Sülin Taşcıoğlu

A novel method for the spectrophotometric determination of nitrite in water

A rapid, simple, selective and sensitive method for the spectrophotometric determination of nitrite in water has been developed and optimum reaction conditions along with other analytical parameters have been evaluated. Nitrite reacts with barbituric acid in acidic solution to give the nitroso derivative, violuric acid. At analytical wavelength of 310nm, Beers law is obeyed over the concentration range 0.00-3.22ppm of nitrite. The molar absorptivity is 15330+/-259.7 (95%) with pooled standard deviation of 355.57 and R.S.D. of 2.32%. As well as the method is sensitive (2.99x10(-3)mug NO(2)cm(-2)) and selective, it tolerates most of the potential interferents. It has been successfully applied to nitrite determination in natural waters by use of a calibration graph with determination limit of 1.66mug NO(2) in 100mL working solution corresponding to minimum 9.5ppb NO(2)-N in water samples. Lower concentrations of nitrite (3.0mug NO(2)/L sample) is precisely analyzed by using the method of dilution with sample, with R.S.D. of lower than 0.5%. The results were compared with standard N-(1-naphtyl)ethylenediamine dihydrochloride method and very good agreement between the data was observed. The method can easily be applied in the field.

Temperature dependence of copper, iron, nickel and chromium transfers into various black and green tea infusions

Transfer ratios of copper, iron, nickel and chromium from 10 blended, unblended, instant and green tea samples of Turkish or British origin into the infusions have been determined at different brewing temperatures (18, 40, 60 and 80°C). The transfer ratio of each metal into the infusion appeared to be dependent on both temperature and strength of infusions as well as the kind of tea. Ingested metal amounts were calculated and discussed.

Influence of the Nature of the Metal Ion on the Rate of Reduction of Coordinated Azomethine Group

The kinetics of reduction of the azomethine bond in various Schiff bases and their transition metal complexes with sodium borohydride in dimethylformamide and ethanol solutions was studied. The reduction rate depends on both the structure of the starting Schiff bases and the nature of the metal ion. In transition metal N-phenylsalicylaldiminates, the rate of reduction of the azomethine group increases in the order Zn(II) < Ni(II) < Cu(II) < Co(II) < VO(II) < Mn(II). Similar trend is observed in other series of metal complexes with Schiff bases. The revealed trends are opposite to the Irving-Williams series of stability of complexes. This fact suggests that the major factor affecting the rate of reduction of the coordinated azomethine bond is the strength of its bonding with the metal ion. Depending on particular metal ion, the complexation can either decelerate or accelerate the reduction.

Synthesis in water-free DMF, characterization, electrical, and gas sensing properties of bis(2-(2-aminoethylamino)ethanol)copper(II) dibromide

Abstract2-(2-Aminoethylamino)ethanol (L) reacts with cupric bromide in dimethylformamide to give a mononuclear complex of Cu(II) [L2Cu]Br2, with six-coordinate distorted octahedral geometry, in which two molecules of tridentate (N,N,O) ligand are involved. The structure was confirmed by spectroscopic methods, elemental and thermogravimetric analyses, and magnetic measurements. Optimization of possible configurations indicated the formation of the trans structure of the complex. Experimental results indicate that the investigated complex, bis[2-(2-aminoethylamino)ethanol] copper(II) bromide, behaves as a semiconductor in the studied temperature range of 298–388 K. Gas sensing properties of the film for the volatile organic compounds (VOCs): acetone, tetra-chloromethane, chloroform, ethanol, and methanol, were also investigated as a function of vapor concentration and temperature in dark. The film showed maximum sensitivity to tetrachloromethane and ethanol vapors at room temperature. Responses of the film to the tested gases are reversible.

Preparation and characterization of Cu(II)-N-salicylideneanthranilic acids, their reduction products and hydrolysis of the Schiff base

Copper (II) complexes ofN-salicylideneanthranilic acid (I) and its derivatives (II, III) as well as their NaBH4 reduction products, namelyN-(2-hydroxybenzyl) anthranilic acids (IV–VI) have been prepared and their structures have been determined analytically. Tetracoordinated planar structures of the Cu(II) complexes of the Schiff bases and distorted tetrahedral structures of the Cu(II) complexes of compoundsV–VI have been elucidated by ESR and other spectral methods. During the preparation of the complex the hydrolysis of the Schiff base often takes place in the presence of water giving anthranilates and salicylaldehydates of metals to some extent along with the complexes of the Schiff base. The kinetic data for the hydrolysis ofN-salicylideneanthranilic acid (I) in methanol-water solution also are reported.

A novel reagent for spectroscopic determination of Mo(VI)

A new reagent for spectrophotometric determination of Mo(VI) was developed utilizing micellar effects. For this purpose, differences in the ultraviolet and visible spectral properties of Mo(VI), gallic acid, L-serine, and their binary and ternary solutions were studied in the presence and absence of cationic, anionic, and non-ionic surface active agents. L-serine was observed to form binary complexes and a ternary complex with Mo(VI) and gallic acid below its isoelectric point. The maximum Mo(VI) sensitivity was exerted by the Mo(VI) + gallic acid + L-serine + hexadecyltrimethylammonium bromide system at pH of 4.5. This system was proposed for use in the spectrophotometric determination of Mo(VI) as a superior alternative to the Mo(VI) + gallic acid + hexadecyltrimethylammonium bromide system and to most of the instrumental analysis methods referred to in the literature. The mechanism of micellar effects was discussed on the basis of the spectral data obtained above and below the isoelectric point of L-serine and explained in terms of the molecular charge of the substrates and the surfactants.