Stéphane Coen

Coherence properties of supercontinuum spectra generated in photonic crystal and tapered optical fibers

Numerical simulations have been used in studies of the temporal and spectral features of supercontinuum generation in photonic crystal and tapered optical fibers. In particular, an ensemble average over multiple simulations performed with random quantum noise on the input pulse allows the coherence of the supercontinuum to be quantified in terms of the dependence of the degree of first-order coherence on the wavelength. The coherence is shown to depend strongly on the input pulses duration and wavelength, and optimal conditions for the generation of coherent supercontinua are discussed.

Supercontinuum generation in air–silica microstructured fibers with nanosecond and femtosecond pulse pumping

We study the generation of supercontinua in air–silica microstructured fibers by both nanosecond and femtosecond pulse excitation. In the nanosecond experiments, a 300-nm broadband visible continuum was generated in a 1.8-m length of fiber pumped at 532 nm by 0.8-ns pulses from a frequency-doubled passively Q-switched Nd:YAG microchip laser. At this wavelength, the dominant mode excited under the conditions of continuum generation is the LP11 mode, and, with nanosecond pumping, self-phase modulation is negligible and the continuum generation is dominated by the interplay of Raman and parametric effects. The spectral extent of the continuum is well explained by calculations of the parametric gain curves for four-wave mixing about the zero-dispersion wavelength of the LP11 mode. In the femtosecond experiments, an 800-nm broadband visible and near-infrared continuum has been generated in a 1-m length of fiber pumped at 780 nm by 100-fs pulses from a Kerr-lens model-locked Ti:sapphire laser. At this wavelength, excitation and continuum generation occur in the LP01 mode, and the spectral width of the observed continuum is shown to be consistent with the phase-matching bandwidth for parametric processes calculated for this fiber mode. In addition, numerical simulations based on an extended nonlinear Schrodinger equation were used to model supercontinuum generation in the femtosecond regime, with the simulation results reproducing the major features of the experimentally observed spectrum.

Cross-correlation frequency resolved optical gating analysis of broadband continuum generation in photonic crystal fiber: simulations and experiments

Numerical simulations are used to study the temporal and spectral characteristics of broadband supercontinua generated in photonic crystal fiber. In particular, the simulations are used to follow the evolution with propagation distance of the temporal intensity, the spectrum, and the cross-correlation frequency resolved optical gating (XFROG) trace. The simulations allow several important physical processes responsible for supercontinuum generation to be identified and, moreover, illustrate how the XFROG trace provides an intuitive means of interpreting correlated temporal and spectral features of the supercontinuum. Good qualitative agreement with preliminary XFROG measurements is observed.

White-Light Supercontinuum Generation with 60-ps Pump Pulses in a Photonic Crystal Fiber

The generation of a spatially single-mode white-light supercontinuum has been observed in a photonic crystal fiber pumped with 60-ps pulses of subkilowatt peak power. The spectral broadening is identified as being due to the combined action of stimulated Raman scattering and parametric four-wave-mixing generation, with a negligible contribution from the self-phase modulation of the pump pulses. The experimental results are in good agreement with detailed numerical simulations. These findings demonstrate that ultrafast femtosecond pulses are not needed for efficient supercontinuum generation in photonic crystal fibers.

Scalar modulation instability in the normal dispersion regime by use of a photonic crystal fiber

Modulation instability at high frequencies has been demonstrated in the normal dispersion regime by use of a photonic crystal fiber. This fiber-optic parametric generator provides efficient conversion of red pump light into blue and near-infrared light.

Fiber supercontinuum sources (Invited)

We review supercontinuum generation in optical fibers for particular cases where the nonlinear spectral broadening is induced by pump radiation from fiber-format sources. Based on numerical simulations, our paper is intended to provide experimental design guidelines tailored ytterbium and erbium-based pumps around 1060 and 1550 nm, respectively. In particular, at 1060 nm, we consider conditions under which the generated spectra are phase and intensity stable, and we address the dependence of the supercontinuum coherence on the input pulse parameters and the fiber length. At 1550 nm, special attention is paid to the case of dispersion-flattened dispersion-decreasing fiber, where we revisit the underlying physics in detail and explicitly examine the use of such fiber for supercontinuum generation with pumps of peak power in the range 200-1200 W and sub-10 m fiber lengths. We show that supercontinuum generation under such conditions can be highly coherent and can be applied to nonlinear pulse compression.

Self-induced modulational instability laser revisited: normal dispersion and dark-pulse train generation.

We study theoretically and experimentally the so-called self-induced modulational instability laser and show that the passive mode-locking mechanism that is at play in this laser relies on a dissipative four-wave mixing process that leads to generation of a dark-pulse train in the normal-dispersion regime.

Numerical simulations and coherence properties of supercontinuum generation in photonic crystal and tapered optical fibers

Numerical simulations have been used to study broad-band supercontinuum generation in optical fibers with dispersion and nonlinearity characteristics typical of photonic crystal or tapered fiber structures. The simulations include optical shock and Raman nonlinearity terms, with quantum noise taken into account phenomenologically by including in the input field a noise seed of one photon per mode with random phase. For input pulses of 150-fs duration injected in the anomalous dispersion regime, the effect of modulational instability is shown to lead to severe temporal jitter in the output, and associated fluctuations in the spectral amplitude and phase across the generated supercontinuum. The spectral phase fluctuations are quantified by performing multiple simulations and calculating both the standard deviation of the phase and, more rigorously, the degree of first-order coherence as a function of wavelength across the spectrum. By performing simulations over a range of input pulse durations and wavelengths, we can identify the conditions under which coherent supercontinua with a well-defined spectral phase are generated.

Experimental Studies of the Coherence of Microstructure-Fiber Supercontinuum

The phase coherence of supercontinuum generation in microstructure fiber is quantified by performing a Youngs type interference experiment between independently generated supercontinua from two separate fiber segments. Analysis of the resulting interferogram yields the wavelength dependence of the magnitude of the mutual degree of coherence, and a comparison of experimental results with numerical simulations suggests that the primary source of coherence degradation is the technical noise-induced fluctuations in the injected peak power.

Continuous-wave ultrahigh-repetition-rate pulse-train generation through modulational instability in a passive fiber cavity.

Thanks to a passive cavity configuration, modulational instability in fibers is successfully observed, for the first time to our knowledge, in the continuous-wave regime. Our technique provides a new means of generating all-optically ultrahigh-repetition-rate pulse trains and opens up new possibilities for the fundamental study of modulational instability and related phenomena.