Toshiyuki Kaizu

Quantum size effects in GaAs nanodisks fabricated using a combination of the bio-template technique and neutral beam etching.

We successfully fabricated defect-free, distributed and sub-20-nm GaAs quantum dots (named GaAs nanodisks (NDs)) by using a novel top-down technique that combines a new bio-template (PEGylated ferritin) and defect-free neutral beam etching (NBE). Greater flexibility was achieved when engineering the quantum levels of ND structures resulted in greater flexibility than that for a conventional quantum dot structure because structures enabled independent control of thickness and diameter parameters. The ND height was controlled by adjusting the deposition thickness, while the ND diameter was controlled by adjusting the hydrogen-radical treatment conditions prior to NBE. Photoluminescence emission due to carrier recombination between the ground states of GaAs NDs was observed, which showed that the emission energy shift depended on the ND diameters. Quantum level engineering due to both diameter and thickness was verified from the good agreement between the PL emission energy and the calculated quantum confinement energy.

Suppression of thermal carrier escape and efficient photo-carrier generation by two-step photon absorption in InAs quantum dot intermediate-band solar cells using a dot-in-well structure

We investigated the effects of an increase in the barrier height on the enhancement of the efficiency of two-step photo-excitation in InAs quantum dot (QD) solar cells with a dot-in-well structure. Thermal carrier escape of electrons pumped in QD states was drastically reduced by sandwiching InAs/GaAs QDs with a high potential barrier of Al0.3Ga0.7As. The thermal activation energy increased with the introduction of the barrier. The high potential barrier caused suppression of thermal carrier escape and helped realize a high electron density in the QD states. We observed efficient two-step photon absorption as a result of the high occupancy of the QD states at room temperature.

Photoluminescence from GaAs nanodisks fabricated by using combination of neutral beam etching and atomic hydrogen-assisted molecular beam epitaxy regrowth

We have fabricated GaAs nanodisk (ND) structures by using a combination of neutral beam etching process and atomic hydrogen-assisted molecular beam epitaxy regrowth. We have observed clear photoluminescence (PL) emissions from GaAs NDs. The peak energy showed a blueshift due to the quantum confinement in three spatial dimensions, and it agreed with the theoretically estimated transition energy. The PL results also showed that the cap-layer disks act as radiative recombination centers. We have confirmed that the PL emission originates from the GaAs NDs, and our approach is effective for the fabrication of high quality ND structures.

Theoretical analysis of GaAs/AlGaAs quantum dots in quantum wire array for intermediate band solar cell

A GaAs quantum dot (QD) array embedded in a AlGaAs host material was fabricated using a strain-free approach, through combination of neutral beam etching and atomic hydrogen-assisted molecular beam epitaxy regrowth. In this work, we performed theoretical simulations on a GaAs/AlGaAs quantum well, GaAs QD and QD array based intermediated band solar cell (IBSC) using a combined multiband k·p and drift-diffusion transportation method. The electronic structure, IB band dispersion, and optical transitions, including absorption and spontaneous emission among the valence band, intermediate band, and conduction band, were calculated. Based on these results, maximum conversion efficiency of GaAs/AlGaAs QD array based IBSC devices were calculated by a drift-diffusion model adapted to IBSC under the radiative recombination limit.

Polarization-insensitive optical gain characteristics of highly stacked InAs/GaAs quantum dots

The polarized optical gain characteristics of highly stacked InAs/GaAs quantum dots (QDs) with a thin spacer layer fabricated on an n+-GaAs (001) substrate were studied in the sub-threshold gain region. Using a 4.0-nm-thick spacer layer, we realized an electronically coupled QD superlattice structure along the stacking direction, which enabled the enhancement of the optical gain of the [001] transverse-magnetic (TM) polarization component. We systematically studied the polarized electroluminescence properties of laser devices containing 30 and 40 stacked InAs/GaAs QDs. The net modal gain was analyzed using the Hakki-Paoli method. Owing to the in-plane shape anisotropy of QDs, the polarization sensitivity of the gain depends on the waveguide direction. The gain showing polarization isotropy between the TM and transverse-electric polarization components is high for the [110] waveguide structure, which occurs for higher amounts of stacked QDs. Conversely, the isotropy of the [−110] waveguide is easily achiev...

Two-step photon up-conversion solar cells

Reducing the transmission loss for below-gap photons is a straightforward way to break the limit of the energy-conversion efficiency of solar cells (SCs). The up-conversion of below-gap photons is very promising for generating additional photocurrent. Here we propose a two-step photon up-conversion SC with a hetero-interface comprising different bandgaps of Al0.3Ga0.7As and GaAs. The below-gap photons for Al0.3Ga0.7As excite GaAs and generate electrons at the hetero-interface. The accumulated electrons at the hetero-interface are pumped upwards into the Al0.3Ga0.7As barrier by below-gap photons for GaAs. Efficient two-step photon up-conversion is achieved by introducing InAs quantum dots at the hetero-interface. We observe not only a dramatic increase in the additional photocurrent, which exceeds the reported values by approximately two orders of magnitude, but also an increase in the photovoltage. These results suggest that the two-step photon up-conversion SC has a high potential for implementation in the next-generation high-efficiency SCs.

Saturable Two-Step Photocurrent Generation in Intermediate-Band Solar Cells Including InAs Quantum Dots Embedded in Al

We studied in detail the photocurrent generation process in two-step photon absorption in intermediate-band solar cells, including InAs quantum dots embedded in Al0.3Ga0.7 As/GaAs quantum wells at room temperature. The photocurrent generated by the two-step photon absorption exhibited saturation as the interband excitation intensity increased in strength. On the other hand, as the intersubband excitation intensity increased, the twostep photoexcitation current deviated from a power law. Furthermore, the two-step photoexcitation current exhibiting saturation and deviation strongly depended on both the interband and intersubband excitation intensities. To interpret these phenomena, we performed a theoretical simulation of the two-step photoexcitation current. The results suggest that the photocurrent saturation and deviation were caused by filling of the intermediate states with electrons. Furthermore, our calculated results indicate that the electron-recombination lifetime in the intermediate states is extremely long. The results of the temperature dependence of the two-step photoexcitation current and the excitation intensity dependence of photoluminescence suggest that efficient electron-hole separation extends electron lifetime.

_{0.3}

We investigated the effects of the GaAs capping temperature on the morphological and photoluminescence (PL) properties of InAs quantum dots (QDs) on GaAs(001). The broadband tuning of the emission wavelength from 1.1 to 1.3 μm was achieved at room temperature by only adjusting the GaAs capping temperature. As the capping temperature was decreased, the QD shrinkage due to In desorption and In-Ga intermixing during the capping process was suppressed. This led to QDs with a high aspect ratio, and resultantly, the emission wavelength shifted toward the longer-wavelength side. In addition, the linearly polarized PL intensity elucidated anisotropic characteristics reflecting the shape anisotropy of the embedded QDs, in which a marked change in polarization anisotropy occurred at capping temperatures lower than 460 °C.

Ga

We studied the structural and photoluminescence (PL) characteristics of InAs quantum dots (QDs) grown on nitrogen (N) δ-doped GaAs(001). The emission wavelength for low-density N-δ doping exhibited a blueshift with respect to that for undoped GaAs and was redshifted with increasing N-sheet density. This behavior corresponded to the variation in the In composition of the QDs. N-δ doping has two opposite and competing effects on the incorporation of Ga atoms from the underlying layer into the QDs during the QD growth. One is the enhancement of Ga incorporation induced by the lattice strain, which is due to the smaller radius of N atoms. The other is an effect blocking for Ga incorporation, which is due to the large bonding energy of Ga-N or In-N. At a low N-sheet density, the lattice-strain effect was dominant, while the blocking effect became larger with increasing N-sheet density. Therefore, the incorporation of Ga from the underlying layer depended on the N-sheet density. Since the In-Ga intermixing betw...

_{0.7}

We studied the effects of miniband formation on the photocurrent generated by two-step intersubband absorption in an intermediate-band solar cell incorporating an InAs/GaAs quantum dot superlattice (QDSL). The two-step photocarrier generation increases with the electronic state coupling of InAs QDSLs in the intrinsic layer. Because carriers that are excited into the superlattice minibands spatially separate in an internal electric field, the electron–hole recombination rate for the photoexcited carriers decreases, and therefore, the electron lifetime increases. The long-lived electrons in the intermediate states of the QDSL miniband increase the intersubband absorption strength. We confirmed a systematic sensitive change in the two-step photocurrent generation depending on the miniband formation controlled by the temperature.