to assemble and form soluble and potentially cytotoxic oligomers, as well as ordered stable amyloid fibres. It is widely believed that the cytotoxicity is a result of the formation of transient soluble oligomers. This observed toxicity may be associated with the ability of oligomers to associate with and cause permeation of lipid membranes. In the present study, we have investigated the ability of oligomeric and fibrillar Aβ42 to simultaneously associate with and affect the integrity of biomimetic membranes in vitro. Surface plasmon field-enhanced fluorescence spectroscopy reveals that the binding of the freshly dissolved oligomeric 42-residue peptide binds with a two-step association with the lipid bilayer, and causes disruption of the membrane resulting in leakage from vesicles. In contrast, fibrils bind with a 2-fold reduced avidity, and their addition results in approximately 2-fold less fluorophore leakage compared with oligomeric Aβ. Binding of the oligomers may be, in part, mediated by the GM1 ganglioside receptors as there is a 1.8-fold increase in oligomeric Aβ binding and a 2-fold increase in permeation compared with when GM1 is not present. Atomic force microscopy reveals the formation of defects and holes in response to oligomeric Aβ, but not preformed fibrillar Aβ. The results of the present study indicate that significant membrane disruption arises from association of low-molecular-mass Aβ and this may be mediated by mechanical damage to the membranes by Aβ aggregation. This membrane disruption may play a key role in the mechanism of Aβ-related cell toxicity in AD.

Roles of fibrin α- and γ-chain specific cross-linking by FXIIIa in fibrin structure and function

Factor XIII is responsible for the cross-linking of fibrin γ-chains in the early stages of clot formation, whilst α-chain cross-linking occurs at a slower rate. Although γ- and α-chain cross-linking was previously shown to contribute to clot stiffness, the role of cross-linking of both chains in determining clot structure is currently unknown. Therefore, the aim of this study was to determine the role of individual α- and γ-chain cross-linking during clot formation, and its effects on clot structure. We made use of a recombinant fibrinogen (γQ398N/Q399N/K406R), which does not allow for γ-chain cross-linking. In the absence of cross-linking, intact D-D interface was shown to play a potential role in fibre appearance time, clot stiffness and elasticity. Cross-linking of the fibrin α-chain played a role in the thickening of the fibrin fibres over time, and decreased lysis rate in the absence of α2-antiplasmin. We also showed that α-chain cross-linking played a role in the timing of fibre appearance, straightening fibres, increasing clot stiffness and reducing clot deformation. Cross-linking of the γ-chain played a role in fibrin fibre appearance time and fibre density. Our results show that α- and γ-chain cross-linking play independent and specific roles in fibrin clot formation and structure.

Critical point fluctuations in supported lipid membranes

In this paper, we demonstrate that it is possible to observe many aspects of critical phenomena in supported lipid bilayers using atomic force microscopy (AFM) with the aid of stable and precise temperature control. The regions of criticality were determined by accurately measuring and calculating phase diagrams for the 2 phase L(d)-L(o) region, and tracking how it moves with temperature, then increasing the sampling density around the estimated critical regions. Compositional fluctuations were observed above the critical temperature (T(c)) and characterised using a spatial correlation function. From this analysis, the phase transition was found to be most closely described by the 2D Ising model, showing it is a critical transition. Below T(c) roughening of the domain boundaries occurred due to the reduction in line tension close to the critical point. Smaller scale density fluctuations were also detected just below T(c). At T(c), we believe we have observed fluctuations on length scales greater than 10 microm. The region of critically fluctuating 10-100 nm nanodomains has been found to extend a considerable distance above T(c) to temperatures within the biological range, and seem to be an ideal candidate for the actual structure of lipid rafts in cell membranes. Although evidence for this idea has recently emerged, this is the first direct evidence for nanoscale domains in the critical region.