Teresa Aditya

Fabrication of superhydrophobic copper surface on various substrates for roll-off, self-cleaning, and water/oil separation.

Superhydrophobic surfaces prevent percolation of water droplets and thus render roll-off, self-cleaning, corrosion protection, etc., which find day-to-day and industrial applications. In this work, we developed a facile, cost-effective, and free-standing method for direct fabrication of copper nanoparticles to engender superhydrophobicity for various flat and irregular surfaces such as glass, transparency sheet (plastic), cotton wool, textile, and silicon substrates. The fabrication of as-prepared superhydrophobic surfaces was accomplished using a simple chemical reduction of copper acetate by hydrazine hydrate at room temperature. The surface morphological studies demonstrate that the as-prepared surfaces are rough and display superhydrophobic character on wetting due to generation of air pockets (The Cassie-Baxter state). Because of the low adhesion of water droplets on the as-prepared surfaces, the surfaces exhibited not only high water contact angle (164 ± 2°, 5 μL droplets) but also superb roll-off and self-cleaning properties. Superhydrophobic copper nanoparticle coated glass surface uniquely withstands water (10 min), mild alkali (5 min in saturated aqueous NaHCO3 of pH ≈ 9), acids (10 s in dilute HNO3, H2SO4 of pH ≈ 5) and thiol (10 s in neat 1-octanethiol) at room temperature (25-35 °C). Again as-prepared surface (cotton wool) was also found to be very effective for water-kerosene separation due to its superhydrophobic and oleophilic character. Additionally, the superhydrophobic copper nanoparticle (deposited on glass surface) was found to exhibit antibacterial activity against both Gram-negative and Gram-positive bacteria.

Mn3O4 nanoparticles anchored to multiwall carbon nanotubes: a distinctive synergism for high-performance supercapacitors

Modified hydrothermal route (MHT)-evolved Mn3O4 nanoparticles of ∼60 nm diameter were anchored onto a conductive multiwalled carbon nanotubes (MWCNTs) backbone (again under MHT) to produce an energy storage composite. To obtain the benefits of a low cost and stable MWCNT/Mn3O4 composite as a supercapacitor, cyclic voltammetry (CV) and galvanostatic charge–discharge measurements (GCD), as well as cycling stability and electrochemical impedance studies (EIS) have been performed. The electrochemical measurements reveal the suitability of the as-synthesized MWCNT/Mn3O4 composite as an electrode material with a highest specific capacitance of 441 F g−1 at 2 mV s−1 scan rate, which is 1.4 times higher than the specific capacitance (312 F g−1 at a scan rate of 2 mV s−1) of the bare Mn3O4 nanoparticle. MWCNT/Mn3O4 shows an excellent rate capability, outstanding long-term cyclic stability (98% capacity retention after 1000 consecutive cycles) and better power density and energy density. Due to the synergistic effect operating between the pseudocapacitor Mn3O4 nanoparticle and the conductive MWCNT, the capacitive performance of the composite electrode was considerably improved, and we perceive that the composite effect could have benefit in terms of supercapacitor application. These interesting improved material properties of the as-synthesized material indicate that the material is a suitable candidate for use in future energy storage applications.

Micelle confined mechanistic pathway for 4-nitrophenol reduction

The model 4-nitrophenol reduction has been carried out by different groups in presence of metallic or even non-metallic catalyst elaborating different mechanistic aspects. In the present investigation, we have thoroughly studied the hydrogenation of 4-nitrophenol in a completely metal free homogeneous condition. The introduction of a non-fluorescent probe unequivocally generates a fluorescent molecule that indirectly justifies the anion radical stabilization in the micelle. The reduction mechanism under metal-free condition was proposed and the concept of stabilization of anion radical transition state of 4-nitrophenol at the positively charged Stern layer of anionic micelle was established. The plausible reduction mechanism has also enlightened the graphene-like conducting property of Stern layer of the homogeneous micellar system. Furthermore, the confinement effect for catalysis has also been authenticated by supporting experimental evidences. The borrowed concept of catalysis in confinement drives the catalytic study to a new era of catalysis.

Fluorescence enhancement via varied long-chain thiol stabilized gold nanoparticles: A study of far-field effect

Metal enhanced fluorescence of carbon dots has been reported in aqueous solution. Moderately fluorescing carbon dots (λex=360nm and λem=440nm) of 6-8nm diameters (CDA) have been synthesized from freshly prepared aqueous ascorbic acid solution under modified hydrothermal treatment. The CDA fluorescence is quenched at the close proximity with gold nanoparticles (AuNPs). Here, a substrate specific near-field electric field distribution is pronounced. Anticipating distance dependent fluorescence enhancement phenomenon, long-chain aliphatic thiol capped AuNPs are introduced to improve fluorescence of moderately fluorescing CDAs. The long-chain aliphatic thiols act as spacers between CDA and AuNP. Interestingly, the fluorescence of CDA is observed to be enhanced successively as the chain lengths of aliphatic thiols are increased. Fluorescing CDA, upon excitation, transfers energy to the nearby AuNP and a plasmon is induced. This plasmon radiates in the far-field resulting in fluorescence enhancement of CDAs. Such an interesting enhancement in emission with metallic gold is termed as gold enhanced fluorescence. This far-field effect for fluorescence enhancement of CDA particles becomes a general consensus in solution with varied long-chain aliphatic amine ligand capped silver nanoparticles (AgNPs). Finally, consequence of far-field effect of fluorescence enhancement has been observed while derivatized AuNP and AgNP are introduced into the CDA solution simultaneously which is described as reinforced fluorescence enhancement due to coupled plasmonic radiation.

Remarkable Facet Selective Reduction of 4-Nitrophenol by Morphologically Tailored (111) Faceted Cu2O Nanocatalyst

In this work, we have disclosed the facile syntheses of morphologically diverse Cu2O nanoparticles using our laboratory designed modified hydrothermal reactor employing low-cost copper (II) acetate precursor compounds. The reaction conditions dovetail the effect of ethylene glycol (EG) and glucose to exclusively evolve the morphology tuned Cu2O nanomaterial at different pHs. The morphology tuning produces octahedron (Oh), dwarf hexapod (DHP), and elongated hexapod (EHP) Cu2O structures only with the optimized reagent concentrations. Interestingly, all of them were bestowed with a (111) facet, a superlative facet for facile nitroarene reduction. Thus, the morphology reliant catalytic reaction becomes evident. However, when used individually, EG and glucose evolve ill-defined CuO/Cu2O and Cu2O structures, respectively. We have observed that a change in pH of the medium at the onset of the reaction is obligatory for the evolution of tailor-made morphologically diverse Cu2O nanoparticles. However, preformed Cu2O particles do not suffer further structure/morphology changes under deliberate pH (6.0–9.0) change. With the as-obtained Oh, DHP, and EHP Cu2O structures, we further delve into the realm of catalysis to understand the splendor of the nanocatalyst, morphology and surface area dependence, facet selective reactivity, and other factors affecting the catalytic efficiency. The remarkable rate of catalysis of 4-nitrophenol (4-NP), evident from the catalyst activity parameter (ka = 123.6 g–1 s–1), to produce 4-aminophenol in the presence of a reducing agent like sodium borohydride (NaBH4) of the as-prepared catalysts is evidence of the collaborative effects of the effective surface area, surface positive charge, and active (111) facet of the Cu2O nanocatalyst. We have also studied the effect of other common anions, namely, Cl–, NO2–, NO3–, CO32–, and SO42– on the reduction process. To obtain a general consensus about facets, we compared (100) and (111) faceted Cu2O nanocatalysts not only for 4-NP reduction but also for the reduction of toxic chromium Cr(VI) in the presence of formic acid to further emphasize the importance of facet selectivity in catalysis and the versatility of the morphology tuned as-prepared Cu2O.

Solvent Polarity-Dependent Behavior of Aliphatic Thiols and Amines toward Intriguingly Fluorescent AuAgGSH Assembly

Highly stable fluorescent glutathione (GSH)-protected AuAg assembly has been synthesized in water under UV irradiation. The assembly is composed of small Ag2/Ag3 clusters. These clusters gain stability through synergistic interaction with Au(I) present within the assembly. This makes the overall assembly fluorescent. Here, GSH acts as a reducing as well as stabilizing agent. The assembly is so robust that it can be vacuum-dried to solid particles. The as-obtained solid is dispersible in nonaqueous solvents. The interaction between solvent and the assembly provides stability to the assembly, and the assembly shows fluorescence. It is interesting to see that the behavior of long-chain aliphatic thiols or amines toward the fluorescent assembly is altogether a different phenomenon in aqueous and nonaqueous mediums. The assembly gets ruptured in water due to direct interaction with long-chain thiols or amines, whereas in nonaqueous medium, solvation of added thiols or amines becomes pronounced, which hinders the interaction of solvent with the assembly. However, the fluorescence of the assembly is always quenched with thiols or amines no matter what the solvent medium is. In aqueous medium, the fluorescence quenching by aliphatic thiol or amine becomes pronounced with successive decrease in their chain length, whereas in nonaqueous medium, the trend is just reversed with chain length. The reasons behind such an interesting reversal of fluorescence quenching in aqueous and nonaqueous solvents have been discussed explicitly. Again, in organic solvents, thiol or amine-induced quenched fluorescence is selectively recovered by Pb(II) ion without any alteration of excitation and emission maxima. This phenomenon is not observed in water because of the ruptured fluorescent assembly. The fluorescence recovery by Pb(II) and unaltered emission peak only in nonaqueous solvent unequivocally prove the engagement of Pb(II) with thiols or amines, which in turn revert the original solvent-supported stabilization of the assembly.