Sui Zhao

Effect of different acidic fractions in crude oil on dynamic interfacial tensions in surfactant/alkali/model oil systems

Abstract Experimental studies have been conducted in order to elucidate the mechanisms responsible for synergism/antagonism for lowering dynamic interfacial tension (IFT) in surfactant/alkali/acidic fraction model oil systems. The dynamic interfacial tensions of different acidic fractions were measured against alkaline and/or surfactant solutions. The relationships between structure and interfacial tensions were studied. We have found that the acid fractions with the lower average molecular weight (Mn 500) have considerable aromaticity in the R side chain and show lower interfacial activities with alkaline solutions. The acidic fractions in oil phase can influence the partition of added surfactants between the oil phase and aqueous phase, which resulted in the change of interfacial tensions. The acidic fractions with the higher average molecular weight, which have high polarity, influenced interfacial tensions more intensively. The synergism in decreasing interfacial tension in acidic fraction model oil/petroleum sulfonate systems and acidic fraction model oil/alkali/petroleum sulfonate systems can be positive or negative according to the character of oil phase and aqueous phase. The EACN values of different model oils have been measured by using petroleum sulfonate mixtures with various nmin values. We have found that antagonism was observed generally when EACN/nmin value was far from unity, while synergism was observed when EACN/nmin value was close to unity.

Interfacial dilational properties of tri-substituted alkyl benzene sulfonates at air/water and decane/water interfaces.

The dilational rheological properties of absorbed film of three pairs of structural isomers, tri-substituted alkyl benzene sulfonates, at the air-water and decane-water interfaces have been investigated by drop shape analysis method. The influences of bulk concentration on dilational elasticity and viscosity were expounded. Interfacial tension relaxation method was employed to obtain dilational parameters in a reasonably broad frequency range. The experimental results showed that the meta-alkyl to sulfonate group plays a crucial role in the interfacial dilational properties: the longer meta-alkyl will lead to higher dilational parameters for air-water interface and lower ones for decane-water interface when the total alkyl carbon numbers are equal. For alkyl benzene sulfonates with shorter meta-alkyl, the surface dilational properties are similar to interfacial dilational properties, whereas the surface dilational parameters are obviously higher than the interfacial dilational parameters for alkyl benzene sulfonates with longer meta-alkyl in general. The possible mechanism has been proposed and ensured by Cole-Cole plots.

Interfacial dilational rheology related to enhance oil recovery

Dilational rheology has been proved to be a powerful tool to investigate equilibrium and dynamic properties of adsorption films by recent studies. Interfacial dilational properties play crucial roles in Enhanced oil recovery (EOR) processes, such as the formation of oil bank and the demulsification of crude oil emulsions. Moreover, measurements of the interfacial rheology give important clues about the conformations and molecular interactions of amphiphiles adsorbed at an interface. In this review, the experimental results are summarized on dilational rheology of adsorbed layers containing surfactants and polymers employed in EOR, crude oil components and demulsifiers have been summarized. The relationship between dilational data and emulsion stability has been discussed.

Studies of Synergism/Antagonism for Lowering Dynamic Interfacial Tensions in Surfactant/Alkali/Acidic Oil Systems

Experimental studies are conducted in order to elucidate the mechanisms responsible for synergism/antagonism for lowering dynamic interfacial tension in model oil/surfactant/brine systems. A well-defined model oil is selected for controlled design of experiments, thus enhancing verification of known and unknown mechanisms. The systems examined contain model oils and two petroleum sulfonate solutions. The influence of additives in oil phase, such as carboxylic acids with different chain length, n-octadecanol, and oil soluble surfactant SP-60, on the equivalent alkane carbon number (EACN) values has been examined. The interfacial tensions of different model oils with different EACN values against surfactant solutions with different n(min) values have also been obtained. We find that antagonism has been observed when EACN/n(min) value is far from unity by adding organic components, while synergism has been observed when EACN/n(min) value is close to unity. The results present here suggest that organic additives in oil phase controlled interfacial tension by changing the partition of surfactants in oil phase, aqueous phase, and interface.

Dilational Properties of Anionic Gemini Surfactants with Polyoxyethylene Spacers at Water−Air and Water−Decane Interfaces

The dilational properties of anionic gemini surfactants (oligooxa)-alpha,omega-bis(m-octylbenzene sulfonate) (C(8)E(x)C(8)) with polyoxyethylene spacers at the water-air and water-decane interfaces were investigated via the oscillating barriers method. The influences of oscillating frequency and bulk concentration on dilational properties were explored. The interfacial tension relaxation method was employed to obtain dilational parameters in a reasonably broad frequency range. The experimental results show that the number of ethylene oxide groups is one of the principal factors to control the nature of the interfacial film. With an increase of ethylene oxide groups, the dilational modulus of C(8)E(8)C(8) shows two maxima with the increasing concentration. Furthermore, the dilational moduli at the water-decane interface are remarkably lower than those at the water-air interface for C(8)E(1)C(8) and C(8)E(4)C(8), while the dilational modulus at the water-decane interface is close to that at the water-air interface for C(8)E(8)C(8), which indicates that the structure of the adsorption sublayer plays a more important role. Possible schematic diagrams of adsorbed molecules with different polyoxyethylene spacers at the water-air and water-decane interfaces are proposed. The results of relaxation experiments and Cole-Cole plots can support our provided mechanism strongly.

Wettability of a quartz surface in the presence of four cationic surfactants.

Advancing contact angle (θ) measurements were carried out for aqueous solutions of four cationic surfactants, hexadecanol glycidyl ether ammonium chloride (C(16)PC), guerbet alcohol hexadecyl glycidyl ether ammonium chloride (C(16)GPC), hexadecanol polyoxyethylene(3) glycidyl ether ammonium chloride (C(16)(EO)(3)PC), and guerbet alcohol hexadecyl polyoxyethylene(3) glycidyl ether ammonium chloride (C(16)G(EO)(3)PC), on the quartz surface using the sessile drop analysis. The influences of surfactant type and bulk concentration on contact angle were expounded, and the changes in adhesional tension and adhesion work were discussed. The contact angle increases up to a maximum with the increasing concentration for all cationic surfactants. Surfactants with branched chain have more hydrophobic group density on the quartz surface, which results in higher values of maxima in contact angle curves. When ethylene oxide groups CH(2)CH(2)O were incorporated in the hydrophobic group, the decrease in contact angle maximum was observed for C(16)(EO)(3)PC and C(16)G(EO)(3)PC. Moreover, an increase in quartz-water interfacial free energy (γ(SL)) has been observed due to the adsorption of four cationic surfactants. The four cationic surfactants can form a monolayer with alignment structure on the quartz surface through electrostatic interaction and then form the bilayer with increasing bulk concentration. In contrast with literature, the maximal contact angles may not necessarily correspond to the beginning of the formation of bilayer for cationic surfactants at the quartz-water interface. Moreover, the concentrations corresponding to maximal contact angles for C(16)PC and C(16)(EO)(3)PC were much lower than their CMC. The contact angle passes through a maximum at a concentration obviously higher than CMC for C(16)G(EO)(3)PC.

Phase matching analysis of noncollinear optical parametric process in nonlinear anisotropic crystals

Phase matching for noncollinear optical parametric generation is investigated. All the possible phase matching configurations and existence conditions for general noncollinear three-wave mixing interactions are derived for propagation within the crystal principal planes. Numerical expressions for the critical phase matching angles are presented wherever possible. Finally, as an application of these expressions, several numerical calculations of the phase matching angles for general noncollinear phase matched optical parametric amplification in the nonlinear-optical crystals such as beta -BaB2O4, LiB3O5 and KTiOPO4 are completed. and the results are graphically presented

Adsorption behaviors of cationic surfactants and wettability in polytetrafluoroethylene-solution-air systems.

Measurements of the advancing contact angle (θ) and adsorption properties were carried out for aqueous solutions of four cationic surfactants, hexadecanol glycidyl ether ammonium chloride (C(16)PC), Guerbet alcohol hexadecyl glycidyl ether ammonium chloride (C(16)GPC), hexadecanol polyoxyethylene(3) glycidyl ether ammonium chloride(C(16)(EO)(3)PC), and Guerbet alcohol hexadecyl polyoxyethylene(3) glycidyl ether ammonium chloride (C(16)G(EO)(3)PC), on the polytetrafluoroethylene (PTFE) surface using the sessile drop analysis. The obtained results indicate that the contact angle decreases to a minimum with the increasing concentration for all cationic surfactants. Surfactants with branched chain show lower θ values. Moreover, an increase of adhensional tension on the PTFE-water interface has been observed for the four cationic surfactants, and the branched ones have larger increases of adhensional tension. It is very interesting that the sharp decrease of θ appears mainly after critical micelle concentration (cmc) for C(16)GPC, C(16)(EO)(3)PC, and C(16)G(EO)(3)PC, which is quite different from traditional cationic surfactants reported in the literature. Especially for C(16)G(EO)(3)PC, there are two saturated adsorption stages on PTFE surface after cmc (which means the saturated adsorption film at air-solution interface has been formed). In the first saturated stage, the C(16)G(EO)(3)PC molecules are oriented parallel to the PTFE surface with saturated monolayer formed through hydrophobic interaction and hydrogen bond. In the second saturated stage, the hemimicelle has been formed on the PTFE surface, which can be supported by the QCM-D and SPR measurements.

Interactions between Hydrophobically Modified Associating Polyacrylamide and Cationic Surfactant at the Water‐Octane Interface: Interfacial Dilational Viscoelasticity and Relaxation Processes

The interfacial dilational viscoelastic properties of hydrophobically associating block copolymer composed of acrylamide (AM) and a low amount of 2‐ethylhexyl acrylate (EHA) (<1.0 mol%) with a hydrolyzed degree of about 1.5–2.0% at the octane‐water interfaces were investigated by means of two methods: the interfacial tension response to sinusoidal area variations (oscillating barriers method) and the relaxation of an applied stress (interfacial tension relaxation method) respectively. The influence of cationic surfactant cetyl trimethylammonium bromide (CTAB) on the dilational viscoelastic properties was studied. The results obtained by oscillating barriers method showed that dilational modulus decreased moderately with the increase of CTAB concentration. The results obtained by interfacial tension relaxation measurements showed that two main relaxation processes exist in the interface at 7,000 ppm polymer concentration: one is the fast process involving the exchange of hydrophobic blocks between the proximal region and distal region in the interface; the other is the slow relaxation process involving conformational changes of polymer chain in the interface. By adding CTAB, the slow process changed obviously due to the strong electrostatic interaction between oppositely charged surfactant and hydrolyzed part of polymer chain. Only when the CTAB concentration was close to the “equal charge point,” the associations formed mainly by the hydrophobic interaction like that in SDS/polymer system appeared and the characteristic time of fast process decreased obviously. The information of relaxation processes obtained from interfacial tension relaxation measurements can explain the results from dilational viscoelasticity measurements very well.

The Fast Relaxation Process between Hydrophobically Modified Associating Polyacrylamide and Different Surfactants at the Water‐Octane Interface

In our previous work (Macromolecules 2004, 37:2930), we found that the hydrophobic blocks of polyacrylamide modified with 2‐phenoxylethyl acrylate (POEA) and anionic surfactant sodium dodecyl sulfate (SDS) may form mixed associations at octane/water interface. However, the process involving the exchange of surfactant molecules between monomers and mixed associations in interface is so fast that we cannot obtain its characteristic time. In this article, the interfacial dilational viscoelastic properties of another hydrophobically associating block copolymer composed of acrylamide (AM) and a low amount of 2‐ethylhexyl acrylate (EHA) (<1.0 mol%) at the octane‐water interfaces were investigated by means of oscillating barriers method and interfacial tension relaxation method respectively. The influences of anionic surfactant SDS and nonionic surfactant Triton X‐100 on the dilational viscoelastic properties of 7000 ppm polymer solutions were studied. The results showed that the interaction between P(AM/2‐EHA) and SDS was similar to that of P(AM/POEA) and SDS. Moreover, we got the relaxation characteristic time of the fast process involving the exchange of s Triton X‐100 molecules between monomers and mixed associations. We also found that the interfacial tension response of hydrophobically associating water‐soluble copolymers to the sinusoidal oscillation of interfacial area at low bulk concentration is as same as that of the typical surfactants: the interfacial tension decreases with the decrease of interfacial area because of the increase of interfacial active components. However, the interfacial tension increases with the decrease of interfacial area at 7000 ppm P(AM/2‐EHA), which is believed to be correlative with the structure of absorbed film. The results of another hydrophobically associating polymer P(AM/POEA) and polyelectrolyte polystyrene sulfonate (PSS) enhanced our supposition. The phase difference between area oscillation and tension oscillation has also been discussed considering the apparent negative value.