Sylvain Delage

Punch-through in short-channel AlGaN/GaN HFETs

Short-channel punch-through effects are demonstrated in 0.17 /spl mu/m gate length AlGaN/GaN single heterojunction field-effect transistors. These take the form of a high output conductance and the strong dependence of pinch-off voltage on drain voltage. It is shown by simulation that they can be explained by poor confinement of charge at the AlGaN/GaN interface resulting in current flow within the bulk of the GaN layer. This is caused by there being a concentration of only /spl sim/1.5/spl times/10/sup 16/ cm/sup -3/ deep levels in the insulating GaN buffer layer. It is found that a net acceptor density of around 10/sup 17/ cm/sup -3/ is required to ensure suppression of short-channel effects.

AlInN/AlN/GaN HEMT Technology on SiC With 10-W/mm and 50% PAE at 10 GHz

High-frequency high-electron-mobility transistors (HEMTs) were fabricated on AlInN/AlN/GaN heterostructures grown by low-pressure metal-organic chemical vapor deposition on a SiC substrate. The results presented in this letter confirm the high performance that is reachable by AlInN-based technology with an output power of 10.3 W/mm and a power-added efficiency of 51% at 10 GHz with a gate length of 0.25 ¿m. A good extrinsic transconductance value that is greater than 450 mS/mm and exceeding AlGaN/GaN HEMT results was also measured on these transistors. To our knowledge, these results are the best power results published on AlInN/GaN HEMTs. These good results were attributed to optimized heterostructure properties associated with low-resistance ohmic contacts and an effective passivation layer minimizing drain current slump in high-frequency operations.

Output power density of 5.1/mm at 18 GHz with an AlGaN/GaN HEMT on Si substrate

Microwave frequency capabilities of AlGaN/GaN high electron mobility transistors (HEMTs) on high resistive silicon (111) substrate for power applications are demonstrated in this letter. A maximum dc current density of 1 A/mm and an extrinsic current gain cutoff frequency (F/sub T/) of 50 GHz are achieved for a 0.25 /spl mu/m gate length device. Pulsed and large signal measurements show the good quality of the epilayer and the device processing. The trapping phenomena are minimized and consequently an output power density of 5.1 W/mm is reached at 18 GHz on a 2/spl times/50/spl times/0.25 /spl mu/m/sup 2/ HEMT with a power gain of 9.1dB.

Evidence of traps creation in GaN/AlGaN/GaN HEMTs after a 3000 hour on-state and off-state hot-electron stress

A long-term 3000-hour test under on-state conditions (VDS =25V, 6W/mm constant dissipated power) and off-state conditions (V DS=46V, VGS=-6V) on GaN/AlGaN/GaN HEMTs is presented. Trapping presence and hot-electrons effect are characterized by means of low-frequency techniques (low-frequency noise measurements, transconductance frequency dispersion, gate-lag). The on-state stress shows the most important degradation. Since our measurements point out to the creation of traps in the gate-to-drain surface region during the stress, this degradation is ascribed to the effect of hot-electrons

Testing the Temperature Limits of GaN-Based HEMT Devices

The high temperature stability of AlGaN/GaN and lattice-matched InAlN/GaN heterostructure FETs has been evaluated by a stepped temperature test routine under large-signal operation. While AlGaN/GaN high-electron mobility transistors (HEMTs) have failed in an operating temperature range of 500°C, InAlN/GaN HEMTs have been operated up to 900°C for 50 h (in vacuum). Failure is thought to be still contact metallization stability related, indicating an extremely robust InAlN/GaN heterostructure configuration.

SThM Temperature Mapping and Nonlinear Thermal Resistance Evolution With Bias on AlGaN/GaN HEMT Devices

Channel temperature has a strong impact on the performance of a microwave power transistor. In particular, it has a strong influence on the power gain, energetic efficiency, and reliability of the device. The thermal optimization of device geometry is therefore a key issue, together with precise measurements of temperature within the channel area. In this paper, we have used scanning thermal microscopy to perform temperature mapping, at variable dc bias points, on an AlGaN/GaN high-electron mobility transistor made on epilayers grown on silicon carbide substrate. We have analyzed the variation of the thermal resistance values, which are deduced from these measurements, with bias conditions VGS and VDS. The observed nonlinear behavior is found to be in excellent agreement with physical simulations, strongly pointing out the large variability of the extension of the dissipation area with the dc bias conditions

Influence of surface recombination on the burn-in effect in microwave GaInP/GaAs HBT's

In this paper, we report on the early increase of the dc current gain (burn-in effect) due to the electrical stress of carbon doped GaInP/GaAs heterojunction bipolar transistors (HBTs). Devices featuring different passivation layers, base doping, and emitter widths were investigated. The obtained data demonstrate that the burn-in effect is due to a reduction of the surface recombination located at the extrinsic base surface, around the emitter perimeter. It is concluded that the recombination centers are related to defects at the passivation/semiconductor interface and that, during the stress, they are passivated by hydrogen atoms released from C-H complexes.

A 3000 hours DC Life Test on AlGaN/GaN HEMT for RF and microwave applications

Impressive results have been published for GaN-based transistors for large frequency range. Therefore, both single chip and complete amplification system reliability demonstration is becoming an important subject of concern. In this paper a 3000 hour DC life test is described and the last results derived from the data treatment of this test are presented. The transistor parameters show an evolution strictly related to the biasing point. The High Forward Gate Current test does not present any particular degradation of the transistor characteristics. The most important degradation is observed on the drain saturation current during the High Temperature Operating test. The effect of hot-carriers seems to be the main cause for device degradation.

State of the Art 58W, 38% PAE X-Band AlGaN/GaN HEMTs Microstrip MMIC Amplifiers

This paper presents the results obtained on X-Band GaN MMICs developed in the frame of the Kerrigan project launched by the European Defense Agency. A new step was achieved, 58 W of output power with 38% PAE in X-Band were obtained using an 18 mm 2 2-stages amplifier. To our knowledge, these results present a new state-of-the-art of X-Band MMIC power amplifiers.

MBE growth of AlGaN/GaN HEMTS on resistive Si(111) substrate with RF small signal and power performances

In this paper, we report on the properties of GaN films and AlGaN/GaN HEMT structures grown by molecular beam epitaxy on resistive Si(1 1 1) substrates. The properties of the GaN buffer layer and the AlGaN/GaN HEMTs are presented. Finally, both static and high-frequency performances of sub-micron gate length devices are analyzed demonstrating their RF power capability