Weibao Qiu

A multifunctional, reconfigurable pulse generator for high-frequency ultrasound imaging

High-frequency (>;20 MHz) ultrasound (HFUS) imaging systems have made it possible to image small structures with fine spatial resolution. They find a variety of biomedical applications in dermatology, ophthalmology, intravascular imaging, and small-animal imaging. One critical technical challenge of HFUS is to generate high-voltage, high-frequency pulsed signals to effectively excite the transducer for a high SNR. This paper presents the development of a multifunctional, reconfigurable pulse generator for HFUS imaging. The pulse generator can produce a high-voltage unipolar pulse, a bipolar pulse, or arbitrary pulses for B-mode imaging, Doppler measurement, and modulated excitation imaging. The characteristics of the pulses, such as timing, waveform, and frequency are reconfigurable by a high-speed field-programmable gate array (FPGA). Customized software was developed to interface with the FPGA through a USB connector for pulse selection, and easy, flexible, real-time pulse management. The hardware was implemented in a compact, printed circuit board (PCB)-based scheme using state-of-the-art electronics for cost-effectiveness and fully digital control. Testing results show that the unipolar pulse can reach over 165 Vpp with a 6-dB bandwidth of 70 MHz, and the bipolar pulse and arbitrary pulses can reach 150 and 60 Vpp with central frequencies of 60 and 120 MHz, respectively.

An FPGA-based open platform for ultrasound biomicroscopy

Ultrasound biomicroscopy (UBM) has been extensively applied to preclinical studies in small animal models. Individual animal study is unique and requires different utilization of the UBM system to accommodate different transducer characteristics, data acquisition strategies, signal processing, and image reconstruction methods. There is a demand for a flexible and open UBM platform to allow users to customize the system for various studies and have full access to experimental data. This paper presents the development of an open UBM platform (center frequency 20 to 80 MHz) for various preclinical studies. The platform design was based on a field-programmable gate array (FPGA) embedded in a printed circuit board to achieve B-mode imaging and directional pulsed-wave Doppler. Instead of hardware circuitry, most functions of the platform, such as filtering, envelope detection, and scan conversion, were achieved by FPGA programs; thus, the system architecture could be easily modified for specific applications. In addition, a novel digital quadrature demodulation algorithm was implemented for fast and accurate Doppler profiling. Finally, test results showed that the platform could offer a minimum detectable signal of 25 μV, allowing a 51 dB dynamic range at 47 dB gain, and real-time imaging at more than 500 frames/s. Phantom and in vivo imaging experiments were conducted and the results demonstrated good system performance.

High Performance Relaxor-Based Ferroelectric Single Crystals for Ultrasonic Transducer Applications

Relaxor-based ferroelectric single crystals Pb(Mg1/3Nb2/3)O3-PbTiO3 (PMN-PT) have drawn much attention in the ferroelectric field because of their excellent piezoelectric properties and high electromechanical coupling coefficients (d33∼2000 pC/N, kt∼60%) near the morphotropic phase boundary (MPB). Ternary Pb(In1/2Nb1/2)O3-Pb(Mg1/3Nb2/3)O3-PbTiO3 (PIN-PMN-PT) single crystals also possess outstanding performance comparable with PMN-PT single crystals, but have higher phase transition temperatures (rhombohedral to tetragonal Trt, and tetragonal to cubic Tc) and larger coercive field Ec. Therefore, these relaxor-based single crystals have been extensively employed for ultrasonic transducer applications. In this paper, an overview of our work and perspectives on using PMN-PT and PIN-PMN-PT single crystals for ultrasonic transducer applications is presented. Various types of single-element ultrasonic transducers, including endoscopic transducers, intravascular transducers, high-frequency and high-temperature transducers fabricated using the PMN-PT and PIN-PMN-PT crystals and their 2-2 and 1-3 composites are reported. Besides, the fabrication and characterization of the array transducers, such as phased array, cylindrical shaped linear array, high-temperature linear array, radial endoscopic array, and annular array, are also addressed.

Improved Anatomical Specificity of Non-invasive Neuro-stimulation by High Frequency (5 MHz) Ultrasound.

Low frequency ultrasound (<1 MHz) has been demonstrated to be a promising approach for non-invasive neuro-stimulation. However, the focal width is limited to be half centimeter scale. Minimizing the stimulation region with higher frequency ultrasound will provide a great opportunity to expand its application. This study first time examines the feasibility of using high frequency (5 MHz) ultrasound to achieve neuro-stimulation in brain, and verifies the anatomical specificity of neuro-stimulation in vivo. 1 MHz and 5 MHz ultrasound stimulation were evaluated in the same group of mice. Electromyography (EMG) collected from tail muscles together with the motion response videos were analyzed for evaluating the stimulation effects. Our results indicate that 5 MHz ultrasound can successfully achieve neuro-stimulation. The equivalent diameter (ED) of the stimulation region with 5 MHz ultrasound (0.29 ± 0.08 mm) is significantly smaller than that with 1 MHz (0.83 ± 0.11 mm). The response latency of 5 MHz ultrasound (45 ± 31 ms) is also shorter than that of 1 MHz ultrasound (208 ± 111 ms). Consequently, high frequency (5 MHz) ultrasound can successfully activate the brain circuits in mice. It provides a smaller stimulation region, which offers improved anatomical specificity for neuro-stimulation in a non-invasive manner.

Computer-assisted assessment of ultrasound real-time elastography: Initial experience in 145 breast lesions

PURPOSE To develop and evaluate a computer-assisted method of quantifying five-point elasticity scoring system based on ultrasound real-time elastography (RTE), for classifying benign and malignant breast lesions, with pathologic results as the reference standard. MATERIALS AND METHODS Conventional ultrasonography (US) and RTE images of 145 breast lesions (67 malignant, 78 benign) were performed in this study. Each lesion was automatically contoured on the B-mode image by the level set method and mapped on the RTE image. The relative elasticity value of each pixel was reconstructed and classified into hard or soft by the fuzzy c-means clustering method. According to the hardness degree inside lesion and its surrounding tissue, the elasticity score of the RTE image was computed in an automatic way. Visual assessments of the radiologists were used for comparing the diagnostic performance. Histopathologic examination was used as the reference standard. The Students t test and receiver operating characteristic (ROC) curve analysis were performed for statistical analysis. RESULTS Considering score 4 or higher as test positive for malignancy, the diagnostic accuracy, sensitivity, specificity, positive predictive value (PPV) and negative predictive value (NPV) were 93.8% (136/145), 92.5% (62/67), 94.9% (74/78), 93.9% (62/66), and 93.7% (74/79) for the computer-assisted scheme, and 89.7% (130/145), 85.1% (57/67), 93.6% (73/78), 92.0% (57/62), and 88.0% (73/83) for manual assessment. Area under ROC curve (Az value) for the proposed method was higher than the Az value for visual assessment (0.96 vs. 0.93). CONCLUSION Computer-assisted quantification of classical five-point scoring system can significantly eliminate the interobserver variability and thereby improve the diagnostic confidence of classifying the breast lesions to avoid unnecessary biopsy.

An open system for intravascular ultrasound imaging

Intravascular ultrasound (IVUS) is able to delineate internal structures of vessel wall with fine spatial resolution. However, the developed IVUS is insufficient to identify the fibrous cap thickness and tissue composition of atherosclerotic lesions. Currently, novel imaging strategies are proposed such as increasing the center frequency of ultrasound or using modulated excitation technique to improve the accuracy of diagnosis. Dual mode tomography combining the IVUS with optical tomography has also been developed to determine tissue morphology and characteristics. The implementation of these new imaging methods requires an open system that allows users to customize the system for various studies. This paper presents the development of an IVUS system that has open structures to support various imaging strategies. In vitro IVUS vessel imaging and multi-modality imaging with photoacoustics were conducted to demonstrate the performance of the open system.

A Novel Modulated Excitation Imaging System for Microultrasound

Microultrasound (micro-US), also known as ultrasound biomicroscope, is able to delineate small structures with fine spatial resolution. However, micro-US suffers limited depth of penetration due to significantly large attenuation at high frequencies. Modulated excitation imaging has displayed the capability to improve the penetration depth, while maintaining the spatial resolution. But the effectiveness of this technique in micro-US has not been fully demonstrated. In addition, the current modulated excitation imaging systems for micro-US are designed for specific excitation method, therefore, lack of flexibility, and are typically bulky and expensive. This paper presents the development of a novel system to achieve modulated excitation imaging with high programmability and flexibility to satisfy various micro-US studies. It incorporates a high-voltage arbitrary waveform generator for producing desired excitation waveform, and a programmable imaging receiver implemented by the state-of-the-art electronics and field-programmable gate array. Test results show that the proposed modulated excitation imaging system can acquire up to 20 dB signal-to-noise ratio improvement and 83% increase of penetration depth in contrast to traditional short-pulse imaging method. In vivo experiment on the dorsal skin of a human hand demonstrates good performance of the programmable modulated excitation imaging system.

A flexible annular-array imaging platform for micro-ultrasound

Micro-ultrasound is an invaluable imaging tool for many clinical and preclinical applications with high resolution (about several tens microns). The imaging systems for micro-ultrasound are developed extensively in recent years including single element imaging systems, and linear array imaging systems. This paper presents the development of a novel programmable and real-time annular array imaging platform for micro-ultrasound. It supported multi-channel dynamic beamforming technique for large depth-of-field imaging. The major image processing algorithms were achieved by the novel field programmable technology for high speed and flexibility. Real-time imaging processing was achieved by fast processing algorithms and high speed data transfer interface. Extensive tests including hardware, algorithms, wire phantom, and tissue mimicking phantom measurements were conducted to demonstrate good performance of the platform. The calculated contrast-to-noise ratio (CNR) of the tissue phantom measurements were higher than 1.2 in the range of 3.8-8.7 mm imaging depth. The platform supported higher than 25 images per second for real-time image acquisition. The depth-of-field had about 2.5-fold improvement as opposed to single element transducer imaging.

A novel dual-frequency imaging method for intravascular ultrasound applications.

Intravascular ultrasound (IVUS), which is able to delineate internal structures of vessel wall with fine spatial resolution, has greatly enriched the knowledge of coronary atherosclerosis. A novel dual-frequency imaging method is proposed in this paper for intravascular imaging applications. A probe combined two ultrasonic transducer elements with different center frequencies (36 MHz and 78 MHz) is designed and fabricated with PMN-PT single crystal material. It has the ability to balance both imaging depth and resolution, which are important imaging parameters for clinical test. A dual-channel imaging platform is also proposed for real-time imaging, and this platform has been proven to support programmable processing algorithms, flexible imaging control, and raw RF data acquisition for IVUS applications. Testing results show that the -6 dB axial and lateral imaging resolutions of low-frequency ultrasound are 78 and 132 μm, respectively. In terms of high-frequency ultrasound, axial and lateral resolutions are determined to be as high as 34 and 106 μm. In vitro intravascular imaging on healthy swine aorta is conducted to demonstrate the performance of the dual-frequency imaging method for IVUS applications.

Development of a Mechanical Scanning Device With High-Frequency Ultrasound Transducer for Ultrasonic Capsule Endoscopy

Wireless capsule endoscopy has opened a new era by enabling remote diagnostic assessment of the gastrointestinal tract in a painless procedure. Video capsule endoscopy is currently commercially available worldwide. However, it is limited to visualization of superficial tissue. Ultrasound (US) imaging is a complementary solution as it is capable of acquiring transmural information from the tissue wall. This paper presents a mechanical scanning device incorporating a high-frequency transducer specifically as a proof of concept for US capsule endoscopy (USCE), providing information that may usefully assist future research. A rotary solenoid-coil-based motor was employed to rotate the US transducer with sectional electronic control. A set of gears was used to convert the sectional rotation to circular rotation. A single-element focused US transducer with 39-MHz center frequency was used for high-resolution US imaging, connected to an imaging platform for pulse generation and image processing. Key parameters of US imaging for USCE applications were evaluated. Wire phantom imaging and tissue phantom imaging have been conducted to evaluate the performance of the proposed method. A porcine small intestine specimen was also used for imaging evaluation in vitro. Test results demonstrate that the proposed device and rotation mechanism are able to offer good image resolution (