Wei Jing

Design, Analysis and R&D of the EAST In-Vessel Components

In-vessel components are important parts of the EAST superconducting tokamak. They include the plasma facing components, passive plates, cryo-pumps, in-vessel coils, etc. The structural design, analysis and related R&D have been completed. The divertor is designed in an up-down symmetric configuration to accommodate both double null and single null plasma operation. Passive plates are used for plasma movement control. In-vessel coils are used for the active control of plasma vertical movements. Each cryo-pump can provide an approximately 45 m3/s pumping rate at a pressure of 10−1 Pa for particle exhaust. Analysis shows that, when a plasma current of 1 MA disrupts in 3 ms, the EM loads caused by the eddy current and the halo current in a vertical displacement event (VDE) will not generate an unacceptable stress on the divertor structure. The bolted divertor thermal structure with an active cooling system can sustain a load of 2 MW/m2 up to a 60 s operation if the plasma facing surface temperature is limited to 1500 °C. Thermal testing and structural optimization testing were conducted to demonstrate the analysis results.

The Alignment and Assembly for EAST Tokamak Device

EAST (HT-7U) is a large fusion experimental device. It is a full superconducting tokamak with 1 MA of plasma current, 1000 s of plasma duration, high elongation and triangularity. It mainly consists of superconducting magnets of poloidal and toroidal field (PF & TF), vacuum vessel (VV), thermal radiation shield (TRS) and cryostat vessel (CV). The significant difficulty for assembly of EAST is tight installation tolerances, which are in the order of several tenth of a millimeter. In particular, the alignment of plasma facing components to the magnetic axis of the device is less than ± 0.5 mm. At present, a reasonable assembly process of EAST has been defined, and based on it, the alignment method for EAST, including the survey control network, the location of the main components in different directions, the magnetic axis determination and the accurate positioning of the plasma facing components inside of the vacuum vessel and so on, has been defined by using the sophisticated optical metrology system (SOMS). This paper describes the assembly procedure of EAST and the installation tolerances associated with the main components. Meanwhile, how to establish the assembly survey control network, magnetic axis determination methods, are introduced in detail.

Feasibility Study on Welding Structure of the HT-7U Toroidal Field Coil Case

The Toroidal Field (TF) coil case of the HT-7U superconducting tokamak device is made of austenitic stainless steel 316LN and is designed to operate at cryogenic temperature (4 K). 316LN can retain high strength and fracture toughness at 4 K. Feasibility study on technical process of welding has been experimentally considered as a hopeful joint method for suppression of post-welding deformation and reduction of over-heating. Meanwhile the final range of stress intensity and the stress intensity factor (K) for pre-cracks of welding structure have been determined by using J-integral. These related results are optimistic and have shown that theres no problem in strength and fracture toughness at the vicinity of the pre-crack tip. This paper introduces the welding structure of TF coil case in detail.