Sylvester Werczynski

The Vertical Distribution of Radon in Clear and Cloudy Daytime Terrestrial Boundary Layers

Abstract Radon (222Rn) is a powerful natural tracer of mixing and exchange processes in the atmospheric boundary layer. The authors present and discuss the main features of a unique dataset of 50 high-resolution vertical radon profiles up to 3500 m above ground level, obtained in clear and cloudy daytime terrestrial boundary layers over an inland rural site in Australia using an instrumented motorized research glider. It is demonstrated that boundary layer radon profiles frequently exhibit a complex layered structure as a result of mixing and exchange processes of varying strengths and extents working in clear and cloudy conditions within the context of the diurnal cycle and the synoptic meteorology. Normalized aircraft radon measurements are presented, revealing the characteristic structure and variability of three major classes of daytime boundary layer: 1) dry convective boundary layers, 2) mixed layers topped with residual layers, and 3) convective boundary layers topped with coupled nonprecipitating ...

Constraining annual and seasonal radon-222 flux density from the Southern Ocean using radon-222 concentrations in the boundary layer at Cape Grim

ABSTRACT Radon concentrations measured between 2001 and 2008 in marine air at Cape Grim, a baseline site in north-western Tasmania, are used to constrain the radon flux density from the Southern Ocean. A method is described for selecting hourly radon concentrations that are least perturbed by land emissions and dilution by the free troposphere. The distribution of subsequent radon flux density estimates is representative of a large area of the Southern Ocean, an important fetch region for Southern Hemisphere climate and air pollution studies. The annual mean flux density (0.27 mBq m−2 s−1) compares well with the mean of the limited number of spot measurements previously conducted in the Southern Ocean (0.24 mBq m−2 s−1), and to some spot measurements made in other oceanic regions. However, a number of spot measurements in other oceanic regions, as well as most oceanic radon flux density values assumed for modelling studies and intercomparisons, are considerably lower than the mean reported here. The reported radon flux varies with seasons and, in summer, with latitude. It also shows a quadratic dependence on wind speed and significant wave height, as postulated and measured by others, which seems to support our assumption that the selected least perturbed radon concentrations were in equilibrium with the oceanic radon source. By comparing the least perturbed radon observations in 2002–2003 with corresponding ‘TransCom’ model intercomparison results, the best agreement is found when assuming a normally distributed radon flux density with σ=0.075 mBq m−2 s−1.

Estimating the near-surface daily fine aerosol load using hourly Radon-222 observations

We investigate the extent to which hourly radon observations can be used to estimate daily PM2.5 loading near the ground. We formulate, test and apply a model that expresses the mean daily PM2.5 load as a linear combination of observed radon concentrations and differences on a given day. The model was developed using two consecutive years of observations (2007–2008) at four sites near Sydney, Australia, instrumented with aerosol samplers and radon detectors. Model performance was subsequently evaluated against observations in 2009. After successfully reproducing mean daily radon concentrations (r2≥0.98), we used the model to estimate daily PM2.5 mass, as well as that of selected elements (Si, K, Fe, Zn, H, S and Black Carbon). When parameterizing the model for elemental mass estimates the highest r2 values were generally obtained for H, BC, K and Si. Separating results by season, the r2 values for K and BC were higher in winter for all sites, a period of time where higher concentrations of these elements are seen and a rapid estimation tool would be of particular benefit. The best overall results were obtained in winter for H and BC [r2 = 0.50, 0.68, 0.70, 0.63 (H) and 0.57, 0.57, 0.78, 0.44 (BC)], respectively for Warrawong, Lucas Heights, Richmond and Muswellbrook. Evaluation of model PM2.5 estimates was most successful for days with typical aerosol loads; loads were usually underestimated for, the less frequent, high–to–extreme pollution days. The best elemental results were obtained for BC at Richmond in winter (r2 = 0.68). However, for Warrawong and Lucas Heights r2 values increased from 0.26 to 0.60, and from 0.33 to 0.73, respectively, when several particularly high concentration events were excluded from the analysis. The model performed best at Richmond, an inland site with relatively flat terrain. However, model parameters need to be evaluated for each site.