Syed Muhammad Mukarram Shah

Analysis of chemical constituents and antinociceptive potential of essential oil of Teucrium Stocksianum bioss collected from the North West of Pakistan

BackgroundMedicinal plants are used for the treatment of different diseases in almost all cultures. Teucrium species grow wildly at different geographical locations around the world. Teucrium stocksianum is used in folk medicine for the treatment of diarrhea, cough, jaundice and abdominal pain. Scientific study on Teucrium stocksianum shows that it possesses anthelmintic, cytotoxic and antispasmodic activity. The aim of our present study is to identify the chemical composition and antinociceptive potential of the essential oil extracted from Teucrium stocksianum bioss.MethodEssential oil (EO) from the aerial parts of Teucrium stocksianum were extracted by hydrodistillation process. The qualitative and quantitative composition of essential oil was determined with Gas chromatography/Mass spectrometer. Antinociceptive activity was determined by acetic acid induced writhing method. Percent inhibition of writhes of the test concentration was determined by comparing it with that of control. Tween-80 emulsion 2.5% (5 ml/kg b.w) was used as a control while Diclofenic sodium 50 mg/kg (b.w) was used as a standard drug.ResultsThe chromatogram of the essential oil of Teucrium stocksianum shows differences both qualitatively and quantatively from essential oil composition reported in other countries. Hydrodistillation of Teucrium stocksianum yielded 0.4% (v/w), pale yellowish oil on dry basis. A total of 26 chemicals were identified by GC-MS accounting for 90.28% of the oil. The major components of essential oil were δ-cadinene (12.92%), α-pinene (10.3%), myrcene (8.64%), β-caryophyllene (8.23%), germacrene D (5.18%) and limonene (2.36%). Essential oil of Teucrium stocksianum has shown outstanding antinociceptive activity. It has been observed that increase in percent writhe inhibition (PWI) occurred from 20-80 mg/kg (b.w) and maximum writhe inhibition has been noted at a concentration of 80 mg/kg (b.w), but PWI decreased at 160 mg/kg, which may be due to some toxic effect of higher dose. ED50 value for Teucrium stocksianum was calculated as 31.5 ± 1.72415 mg/kg (b.w).ConclusionOur results indicate that there is a lot of variation in the composition of essential oil of Teucrium stocksianum boiss, which may be due to different climatic and experimental conditions. Secondly, the essential oil possesses strong antinociceptive activity and could be used in analgesic preparations especially for topical use.

Antioxidant, total phenolic contents and antinociceptive potential of Teucrium stocksianum methanolic extract in different animal models

BackgroundOxidative stress and analgesia are connected with different pathological conditions. The drug candidates from synthetic sources are associated with various side effects; therefore, researchers are giving priority to find novel, effective and safe phytomedicines. Teucrium species possesses antioxidant, analgesic, anti-inflammatory and hepatoprotective activities. The essential oils of Teucrium stocksianum have shown strong antinociceptive potential. Our current study is designed to embark total phenolic content (TPC), antioxidant and antinociceptive potential of the methanolic extract of Teucrium stocksianum (METS).MethodPhytochemical composition was determined by using standard methods. Free radical scavenging potential and TPC of METS were assessed by using 2, 2-diphenyl-1-picryl-hydrazyl (DPPH) and Folin-Ciocalteu Reagent (FCR) respectively. Antinociceptive potential was determined by acetic acid induced abdominal writhing, formalin induced paw licking and tail immersion tests. Different test dose 50, 100 and 150 mg/kg body weight of METS were administered intra peritonealy (i.p) to various groups of mice for the evaluation of analgesic potential.ResultsPhytochemical screening confirmed the presence of flavonoids, tannins, saponins, anthraquinone, steroid, phlobatannin, terpenoid, glycoside and reducing sugars. METS was found safe at a dose of 1000 mg/kg body weight. A concentration dependent free radical scavenging effect was observed with methanolic aerial parts extract of Teucrium stocksianum (MAPETS) and methanolic roots extracts of Teucrium stocksianum (MRETS). MAPETS and MRETS have shown highest antioxidant activity 91.72% and 86.19% respectively at 100 μg/ml. MAPETS was found more rich (115.32 mg of GAE/g of dry material) in TPC as compared to MAPETS (105.41 mg of GAE/g). METS demonstrated a dose dependent antinociceptive potential in different pain models, like in acetic acid, formalin and tail immersion showing 83.103%, 80.872% and 67.58% at a dose of 150 mg/kg, similar to acetylsalicylic acid (74.79%, 82.87%, 100 mg/kg) and TramadolR (74%, 30 mg/kg) respectively.ConclusionStrong antioxidant potential and high TPCs are residing in the methanolic extract of T. stocksianum. METS showed analgesic potential in all models of nociception implying that both peripheral and central pathways of analgesia are involved. This might be due to the presence of various classes of phytochemicals in the plant extract.

Smart nanocrystals of artemether: fabrication, characterization, and comparative in vitro and in vivo antimalarial evaluation

Artemether (ARTM) is a very effective antimalarial drug with poor solubility and consequently low bioavailability. Smart nanocrystals of ARTM with particle size of 161±1.5 nm and polydispersity index of 0.172±0.01 were produced in <1 hour using a wet milling technology, Dena® DM-100. The crystallinity of the processed ARTM was confirmed using differential scanning calorimetry and powder X-ray diffraction. The saturation solubility of the ARTM nanocrystals was substantially increased to 900 µg/mL compared to the raw ARTM in water (145.0±2.3 µg/mL) and stabilizer solution (300.0±2.0 µg/mL). The physical stability studies conducted for 90 days demonstrated that nanocrystals stored at 2°C–8°C and 25°C were very stable compared to the samples stored at 40°C. The nanocrystals were also shown to be stable when processed at acidic pH (2.0). The solubility and dissolution rate of ARTM nanocrystals were significantly increased (P<0.05) compared to those of its bulk powder form. The results of in vitro studies showed significant antimalarial effect (P<0.05) against Plasmodium falciparum and Plasmodium vivax. The IC50 (median lethal oral dose) value of ARTM nanocrystals was 28- and 54-fold lower than the IC50 value of unprocessed drug and 13- and 21-fold lower than the IC50 value of the marketed tablets, respectively. In addition, ARTM nanocrystals at the same dose (2 mg/kg) showed significantly (P<0.05) higher reduction in percent parasitemia (89%) against P. vivax compared to the unprocessed (27%), marketed tablets (45%), and microsuspension (60%). The acute toxicity study demonstrated that the LD50 value of ARTM nanocrystals is between 1,500 mg/kg and 2,000 mg/kg when given orally. This study demonstrated that the wet milling technology (Dena® DM-100) can produce smart nanocrystals of ARTM with enhanced antimalarial activities.

FABRICATION AND EVALUATION OF SMART NANOCRYSTALS OF ARTEMISININ FOR ANTIMALARIAL AND ANTIBACTERIAL EFFICACY

Background: Nanocrystals have the potential to substantially increase dissolution rate, solubility with subsequent enhanced bioavailability via the oral route of a range of poor water soluble drugs. Regardless of other issues, scale up of the batch size is the main issue associated with bottom up approach. Material and Methods: Smart nanocrystals of artemisinin (ARM) was produced relatively at large batch sizes (100, 200, 300 and 400ml) compared to our previously reported study by (Shah, et al., 2016). ARM nanosuspensions/nanocrystals were characterised using zeta sizer, SEM, TEM, DSC, PXRD and RP-HPLC. The nanosuspensions were finally subjected to in vitro antimalarial and antimicrobial activity. Results: The average particle size (PS) for 400 ml batches was 126.5 ±1.02 nm, and the polydispersity index (PI) was 0.194 ± 0.04. The saturation solubility of the ARM nanocrystals was substantially increased to (725.4± 2.0 μg/ml) compared to the raw ARM in water 177.4± 1.3 μg/ml and stabilizer solution (385.3± 2.0 μg/ml). The IC50 value of ARM nanosuspension against P. vivax was 65 and 21 folds lower than micronized 19.5 ng/mL and unprocessed drug (6.4 ng/mL) respectively. The ARM nanosuspension was found highly effective compared to unprocessed drug against all the tested microorganism except E. coli, Shigella and C. albican. Conclusion: The simple precipitation-ultrasonication approach was efficiently employed for fabrication of ARM nanosuspension to scale up the batch size. Similarly, the solubility, antimalarial potential and antimicrobial efficacy of ARM in the form of nanosuspension were significantly enhanced. Findings from this study can persuade research interest for further comprehensive studies using animals model.