Tomoya Takasago

Validity of arthroscopic measurement of glenoid bone loss using the bare spot

Purpose Our aim was to test the validity of using the bare spot method to quantify glenoid bone loss arthroscopically in patients with shoulder instability. Methods Twenty-seven patients with no evidence of instability (18 males, nine females; mean age 59.1 years) were evaluated arthroscopically to assess whether the bare spot is consistently located at the center of the inferior glenoid. Another 40 patients with glenohumeral anterior instability who underwent shoulder arthroscopy (30 males, ten females; mean age 25.9 years) were evaluated for glenoid bone loss with preoperative three-dimensional computed tomography (3D-CT) and arthroscopic examination. In patients without instability, the distances from the bare spot of the inferior glenoid to the anterior (Da) and posterior (Dp) glenoid rim were measured arthroscopically. In patients with instability, we compared the percentage glenoid bone loss calculated using CT versus arthroscopic measurements. Results Among patients without instability, the bare spot could not be identified in three of 27 patients. Da (9.5±1.2 mm) was smaller than Dp (10.1±1.5 mm), but it was not significantly different. However, only 55% of glenoids showed less than 1 mm of difference between Da and Dp, and 18% showed more than 2 mm difference in length. The bare spot could not be identified in five of 40 patients with instability. Pearson’s correlation coefficient showed significant (P<0.001) and strong (R2=0.63) correlation in percentage glenoid bone loss between the 3D-CT and arthroscopy method measurements. However, in ten shoulders (29%), the difference in percentage glenoid bone loss between 3D-CT and arthroscopic measurements was greater than 5%. Conclusion The bare spot was not consistently located at the center of the inferior glenoid, and the arthroscopic measurement of glenoid bone loss using the bare spot as a landmark was inaccurate in some patients with anterior glenohumeral instability. Level of evidence Level II, prospective comparative study.

Retrograde intramedullary nailing with a blocking pin technique for reduction of periprosthetic supracondylar femoral fracture after total knee arthroplasty: technical note with a compatibility chart of the nail to femoral component.

Periprosthetic fractures after total knee arthroplasty (TKA) present a clear management challenge, and retrograde intramedullary nails have recently gained widespread acceptance in treatment of these fractures. In two cases, we found a blocking screw technique, first reported by Krettek et al., was useful in the reduction of the fractures. Both patients attained preinjury mobility after intramedullary nailing. Moreover, we present a chart summarizing the notch designs of various femoral components because some prosthetic knee designs are not amenable to retrograde nailing. We hope this will be helpful in determining indications for retrograde nailing in periprosthetic fractures after TKA.

Intrapelvic Migration of the Lag Screw in Intramedullary Nailing

Internal fixation with intramedullary devices has gained popularity for the treatment of intertrochanteric femoral fractures, which are common injuries in the elderly. The most common complications are lag screw cut out from the femoral head and femoral fracture at the distal tip of the nail. We report here a rare complication of postoperative lag screw migration into the pelvis with no trauma. The patient was subsequently treated with lag screw removal and revision surgery with total hip arthroplasty. This case demonstrated that optimal fracture reduction and positioning of the lag screw are the most important surgical steps for decreasing the risk of medial migration of the lag screw. Furthermore, to prevent complications, careful attention should be paid to subsequent steps such as precise insertion of the set screw.

Navigation-Assisted Total Knee Arthroplasty for Osteoarthritis with Extra-Articular Femoral Deformity and/or Retained Hardware

Total knee arthroplasty (TKA) for osteoarthritis (OA) patients with extra-articular deformity is still challenging because angular deformity, canal sclerosis, or the retained hardware that precludes the use of the traditional intramedullary guide. In addition, atypical bone cut for intra-articular correction leads to imbalanced soft tissue gap. Furthermore, corrective osteotomy should be considered for severe deformity or para-articular deformity cases. Recently, navigation-assisted TKA has been reported to increase the accuracy of prosthetic positioning and limb alignment. This system can calculate mechanical axis regardless of extra-articular deformity, canal sclerosis, or retained hardware. Accordingly, navigation surgery has been considered to be a powerful option especially in TKAs with extra-articular deformity cases. Here, we report 3 successful navigation-assisted TKAs for osteoarthritis with extra-articular deformities and/or retained hardware. Navigation-assisted TKA is an effective and reliable alternative for patients with extra-articular deformities.

Native rotational knee kinematics are lost in bicruciate-retaining total knee arthroplasty when the tibial component is replaced

PurposeTo compare the kinematics between native knees and knees that have undergone bicruciate-retaining (BCR) total knee arthroplasty (TKA) with cruciate-retaining (CR) TKA converted from BCR TKA in the same whole-body cadaveric specimen using a navigation system and, if differences exist, to investigate the point at which normal kinematics are lost during the procedure.MethodsThe rotational kinematics throughout passive flexion of the native knee and of knees after meniscectomy, femoral replacement, BCR TKA, or CR TKA were assessed in nine fresh frozen cadavers using an image-free navigation system.ResultsThe rotational kinematic pattern of a knee after BCR TKA was different from that of a native knee, especially in the early flexion phase, and was similar to that after CR TKA. Screw-home movement was not observed after BCR TKA, but still occurred after meniscectomy or femoral replacement with intact cruciate ligaments and an intact tibial articular surface.ConclusionThe rotational kinematics of the native knee are not always preserved after BCR TKA. Native rotational kinematics are preserved after meniscectomy and femoral replacement, but are lost after tibial replacement in BCR TKA. Surgeons should pay close attention to maintain the anteroposterior stabilizing function of the ACL in BCR TKA, rather than to restore the native rotational kinematics.

The Posterior Condylar Cartilage Affects Rotational Alignment of the Femoral Component in Varus Knee Osteoarthritis

Rotational alignment of the femoral component in total knee arthroplasty (TKA) is important for patellar tracking and ligament balance. Preoperative planning based on radiography might have a potential risk for over-rotation because these X-ray based measurements can not detect asymmetric cartilage wear on posterior condyle. The purpose of this study is to evaluate the effect of the posterior condylar cartilage of varus osteoarthritic knee on rotational alignment of the femoral component in TKA. We established two different condylar twist angles (CTA) from intraoperative multiplanar reconstruction (MPR) images and intraoperative information of navigation system. The CTA measured by a navigation system that includes the cartilage (4.8±2.0°) was smaller than those measured by MPR images, which does not include the cartilage (6.6±2.1°) (p<0.05). The difference between these two angles that corresponds to the remaining posterior condylar cartilage was 1.7±1.2°. This result demonstrated that the posterior condylar cartilage might lead to over-rotational of the femoral component in varus osteoarthritic knee. Therefore, when determining rotational alignment of the femoral component, surgeons should consider the effect of the remaining posterior condylar cartilage to avoid the over-rotation of the femoral component, especially in severe varus knees. J. Med. Invest. 64: 24-29, February, 2016.

Pseudoaneurysm of the Anterior Tibial Artery following Ankle Arthroscopy in a Soccer Player

Ankle arthroscopy carries a lower risk of vascular complications when standard anterolateral and anteromedial portals are used. However, the thickness of the fat pad at the anterior ankle affords little protection for the thin-walled anterior tibial artery, rendering it susceptible to indirect damage during procedures performed on the anterior ankle joint. To our knowledge, only 11 cases of pseudoaneurysm involving the anterior tibial artery after ankle arthroscopy have been described in the literature. Here we reported a rare case of a 19-year-old soccer player who presented with pseudoaneurysm of the anterior tibial artery following ankle arthroscopy using an ankle distraction method and underwent anastomosis for the anterior tibial artery injury. Excessive distraction of the ankle puts the neurovascular structures at greater risk for iatrogenic injury of the anterior tibial artery during ankle arthroscopy. Surgeons should look carefully for postoperative ankle swelling and pain after ankle arthroscopy.

Acetabular Reconstruction Using a Trabecular Metal Cup with a Novel Pelvic Osteotomy Technique for Severe Acetabular Bone Defect

Case A 79-year-old woman with an extreme bone defect after failed cementless total hip arthroplasty underwent revision arthroplasty with a novel technique that involved cutting the anterior iliac bone and sliding it distally to reconstruct the anterior acetabular wall. A three-dimensional printed bone model enabled understanding the details of the bone defect. The clinical outcome at 3 years after surgery was favorable. Conclusion The advantages of this technique are twofold, namely, stable fixation of the cup sandwiched between the anterior and posterior walls and reconstruction of the anterior wall using living bone, which allows bone ingrowth into the cup.

Radiographic changes of cervical destructive spondyloarthropathy in long-term hemodialysis patients: A 9-year longitudinal observational study

Analyses of radiographic changes and clinical symptom of destructive spondyloarthropathy (DSA) on consecutive 42 patients managed with long-term hemodialysis were performed to elucidate radiographic changes of DSA and the factors that influence to the destructive changes. Patients underwent plain radiographs of the cervical spine with 9 years interval. Grading of radiological feature from lateral view was classified into grade 0 to grade 3. Clinical symptom was evaluated using modified Japanese Orthopaedic Association scoring system for cervical myelopathy (mJOA score). Destructive changes were observed in 3 patients at the first examination, and those were observed in 15 patients 9 years after the first examination. There is no statistically significant difference between the duration of hemodialysis and the grade. The mean age at the onset of hemodialysis, however, was significantly higher in patients of grade 2 and 3 than those of grade 1. Older patients with long-term hemodialysis had destructive changes. Destructive changes commonly observed in lower cervical spine. The average numbers of the involved disc level were 1.6 in grade 2 and 1.0 in grade 3. Clinical symptoms were varied in each grade and there was no statistically significant difference in total mJOA score among these grades. J. Med. Invest. 64: 68-73, February, 2017.

Efficacy of a computed tomography-based navigation system for placement of the acetabular component in total hip arthroplasty for developmental dysplasia of the hip

Purpose: Developmental dysplasia of the hip (DDH) presents a considerable surgical challenge in total hip arthroplasty (THA). Although the usefulness of computed tomography (CT)-based navigation in cup alignment has been reported, few reports have evaluated three-dimensional (3-D) cup positioning against the acetabulum specifically in patients with DDH. The purpose of this study was to evaluate the efficacy of a CT-based navigation system for alignment and spatial positioning of the cup in THA for patients with DDH. Methods: We reviewed 174 DDH THA cases in which CT-based navigation was used, and 75 cases in which a mechanical guide was used as a control group. Postoperative cup alignment and spatial positioning were evaluated by superimposition of a 3-D cup template onto the actual implanted cup using postoperative CT images, with pelvic coordinates matching the preoperative planning. Results: The proportion within the combined target zone (inclination and anteversion) was 97.7% in the navigation group and 61.3% in the non-navigation group. The mean absolute error between the intraoperative record and the postoperative measurement was 1.5° ± 1.3° for inclination and 2.1° ± 1.8° for anteversion in the navigation group. For acetabular cup positioning, the mean discrepancy between the preoperative planning and the postoperative measurements was 1.9 ± 1.6 mm on the transverse axis, 2.8 ± 2.3 mm on the longitudinal axis, and 1.7 ± 1.3 mm on the sagittal axis. Conclusion: THA using a CT-based navigation system achieved quite high accuracy of cup alignment angles and spatial cup positioning in primary THA for patients with DDH.