Susumu Nishida

A Tool Path Modification Approach to Cutting Engagement Regulation for the Improvement of Machining Accuracy in 2D Milling With a Straight End Mill

In two-dimensional (2D) free-form contour machining by using a straight (flat) end mill, conventional contour parallel paths offer varying cutting engagement with workpiece, which inevitably causes the variation in cutting loads on the tool, resulting in geometric inaccuracy of the machined workpiece surface. This paper presents an algorithm to generate a new offset tool path, such that the cutting engagement is regulated at a desired level over the finishing path. The key idea of the proposed algorithm is that the semi-finish path, the path prior to the finishing path, is modified such that the workpiece surface generated by the semi-finish path gives the desired engagement angle over the finishing path. The expectation with the proposed algorithm is that by regulating the cutting engagement angle along the tool path trajectory, the cutting force can be controlled at any desirable value, which will potentially reduce variation of tool deflection, thus improving geometric accuracy of machined workpiece. In this study, two case studies for 2D contiguous end milling operations with a straight end mill are shown to demonstrate the capability of the proposed algorithm for tool path modification to regulate the cutting engagement. Machining results obtained in both case studies reveal far reduced variation of cutting force, and thus, the improved geometric accuracy of the machined workpiece contour.

Fabrication of Fine Mesh Filter Screen with Pulsed Laser

This paper proposes a novel manufacturing process of a fine mesh filter screen with a pulsed laser. The fine mesh filter screen, made of stainless steel, has many small diameter holes with high aspect ratio and fine pitch. In the conventional process, an electron beam drills in a vacuum. However, this is very costly because of the expensive equipment required and batch process. Therefore, a laser drilling process for small diameter hole drilling in air with higher flexibility was proposed. The post-processes after the laser drilling completed the fine mesh filter screen.