Stephen J. Clark

Anesthetic efficacy of the mylohyoid nerve block and combination inferior alveolar nerve block/mylohyoid nerve block.

OBJECTIVE The purpose of this study was to measure the degree of anesthesia obtained with the mylohyoid nerve block and the combination mylohyoid nerve block/conventional inferior alveolar nerve (IAN) block in mandibular teeth. STUDY DESIGN With the use of a repeated-measures design, 30 subjects randomly received each of 3 combinations of injections at 3 separate appointments. The combinations were as follows: mylohyoid nerve block (1.8 mL of 2% lidocaine with 1:100,000 epinephrine) + IAN block (3.6 mL of 2% lidocaine with 1:100,000 epinephrine); mock mylohyoid nerve block + IAN block (3.6 mL of 2% lidocaine with 1:100,000 epinephrine); mylohyoid nerve block (1.8 mL of 2% lidocaine with 1:100,000 epinephrine) + mock IAN block. The mylohyoid injections were aided by the use of a peripheral nerve stimulator. Mandibular anterior and posterior teeth were blindly tested with a pulp tester at 4-minute cycles for 60 minutes postinjection. Anesthesia was considered successful when 2 consecutive 80 readings were obtained. RESULTS One hundred percent of the subjects had lip numbness with the mylohyoid nerve block + IAN block and mock mylohyoid nerve block + IAN block techniques. For these 2 techniques, anesthetic success rates were higher in posterior teeth (73% to 93%) than in anterior teeth (33% to 60%). There were no significant differences (P > .05) between the 2 techniques. The mylohyoid nerve block + mock IAN block technique resulted in a very low success rate (0% to 17%) and was significantly different (P < .05) from the mylohyoid nerve block + IAN block technique. CONCLUSIONS The results of this study suggest that the mylohyoid nerve block does not by itself predictably provide pulpal anesthesia in mandibular teeth and does not significantly enhance pulpal anesthesia when administered in combination with the IAN block.

Tuned-aperture computed tomography versus parallax analog and digital radiographic images in detecting second mesiobuccal canals in maxillary first molars.

OBJECTIVE We sought to evaluate the detectability of second mesiobuccal (MB2) canals in the MB root of maxillary first molar teeth by comparing (1) parallax with pairs of conventional direct-exposure film intraoral radiographs (both D-speed and F-speed), (2) parallax with pairs of charge-coupled device-based digital images acquired through the use of Trophy RVG-ui, and (3) charge-coupled device-based images acquired through the use of a Trophy RVG-ui sensor and tomosynthetically reconstructed by TACT (tuned-aperture computed tomography) Workbench Software. STUDY DESIGN Maxillary first molars were mounted in simulated bone. Pairs of images were generated by conventional D-speed and F-speed radiography and digital radiography with a charge-coupled device-based sensor, the RVG-ui. Sequences of images were also acquired for TACT reconstruction by using the digital sensor. Observers viewed sets of images to determine the number of canals present within the MB root of each tooth. Roots were horizontally cross-sectioned and viewed under an operating microscope to determine the actual number of canals present. RESULTS The frequency of detection of MB2 canals was remarkably similar across techniques: 39.2% to 39.6% with parallax for both types of film and for RVG-ui images, and 37.9% with TACT. No statistically significant difference was found in the detectability of MB2 canals between the modalities tested. TACT had higher correlation coefficients than the other 3 modalities with respect to intrarater and interrater reliabilities. CONCLUSIONS (1) There was a less than 40% chance of locating MB2 canals in the MB root of maxillary first molar teeth by using parallax with pairs of digital or analog radiographs. (2) TACT did not significantly affect the rate of detection of MB2 canals.

A Comparison of Pain Levels During Pulpectomy, Extractions, and Restorative Procedures

Most previous studies on pain in endodontics have focused on pain that occurs after root canal therapy. Very few studies have compared pain during the root canal procedure with pain occurring during other dental procedures. In the present study, 250 patients were queried following dental procedures regarding their pain levels prior to treatment and their pain levels during the treatment procedure. Of the total number of patients, 150 had a pulpectomy, 50 patients had a single extraction, and 50 patients had a single restoration. These patients reported significantly more pain during extractions than during root canal therapy. Ninety-two percent of patients undergoing root canal therapy reported that pain during the procedure was less than or much less than anticipated. Eighty-three percent of the patients undergoing root canal therapy experienced less pain during the treatment procedure than they experienced prior to the treatment.

Endodontic measurement accuracy and perceived radiograph quality: effects of film speed and density

OBJECTIVES This study sought to determine the effects of direct exposure x-ray film speed and background density on observer assessment of endodontic working lengths and on perceived radiographic image quality. STUDY DESIGN A human cadaver maxilla section with surrounding soft tissues was used for the study. The canal length to the radiographic apex was determined on 4 canals in maxillary posterior teeth by using Trophy RVG images and adjusting the position of a No. 15 file in each canal until the file tip coincided with the radiographic apex in images made at 3 different vertical angulations. The files were measured with a micrometer from the file stop to the file tip to obtain the length to the radiographic apex. Then No. 10 files were placed in the 4 canals at varying lengths short of this previously determined length, and 5 observers assessed the distance from the file tip to the radiographic apex on radiographs made with Kodak D-, E-, and F-speed and Flow D- and E-speed direct exposure x-ray films that were exposed to produce background densities of 1.5, 2.0, and 3.0. Subjective appraisal of radiographic quality was also assessed. RESULTS Analysis of variance and Tukey honestly significantly different post-hoc analysis results concerning measurement errors made with each film type revealed significantly less error for Kodak Ektaspeed Plus (E-speed) intraoral x-ray film than for Kodak InSight (F-speed) and Flow E; however, no difference was detected among Kodak Ektaspeed Plus (E-speed), Kodak Ultra-Speed (D-speed), and Flow D. Films with a background optical density of 3.0 received 98% favorable ratings; radiographs with a background optical density of 2.0 received 77% favorable ratings; and those with background optical density of 1.5 received only 18% favorable ratings at the 95% confidence level. Flow D film received the most favorable ratings, but there was no statistically significant difference among other film types at the 95% confidence level. CONCLUSIONS Underexposed radiographs are perceived as inferior to slightly overexposed radiographs for endodontic file length assessment regardless of the film speed used. Current Flow and Kodak E-speed and F-speed radiographs appear to be as accurate as other accepted radiographs used in determining endodontic working lengths. Image background density should be kept constant when making comparisons among x-ray films.

Perceived quality of radiographic images after rapid processing of D- and F-speed direct-exposure intraoral x-ray films

OBJECTIVE We sought to compare the densitometric properties and perceived image quality of InSight (F-speed) and Ultra-Speed (D-speed) film radiographs processed with rapid chemistry. The effects of density, contrast, and film speed on perceived image quality were also studied. STUDY DESIGN Images were made of a human cadaver phantom with exposures to achieve background densities approximating 1.5, 2.0, and 3.0. Films were processed in a radiographic darkroom by using Insta-Neg and Insta-Fix rapid chemistry as the manufacturer had recommended. Five endodontic residents independently analyzed images of varying density, speed, and contrast that were presented in a randomized manner. They were required to evaluate the perceived image quality of 5 specifically designated areas on the film, using a labeled photograph as a guide. These areas included root canal obturation, periodontal ligament space, dentinoenamel junction, and crestal bone height. In addition, they were also asked to assess the overall perceived image quality. Statistical analysis consisted of ordinal regression and 2-factor analysis of variance. RESULTS No statistically significant differences were proved between F- and D-speed radiographs within the same density group. Higher density and higher contrast resulted in a statistically significant positive impact (P <.01) on the ranking for all 5 subjective determinations. Observers preferred the films exposed to a background density of 3.0 over those of a lower density (P <.01). CONCLUSIONS InSight (F-speed film) can be used with rapid chemistry to ensure less radiation exposure to patients than is necessary with D-speed film. The observers participating in this study preferred radiographs from the 3.0 background density group to those from the 2.0 and 1.5 density groups.

Degradation of the sealing properties of a zinc oxide-calcium sulfate-based temporary filling material by entrapped cotton fibers.

During root canal therapy cotton may be placed in the pulp chamber before placement of a temporary filling. This study evaluated the effect on the sealing of a zinc oxide-calcium sulfate-based temporary filling material when fibers of the internal cotton passed through the filling material and reached the external surface of the temporary filling. Glass tubes were filled with a 3.5 mm thickness of the temporary filling incorporating a bundle of cotton fibers that passed from the inner surface of the restoration to the outer surface. The time for methylene blue stain to penetrate the filling was compared among four groups. Group 1 (large bundles of fibers) had 20 to 40 fibers, group 2 (medium bundles) had 10 to 15 fibers, group 3 (small bundles) had 3 to 5 fibers, and group 4 (negative controls) had no cotton fibers. All samples with cotton fibers leaked within 12 min. None of the negative controls leaked within the 21 -day observation time. These results demonstrate that even a very small amount of cotton trapped between the wall of the tube and the filling material dramatically reduced the sealing quality of the temporary restoration.

Measurement of Intraosseous Pressures Generated by the Wand, High-Pressure Periodontal Ligament Syringe, and the Stabident System

Intraosseous pressure generated by the use of three anesthetic systems-the Wand; a hand-operated high-pressure periodontal ligament (PDL) syringe; and the Stabident system-were studied in fresh mandibles of 14 large swine. The mandibles were drilled and tapped in one area of both the right and left posterior molar regions. Pressure gauges were attached via threaded fittings. Pressures during injection were recorded for the Wand first, then the PDL syringe, and finally Stabident. Results showed averages of 8.3 mm Hg generated by the Wand, 16.3 mm Hg with the high-pressure PDL syringe, and 43.7 mm Hg from the Stabident system. Results were corroborated with data from three human cadaver mandibles.