Thomas Bjørnholm

Single-electron transistor of a single organic molecule with access to several redox states.

A combination of classical Coulomb charging, electronic level spacings, spin, and vibrational modes determines the single-electron transfer reactions through nanoscale systems connected to external electrodes by tunnelling barriers. Coulomb charging effects have been shown to dominate such transport in semiconductor quantum dots, metallic and semiconducting nanoparticles, carbon nanotubes, and single molecules. Recently, transport has been shown to be also influenced by spin—through the Kondo effect—for both nanotubes and single molecules, as well as by vibrational fine structure. Here we describe a single-electron transistor where the electronic levels of a single π-conjugated molecule in several distinct charged states control the transport properties. The molecular electronic levels extracted from the single-electron-transistor measurements are strongly perturbed compared to those of the molecule in solution, leading to a very significant reduction of the gap between the highest occupied molecular orbital and the lowest unoccupied molecular orbital. We suggest, and verify by simple model calculations, that this surprising effect could be caused by image charges generated in the source and drain electrodes resulting in a strong localization of the charges on the molecule.

Molecular electronics with single molecules in solid-state devices.

The ultimate aim of molecular electronics is to understand and master single-molecule devices. Based on the latest results on electron transport in single molecules in solid-state devices, we focus here on new insights into the influence of metal electrodes on the energy spectrum of the molecule, and on how the electron transport properties of the molecule depend on the strength of the electronic coupling between it and the electrodes. A variety of phenomena are observed depending on whether this coupling is weak, intermediate or strong.

Fullerene-based anchoring groups for molecular electronics.

We present results on a new fullerene-based anchoring group for molecular electronics. Using lithographic mechanically controllable break junctions in vacuum we have determined the conductance and stability of single-molecule junctions of 1,4-bis(fullero[c]pyrrolidin-1-yl)benzene. The compound can be self-assembled from solution and has a low-bias conductance of 3 x 10(-4) G0. Compared to 1,4-benzenedithiol the fullerene-anchored molecule exhibits a considerably lower conductance spread. In addition, the signature of the new compound in histograms is more significant than that of 1,4-benzenediamine, probably owing to a more stable adsorption motif. Statistical analyses of the breaking of the junctions confirm the stability of the fullerene-gold bond.

Lag-burst kinetics in phospholipase A2 hydrolysis of DPPC bilayers visualized by atomic force microscopy

The lag-burst phenomenon in the phospholipase A(2) mediated hydrolysis of phospholipid bilayers is for the first time demonstrated in an atomic force microscopy (AFM) study. Simultaneous AFM measurements of the degree of bilayer degradation and the physical-chemical state of the membrane reveals growing nanoscale indentations in the membrane during the lag phase. It is argued that these indentations are domains of hydrolysis products (lysoPC/PC) which eventually trigger the burst. The rate of the rapid hydrolysis following the burst is found to be proportional to the length of the edge between membrane adsorbed and desorbed to the mica base. The observed maximal rate of membrane degradation is approx. 0.2 mmol lipid/min/mol lipase in solution.

Non-Volatile Photochemical Gating of an Epitaxial Graphene/Polymer Heterostructure

Electronic devices using epitaxial graphene on Silicon Carbide require encapsulation to avoid uncontrolled doping by impurities deposited in ambient conditions. Additionally, interaction of the graphene monolayer with the substrate causes relatively high level of electron doping in this material, which is rather difficult to change by electrostatic gating alone. Here we describe one solution to these problems, allowing both encapsulation and control of the carrier concentration in a wide range. We describe a novel heterostructure based on epitaxial graphene grown on silicon carbide combined with two polymers: a neutral spacer and a photoactive layer that provides potent electron acceptors under UV light exposure. Unexposed, the same double layer of polymers works well as capping material, improving the temporal stability and uniformity of the doping level of the sample. By UV exposure of this heterostructure we controlled electrical parameters of graphene in a non-invasive, non-volatile, and reversible way, changing the carrier concentration by a factor of 50. The electronic properties of the exposed SiC/ graphene/polymer heterostructures remained stable over many days at room temperature, but heating the polymers above the glass transition reversed the effect of light. The newly developed photochemical gating has already helped us to improve the robustness (large range of quantizing magnetic field, substantially higher opera- tion temperature and significantly enhanced signal-to-noise ratio due to significantly increased breakdown current) of a graphene resistance standard to such a level that it starts to compete favorably with mature semiconductor heterostructure standards. [2,3]A novel heterostructure based on epitaxial graphene grown on silicon carbide combined with two polymers is demonstrated, with a neutral spacer and a photoactive layer that provides potent electron acceptors under UV light exposure. UV exposure of this heterostructure enables control of the electrical parameters of graphene in a non-invasive, non-volatile, and reversible way.

Electrical manipulation of spin states in a single electrostatically gated transition-metal complex.

We demonstrate an electrically controlled high-spin (S = 5/2) to low-spin (S = 1/2) transition in a three-terminal device incorporating a single Mn(2+) ion coordinated by two terpyridine ligands. By adjusting the gate-voltage we reduce the terpyridine moiety and thereby strengthen the ligand-field on the Mn-atom. Adding a single electron thus stabilizes the low-spin configuration and the corresponding sequential tunnelling current is suppressed by spin-blockade. From low-temperature inelastic cotunneling spectroscopy, we infer the magnetic excitation spectrum of the molecule and uncover also a strongly gate-dependent singlet-triplet splitting on the low-spin side. The measured bias-spectroscopy is shown to be consistent with an exact diagonalization of the Mn-complex, and an interpretation of the data is given in terms of a simplified effective model.

Fabrication of 2D Gold Nanowires by Self-Assembly of Gold Nanoparticles on Water Surfaces in the Presence of Surfactants

Self-assembly of metallic nanostructures using 2D templates consisting of surfactant systems at the air/water interface is demonstrated (see Figure). The morphology of the resulting nanostructures can be partially controlled by adjusting parameters such as the molecular structure of the surfactant, the chemical properties of the assembly units, and the surface pressure.

Supramolecular organization of highly conducting organic thin films by the Langmuir-Blodgett technique

The optimization of organic materials in semiconductor devices or as electrical conductors in devices is closely related to the optimization of electroactive molecular structures which can self-assemble into highly ordered solid films when cast from solution. This supramolecular optimization problem is dissected in the present feature article by focusing on self-assembly of thin films at the interface between water and air (Langmuir films). Recent advances towards fabrication of highly conducting Langmuir-Blodgett (LB) films is reviewed. Owing to new accurate structural methods, including synchrotron X-ray diffraction and scanning probe microscopy (in particular atomic force microscopy, AFM), the steps in the assembly process of Langmuir-Blodgett films can now be studied in unprecedented detail. This is exemplified for the electroactive molecular surfactant 2-octadecylsulfanyl-p-benzoquinone, and for amphiphilic derivatives of regioregular polythiophene. In the first case control over the packing of the electroactive part of the molecule is lost because the alkyl chains dominate the packing. For amphiphilic regioregular polythiophene the ability to π stack is the important feature that controls the assembly process leading to highly conducting polycrystalline films (σ≈100 S cm –1 ). Comparisons of prototype systems such as disks, boards and rods dressed with alkyl chains show that in cases where π stacking is allowed to dominate over alkyl chain packing the structures formed at the air-water interface resemble bulk structures of similar molecules. Based on these analogies the link between the LB-assembly process and other solution based methods for film fabrication (such as spin coating) is discussed.

In situ scanning tunnelling spectroscopy of inorganic transition metal complexes

Redox molecules with equilibrium potentials suitable for electrochemical control offer perspectives in nanoscale and single-molecule electronics. This applies to molecular but also towards higher sophistication such as transistor or diode function. Most recent nanoscale or single-molecule functional systems are, however, fraught with operational limitations such as cryogenic temperatures and ultra-high vacuum, or lack of electrochemical potential control. We report here cyclic voltammetry (CV) using single-crystal Au(111)- and Pt(111)-electrodes and electrochemical in situ scanning tunnelling microscopy (STM) of a class of Os(II)/(III)- and Co(II)/(III)-complexes, the former novel molecular electronics. The complexes are robust, with ligand groups suitable for linking the complexes to the Au(111)- and Pt(111)-surfaces via N- and S-donor atoms. The data reflect monolayer behaviour. Interfacial ET of the Os-complexes is fast, kET(0) > or = 10(6) s(-1), while the Co-complex reacts much more slowly, kET(0) approximately (1-3) x 10(3) s(-1). In STM of the Os-complexes shows a maximum in the tunnelling current/overpotential relation at constant bias voltage with up to 50-fold current rise. The peak position systematically the bias voltage and equilibrium potential, in keeping with theoretical frames for two-step electron transfer (ET) of in situ STM of redox molecules. The molecular conductivity behaves broadly similarly. The Co-complex also shows a tunnelling spectroscopic feature but much weaker than the Os-complexes. This can be ascribed much smaller interfacial ET rate constant, again caused by large intramolecular nuclear reorganization and weak electronic coupling to the substrate electrode. Overall the has mapped the properties of target molecules needed for stable electronic switching, possible importance in molecular electronics towards the single-molecule level, in room temperature condensed matter environment.

Elliptical Structure of Phospholipid Bilayer Nanodiscs Encapsulated by Scaffold Proteins: Casting the Roles of the Lipids and the Protein

Phospholipid bilayers host and support the function of membrane proteins and may be stabilized in disc-like nanostructures, allowing for unprecedented solution studies of the assembly, structure, and function of membrane proteins (Bayburt et al. Nano Lett. 2002, 2, 853-856). Based on small-angle neutron scattering in combination with variable-temperature studies of synchrotron small-angle X-ray scattering on nanodiscs in solution, we show that the fundamental nanodisc unit, consisting of a lipid bilayer surrounded by amphiphilic scaffold proteins, possesses intrinsically an elliptical shape. The temperature dependence of the curvature of the nanodiscs prepared with two different phospholipid types (DLPC and POPC) shows that it is the scaffold protein that determines the overall elliptical shape and that the nanodiscs become more circular with increasing temperature. Our data also show that the hydrophobic bilayer thickness is, to a large extent, dictated by the scaffolding protein and adjusted to minimize the hydrophobic mismatch between protein and phospholipid. Our conclusions result from a new comprehensive and molecular-based model of the nanodisc structure and the use of this to analyze the experimental scattering profile from nanodiscs. The model paves the way for future detailed structural studies of functional membrane proteins encapsulated in nanodiscs.