Valderi L. Dressler

N-acetylcysteine prevents memory deficits, the decrease in acetylcholinesterase activity and oxidative stress in rats exposed to cadmium

The present study investigated the effect of the administration of N-acetylcysteine (NAC), on memory, on acetylcholinesterase (AChE) activity and on lipid peroxidation in different brain structures in cadmium (Cd)-exposed rats. The rats received Cd (2 mg/kg) and NAC (150 mg/kg) by gavage every other day for 30 days. The animals were divided into four groups (n=12-13): control/saline, NAC, Cd, and Cd/NAC. The results showed a decrease in step-down latency in the Cd-group, but NAC reversed the impairment of memory induced by Cd intoxication. Rats exposed to Cd and/or treated with NAC did not demonstrate altered shock sensitivity. Decreased AChE activity was found in hippocampus, cerebellum and hypothalamus in the Cd-group but NAC reversed this effect totally or partially while in cortex synaptosomes and striatum there was no alteration in AChE activity. An increase in TBARS levels was found in hippocampus, cerebellum and hypothalamus in the Cd-group and NAC abolished this effect while in striatum there was no alteration in TBARS levels. Urea and creatinine levels were increased in serum of Cd-intoxicated rats, but NAC was able to abolish these undesirable effects. The present findings show that treatment with NAC prevented the Cd-mediated decrease in AChE activity, as well as oxidative stress and consequent memory impairment in Cd-exposed rats, demonstrating that this compound may modulate cholinergic neurotransmission and consequently improve cognition. However, it is necessary to note that the mild renal failure may be a contributor to the behavioral impairment found in this investigation.

Cadmium and mineral nutrient accumulation in potato plantlets grown under cadmium stress in two different experimental culture conditions

In order to evaluate the effect of cadmium (Cd(2+)) toxicity on mineral nutrient accumulation in potato (Solanum tuberosum L.), two cultivars named Asterix and Macaca were cultivated both in vitro and in hydroponic experiments under increasing levels of Cd(2+) (0, 100, 200, 300, 400 and 500 microM in vitro and 0, 50, 100, 150 and 200 microM in hydroponic culture). At 22 and 7 days of exposure to Cd(2+), for the in vitro and hydroponic experiment, respectively, the plantlets were separated into roots and shoot, which were analyzed for biomass as well as Cd(2+), and macro (Ca(2+), K(+) and Mg(2+)) and micronutrient (Cu(2+), Fe(2+), Mn(2+) and Zn(2+)) contents. In the hydroponic experiment, there was no reduction in shoot and root dry weight for any Cd(2+) level, regardless of the potato cultivar. In contrast, in the in vitro experiment, there was an increase in biomass at low Cd(2+) levels, while higher Cd(2+) levels caused a decrease. In general, Cd(2+) decreased the macronutrient and micronutrient contents in the in vitro cultured plantlets in both roots and shoot of cultivars. In contrast, the macronutrient and micronutrient contents in the hydroponically grown plantlets were generally not affected by Cd(2+). Our data suggest that the influence of Cd(2+) on nutrient content in potato was related to the level of Cd(2+) in the substrate, potato cultivar, plant organ, essential element, growth medium and exposure time.

Review of the applications of laser ablation inductively coupled plasma mass spectrometry (LA-ICP-MS) to the analysis of biological samples

Laser ablation inductively coupled plasma mass spectrometry (LA-ICP-MS) has received significant attention over the last 10 years and has been widely used for the analysis of biological samples. The technique allows the determination of elements and isotopes in biological tissues and related materials with a spatial resolution typically ranging from 10 to 100 μm. When compared to other techniques usually employed to obtain bioimages, the greater advantage of LA-ICP-MS is its higher sensitivity. The literature survey over the last 10 years concerning the use of LA-ICP-MS for biological tissue analysis is reviewed in this article. Instrumentation, strategies of calibration for quantitative analysis, challenges and recent advances in this field are discussed. Applications of the isotope ratio (IR), including tracer experiments, and isotope dilution (ID), are reviewed for biological samples (briefly for proteins, in order to show the utility of LA-ICP-MS). Bioimaging methods, studies and applications for animal and plants tissues are emphasized, demonstrating the importance of bioimaging of metals and metalloids in biomedical research, bioaccumulation and bioavailability studies for ecological and toxicological risk assessment in humans, animals and plants. The usefulness of the IR associated with bioimaging for predicting geographical origin, habitat, movement of subjects, diet and lifestyle are also demonstrated.

Ultrasound-assisted oxidative process for sulfur removal from petroleum product feedstock

A procedure using ultrasonic irradiation is proposed for sulfur removal of a petroleum product feedstock. The procedure involves the combination of a peroxyacid and ultrasound-assisted treatment in order to comply with the required sulfur content recommended by the current regulations for fuels. The ultrasound-assisted oxidative desulfurization (UAOD) process was applied to a petroleum product feedstock using dibenzothiophene as a model sulfur compound. The influence of ultrasonic irradiation time, oxidizing reagents amount, kind of solvent for the extraction step and kind of organic acid were investigated. The use of ultrasonic irradiation allowed higher efficiency for sulfur removal in comparison to experiments performed without its application, under the same reactional conditions. Using the optimized conditions for UAOD, the sulfur removal was about 95% after 9min of ultrasonic irradiation (20kHz, 750W, run at 40%), using hydrogen peroxide and acetic acid, followed by extraction with methanol.

Determination of copper, cadmium, lead, bismuth and selenium(iv) in sea-water by electrothermal vaporization inductively coupled plasma mass spectrometry after on-line separation

A procedure for the determination of Cu, Cd, Pb, Bi and SeIV in sea-water by electrothermal vaporization inductively coupled plasma mass spectrometry, after on-line separation using a flow injection system, is proposed. Matrix separation and analyte preconcentration was accomplished by retention of the analytes complexed with the ammonium salt of O,O-diethyldithiophosphoric acid on C18 immobilized on silica in a minicolumn coupled directly to the autosampler arm of the vaporizer. The methanol used as eluent was vaporized after being automatically injected into the graphite tube, prior to the vaporization of the analytes. The conditions for the on-line complexation and separation as well as the vaporizer temperature program were optimized. The recoveries from sea-water ranged from 90 to 110%. The accuracy of the method was tested by the analysis of two certified sea-waters, CASS-3 and NASS-4, from the National Research Council of Canada. The concentration of Bi in these sea-waters was below the method detection limit. The relative standard deviation was below 10% (n=6). The throughput was 22 samples h–1 and the volume of sample consumed was only 2.3 ml. Tl and AsIII were also separated but their complexation in sea-water was not efficient.

Biomonitoring of essential and toxic metals in single hair using on-line solution-based calibration in laser ablation inductively coupled plasma mass spectrometry.

Laser ablation inductively coupled plasma mass spectrometry (LA-ICP-MS) has been established as a powerful and sensitive surface analytical technique for the determination of concentration and distribution of trace metals within biological systems at micrometer spatial resolution. LA-ICP-MS allows easy quantification procedures if suitable standard references materials (SRM) are available. In this work a new SRM-free approach of solution-based calibration method in LA-ICP-MS for element quantification in hair is described. A dual argon flow of the carrier gas and nebulizer gas is used. A dry aerosol produced by laser ablation (LA) of biological sample and a desolvated aerosol generated by pneumatic nebulization (PN) of standard solutions are carried by two different flows of argon as carrier or nebulizer gas, respectively and introduced separately in the injector tube of a special ICP torch, through two separated apertures. Both argon flows are mixed directly in the ICP torch. External calibration via defined standard solutions before analysis of single hair was employed as calibration strategy. A correction factor, calculated using hair with known analyte concentration (measured by ICP-MS), is applied to correct the different elemental sensitivities of ICP-MS and LA-ICP-MS. Calibration curves are obtained by plotting the ratio of analyte ion M(+)/(34)S(+) ion intensities measured using LA-ICP-MS in dependence of analyte concentration in calibration solutions. Matrix-matched on-line calibration in LA-ICP-MS is carried out by ablating of human hair strands (mounted on a sticky tape in the LA chamber) using a focused laser beam in parallel with conventional nebulization of calibration solutions. Calibrations curves of Li, Na, Mg, Al, K, V, Cr, Mn, Fe, Ni, Co, Cu, Zn, Sr, Mo, Ag, Cd, I, Hg, Pb, Tl, Bi and U are presented. The linear correlation coefficients (R) of calibration curves for analytes were typically between 0.97 and 0.999. The limits of detection (LODs) of Li, V, Mn, Ni, Co, Cu, Sr, Mo, Ag, Ba, Cd, I, Hg, Pb, Bi and U in a single hair strand were in the range of 0.001-0.90 μg g(-1), whereas those of Cr and Zn were 3.4 and 5.1 μg g(-1), respectively. The proposed quantification strategy using on-line solution-based calibration in LA-ICP-MS was applied for biomonitoring (the spatial resolved distribution analysis) of essential and toxic metals and iodine in human hair and mouse hair.

Determination of toxic elements in coal by ICP-MS after digestion using microwave-induced combustion.

A microwave-induced combustion (MIC) procedure was applied for coal digestion for subsequent determination of As, Cd and Pb by inductively coupled plasma mass spectrometry (ICP-MS) and Hg using cold vapor (CV) generation coupled to ICP-MS. Pellets of coal (500 mg) were combusted using 20 bar of oxygen and ammonium nitrate as aid for ignition. The use of nitric acid as absorbing solution (1.7, 3.5, 5.0, 7.0 and 14 mol L(-1)) was evaluated. For coal samples with higher ash content, better results were found using 7.0 mol L(-1) HNO(3) and an additional reflux step of 5 min after combustion step. For coal samples with ash content lower than 8%, 5.0 mol L(-1) nitric acid was suitable to the absorption of all analytes. Accuracy was evaluated using certified reference material (CRM) of coal and spikes. Agreement with certified values and recoveries was better than 95 and 97%, respectively, for all the analytes. For comparison of results, a procedure recommended by the American Society of Testing and Materials (ASTM) was used. Additionally, a conventional microwave-assisted digestion (MAD) in pressurized vessels was also performed. Using ASTM procedure, analyte losses were observed and a relatively long time was necessary for digestion (>6h). By comparison with MAD procedure, higher sample mass can be digested using MIC allowing better limits of detection. Additionally, the use of concentrated acids was not necessary that is an important aspect in order to obtain low blank levels and lower limits of detection, respectively. The residual carbon content in digests obtained by MAD and MIC was about 15% and <1%, respectively, showing the better digestion efficiency of MIC procedure. Using MIC it was possible to digest completely and simultaneously up to eight samples in only 25 min with relatively lower generation of laboratory effluents.

Determination of trace elements in biological materials by ETV-ICP-MS after dissolution or slurry formation with tetramethylammonium hydroxide

A method to prepare biological samples to be analysed by electrothermal vaporization inductively coupled plasma mass spectrometry is proposed. A solution or slurry was formed by mixing a sample aliquot, 20–100 mg, with a small volume, 10–200 µL, of a 25% m/v tetramethylammonium hydroxide solution. For animal tissues, complete dissolution was obtained, whereas for the plant and whole egg materials, slurries were obtained. The slurries were stirred manually, every three readings, in the instrument. The pyrolysis and atomization temperatures were optimized, using Pd as a carrier–modifier for As, Se, Te, Ag, Cr, Cu, V, Ni, Mn, Co and Cd. An Ir-coated tube was used for Pb, Sb, Sn and Bi. External calibration was used preferentialy, but in some instances, the analyte additions method was employed. Good results were obtained for four certified reference materials. However, Cr and Cd could not be determined in the bovine muscle sample owing to spectral interferences and matrix effects, respectively.

Nickel, vanadium and sulfur determination by inductively coupled plasma optical emission spectrometry in crude oil distillation residues after microwave-induced combustion

Microwave-induced combustion (MIC) was applied for digestion of crude oil distillation residues for further total nickel, vanadium and sulfur determination by inductively coupled plasma optical emission spectrometry (ICP OES). Sample masses up to 500 mg of atmospheric distillation residue (AR) and vacuum distillation residue (VR) were completely combusted using the MIC system. A polyethylene film was used to wrap the samples allowing a feasible combustion process. Ammonium nitrate (6 mol l−1 solution, 50 µl) was used as an aid for ignition. Parameters related to the combustion process, as sample mass and oxygen pressure for MIC were investigated. The type and concentration of absorbing solution (H2O, 5% v/v H2O2 and 1 to 14 mol l−1 HNO3) used to absorb gaseous combustion products as well as the use of an additional reflux step were studied. Diluted nitric acid (2 mol l−1) was selected as absorbing solution resulting in a suitable medium for simultaneous Ni, V and S determination by ICP OES in both AR and VR samples. The agreement to certified values for Ni, V and S was from 99 to 101% for MIC using 2 mol l−1 HNO3 as absorbing solution with a reflux step. Results obtained by MIC for AR and VR samples were also in agreement with results obtained using high pressure microwave-assisted wet digestion. Limits of detection by MIC and further ICP OES determination were 0.2, 0.1 and 2 µg g−1 for Ni, V and S, respectively. It was possible to digest up to eight samples each run. Digestion time was reduced twice when compared to high-pressure microwave-assisted wet digestion.

Chloride determination by ion chromatography in petroleum coke after digestion by microwave-induced combustion

Microwave-induced combustion was applied to petroleum coke digestion in closed vessels for further chloride determination by ion chromatography. Samples were pressed as pellets and placed on a quartz holder. Combustion was performed using oxygen pressure of 2 MPa and 50 microl of 6 moll(-1) NH(4)NO(3) as aid for ignition. Recoveries from 97 to 102% were obtained for all studied absorbing solutions (water, H(2)O(2), Na(2)CO(3) or (NH(4))(2)CO(3)). Accuracy was evaluated using certified reference materials with agreement better than 98% using water as absorbing solution with reflux step. The limit of quantification was 3.8 microg g(-1).