Terry M. Spear

Evaluating the Effectiveness of a Commercial Portable Air Purifier in Homes with Wood Burning Stoves: A Preliminary Study

Wood burning for residential heating is prevalent in the Rocky Mountain regions of the United States. Studies have shown that wood stoves can be a significant source of PM2.5 within homes. In this study, the effectiveness of an electrostatic filter portable air purifier was evaluated (1) in a home where a wood stove was the sole heat source and (2) in a home where a wood stove was used as a supplemental heat source. Particle count concentrations in six particle sizes and particle mass concentrations in two particle sizes were measured for ten 12-hour purifier on and ten purifier off trials in each home. Particle count concentrations were reduced by 61–85 percent. Similar reductions were observed in particle mass concentrations. These findings, although limited to one season, suggest that a portable air purifier may effectively reduce indoor particulate matter concentrations associated with wood combustion during home heating.

An Evaluation of Potential Occupational Exposure to Asbestiform Amphiboles near a Former Vermiculite Mine

Amphibole asbestos (AA) has been detected on the surface of tree bark in forests neighboring an abandoned vermiculite mine near Libby, Montana. In the present study, simulations were performed to assess potential AA exposure associated with United States Department of Agriculture Forest Service (FS) occupational activities. Bark samples were collected prior, and personal breathing zone (PBZ) and Tyvek clothing wipe samples were collected during and immediately after trials that simulated FS activities. Transmission electron microscopy (TEM) analyses revealed AA bark concentrations up to 15 million structures per square centimeter (s/cm2). AA was detected in 25% of the PBZ TEM samples. AA was detected on wipe samples collected from all activities evaluated. This research demonstrates the potential for airborne exposure and transport of AA in the Kootenai National Forest. These findings are especially relevant to those that work in the area and to the general public who may conduct recreational activities.

Amphibole Asbestos in Tree Bark—A Review of Findings for This Inhalational Exposure Source in Libby, Montana

In June 2009, the U.S. Environmental Protection Agency (EPA) designated the town of Libby, Montana, a public health emergency—the first and only time the EPA has made such a determination under the Comprehensive Environmental Response, Compensation, and Liability Act (CERCLA). From about 1920 until 1990, the leading source of vermiculite ore for the United States and the world was from a mine near Libby. This vermiculite ore was contaminated with fibrous and asbestiform amphibole in veins throughout the deposit. Today, areas surrounding the abandoned vermiculite processing/mining facilities and much of the town of Libby are contaminated with these asbestos fibers, contributing to an outbreak of asbestos-related diseases in the Libby population. Trees in Libby and in forested areas surrounding the abandoned mine have accumulated amphibole asbestos fibers on their bark surface, providing for inhalational exposures. Several studies have been conducted to further understand this exposure pathway. To address exposures to the public, Libby amphibole (LA) was measured in personal breathing zone and Tyvek surface wipe samples collected during firewood harvesting simulations, as well as in the ash and emissions of woodstoves when amphibole-contaminated firewood was combusted. Occupational studies simulating wildland firefighting and routine U.S. Department of Agriculture (USDA) Forest Service activities have also been conducted in the forested areas surrounding the abandoned mine, demonstrating the potential for inhalational exposures during common regional workplace activities. We present a review of the findings of this emerging environmental health concern impacting not only the residents of Libby but applicable to other populations living near asbestos-contaminated areas.

A comparison of respirable crystalline silica concentration measurements using a direct-on-filter Fourier transform infrared (FT-IR) transmission method versus a traditional laboratory X-ray diffraction method

Abstract Evaluation and control of respirable crystalline silica (RCS) exposures are critical components of an effective mine industrial hygiene program. To provide more timely exposure data in the field, an end-of-shift Fourier transform infrared (FT-IR) spectrometry method has been developed for evaluation of direct-on-filter RCS. The present study aimed to apply this FT-IR method using field samples collected in three Northwestern U.S. metal/nonmetal mines and compare the results to traditional laboratory X-ray diffraction analysis (XRD). Seventy-five dust samples were analyzed using both methods. Samples for each mine were split in half by random assignment, with half used to create a calibration factor for the FT-IR analysis and half used to apply the calibration. Nonparametric correlational and two-sample comparative tests were used to assess the strength of association and the level of agreement between the two methods. Strong, positive correlations were observed between FT-IR and XRD RCS concentrations, with Spearman rank correlation coefficients ranging between 0.84 and 0.97. The mean RCS concentrations determined through FT-IR analysis were lower than through XRD analysis, with mean differences ranging from −4 to −133 ug/m3 and mean percent errors ranging from 12% to 28%. There was a statistically significant improvement in the level of agreement between log FT-IR and log XRD RCS concentrations following calibration at two of the three mines, with mean differences of −0.03 (p = 0.002) and −0.02 (p = 0.044) in the log scale. The reduction in mean difference following calibration at the other mine was not statistically significant (mean log scale difference = −0.05, p = 0.215), but the differences between FT-IR and XRD were not significantly different without calibration (mean log scale difference = −0.07, p = 0.534). The results indicate that mine-specific calibration factors can improve the level of agreement between RCS concentrations determined via a field-based, end-of-shift FT-IR method in metal/non-metal mines as compared to traditional XRD analysis.

The effects of strapped spectacles on the fit factors of three manufactured brands of full facepiece negative pressure respirators

A study was conducted to determine the effects of strapped spectacles on the fit factors obtained during quantitative fit testing on three different brands of full facepiece negative pressure respirators. The three brands of respirators were evaluated with and without strapped spectacles worn by the test subjects. A total of 180 quantitative fit testing trials were conducted on ten male test subjects. For each test subject, three quantitative fit testing trials were performed with each brand of respirator with and without the spectacles. The average of the fit testing trials for each subject with each respirator was used for statistical analysis. The results demonstrated that the fit factor values were significantly lower during use of the spectacles (p < 0.05). The estimated percentage of test subjects who failed the American National Standards Institute pass/fail criteria for quantitative fit testing (1000) increased by 15-36% when spectacles were worn.