William H. Blake

Heating effects on water repellency in Australian eucalypt forest soils and their value in estimating wildfire soil temperatures

Wildfires can induce or enhance soil water repellency under a range of vegetation communities. Accord- ing to mainly USA-based laboratory studies, repellency is eliminated at a maximum soil temperature (T )o f 280-400 ◦ C. Knowledge of T reached during a wildfire is important in evaluating post-fire soil physical prop- erties, fertility and seedbed status. T is, however, notoriously difficult to ascertain retrospectively and often based on indicative observations with a large potential error. Soils under fire-prone Australian eucalypt forests tend to be water repellent when dry or moderately moist even if long unburnt. This study aims to quantify the temperature of water repellency destruction for Australian topsoil material sampled under three sites with contrasting eucalypt cover (Eucalyptus sieberi, E. ovata and E. baxteri). Soil water repellency was present prior to heating in all sam- ples, increased during heating, but was abruptly eliminated at a specific T between 260 and 340 ◦ C. Elimination temperature varied somewhat between samples, but was found to be dependent on heating duration, with longest duration resulting in lowest elimination temperature. Results suggest that post-fire water repellency may be used as an aid in hindcasting soil temperature reached during the passage of a fire within repellency-prone environments.

Fire severity, water repellency characteristics and hydrogeomorphological changes following the Christmas 2001 Sydney forest fires

Soil water repellency can enhance overland flow and erosion and may be altered by fire. The Christmas 2001 bushfires near Sydney allowed investigation of the relationship between fire severity, water repellency and hydrogeomorphological changes. For two sub-catchments with differences in fire severities in Nattai National Park, south-west of Sydney, this paper considers: (1) the links between fire severity based on SPOT image analysis and ground observation of fire severity and repellency; (2) the textural and organic/minerogenic characteristics of eroded sediment; and (3) erodibility, erosion and deposition of soils in both catchments. Ground surveys show that image analysis reflects well the degree of vegetation consumption by fire, but cannot adequately predict the degree of ground litter consumption, associated soil heating and repellency effects. Fire had varying effects on repellency, leaving it unchanged, destroying it or enhancing it, depending on the soil temperature reached. The main post-fire hydrogeomorphological changes have been widespread erosion and colluvial and alluvial deposition of topsoil in foot-slope locations and river systems, but only localised redistribution of the highly erodible, repellent sandy subsurface layer. The fire did not trigger major geomorphological change in the study area, but fires probably cause important topsoil and nutrient depletion and may also affect water quality.

Initial flux of sediment-associated radiocesium to the ocean from the largest river impacted by Fukushima Daiichi Nuclear Power Plant

This study aimed to quantify the flux of radiocesium in the Abukuma Basin (5,172 km2), the largest river system affected by fallout from the Fukushima Daiichi Nuclear Power Plant (FDNPP) event. In the period from 10 August 2011 to 11 May 2012 an estimated 84 to 92% of the total radiocesium transported in the basins fluvial system was carried in particulate form. During this monitoring period Typhoon Roke (September 2011) was observed to induce a significant and temporally punctuated redistribution of radiocesium. The storm-mobilised radiocesium was an estimated 6.18 Terabecquerels corresponding to 61.4% of the total load delivered to the coastal zone during the observation period. The total flux of radiocesium into the Pacific Ocean estimated at the outlet station (basin area 5,172 km2) was 5.34 TBq for 137Cs, and 4.74 TBq for 134Cs, corresponding to 1.13% of the total estimated radiocesium fallout over the basin catchment (890 TBq). This was equivalent to the estimated amount of direct leakage from FDNPP to the ocean during June 2011 to September 2012 of 17 TBq and the Level 3 Scale Leakage on 21August 2013 (24 TBq).

A 700 year record of combustion-derived pollution in northern Spain: Tools to identify the Holocene/Anthropocene transition in coastal environments

There is an uneven geographical distribution of historic records of atmospheric pollutants from SW Europe and those that exist are very limited in temporal extent. Alternative data source is required to understand temporal trends in human impacts on atmospheric pollution. Polycyclic aromatic hydrocarbons (PAHs), heavy metal content and stable Pb isotopic ratios in a sediment core from a salt marsh in northern Spain were used to reconstruct the regional history of contaminant inputs over the last 700 years. Pre-1800s concentrations of Pb and PAHs represented baseline concentrations, i.e. pre-Industrial, conditions. During the initial stages of the Industrial Revolution, 1800s to 1860s, PAH concentrations increased by a factor of about two above baseline levels in the sediment column. By the 1930s, PAH levels reached ca. 10 times pre-Industrial levels and, along with Pb, reached a peak at ca. 1975 CE. Since then, sedimentary PAH and Pb concentrations decreased significantly. A combination of PAH isomer and Pb stable isotope ratios suggests that the contaminant sources are regional, likely derived partially from wood, but mainly coal used by the metallurgic industry in the Basque country since the 1800s and until the 1970s when leaded petrol saw increased use. This chronology of regional atmosphere-derived pollution expands current southwest Europe emission records and shows coastal salt marsh sediments to be useful in reconstructing the Anthropocene.

Long-term responses of rainforest erosional systems at different spatial scales to selective logging and climatic change

Long-term (21–30 years) erosional responses of rainforest terrain in the Upper Segama catchment, Sabah, to selective logging are assessed at slope, small and large catchment scales. In the 0.44 km2 Baru catchment, slope erosion measurements over 1990–2010 and sediment fingerprinting indicate that sediment sources 21 years after logging in 1989 are mainly road-linked, including fresh landslips and gullying of scars and toe deposits of 1994–1996 landslides. Analysis and modelling of 5–15 min stream-suspended sediment and discharge data demonstrate a reduction in storm-sediment response between 1996 and 2009, but not yet to pre-logging levels. An unmixing model using bed-sediment geochemical data indicates that 49 per cent of the 216 t km−2 a−1 2009 sediment yield comes from 10 per cent of its area affected by road-linked landslides. Fallout 210Pb and 137Cs values from a lateral bench core indicate that sedimentation rates in the 721 km2 Upper Segama catchment less than doubled with initially highly selective, low-slope logging in the 1980s, but rose 7–13 times when steep terrain was logged in 1992–1993 and 1999–2000. The need to keep steeplands under forest is emphasized if landsliding associated with current and predicted rises in extreme rainstorm magnitude-frequency is to be reduced in scale.

Changes in Sediment Sources following Wildfire in Mountainous Terrain: A Paired–Catchment Approach, British Columbia, Canada

This paper describes a study examining the potential of mineral magnetic, geochemical and organic properties to determine if a 2003 wildfire in a catchment in British Columbia, Canada, caused a change in the sources of the suspended sediment transported in the channel relative to a nearby unburnt (reference) catchment. The results show that some of the properties offer the potential to determine sediment sources in the unburnt catchment. However, the 2003 wildfire modified the concentrations of some properties and this can either compromise or enhance their ability as tracers in the burnt catchment. At present, the source tracing results are inconclusive. This has implications for the use of certain properties as fingerprints and raises important issues about approaches to sediment source identification.

Sediment aggregation and water quality in wildfire-affected river basins

Off-site transfer of nutrient-rich burnt soil has implications for downstream water quality. Coarsening of effective particle size (EPS) distributions in burnt material via aggregation of fines into composite particles modifies post-fire sediment and nutrient transport dynamics. Experiments were undertaken to establish temperature controls on wildfire-enhanced soil aggregation. Burnt and unburnt soil from a temperate eucalypt forest were analysed for EPS and settling velocity using a LISST-ST (Laser In Situ Scatter and Transmissometry with Settling Tube) particle size analyser. Next, samples were burnt (250–550°C) before further analysis with the LISST-ST. Settling velocities of naturally burnt soil aggregates were greater than unburnt aggregates of the same EPS. Experimental burning indicated that dense water-stable aggregates form at relatively low temperatures (250°C) probably due to distillation and carbonisation, through pyrolysis, of organic volatiles in surface litter. Under these conditions, the EPS distribution of burnt surface soil coarsens with up to 50% of the <63-μm fraction becoming aggregated. A positive relationship between ‘plant-available’ phosphorus and burn temperature was observed. Given that a large proportion of soil particulate phosphorus is associated with the <63-μm fraction, fire-related aggregation processes have potentially important implications for post-fire fine sediment and nutrient transport and storage dynamics.

A deconvolutional Bayesian mixing model approach for river basin sediment source apportionment

Increasing complexity in human-environment interactions at multiple watershed scales presents major challenges to sediment source apportionment data acquisition and analysis. Herein, we present a step-change in the application of Bayesian mixing models: Deconvolutional-MixSIAR (D-MIXSIAR) to underpin sustainable management of soil and sediment. This new mixing model approach allows users to directly account for the ‘structural hierarchy’ of a river basin in terms of sub-watershed distribution. It works by deconvoluting apportionment data derived for multiple nodes along the stream-river network where sources are stratified by sub-watershed. Source and mixture samples were collected from two watersheds that represented (i) a longitudinal mixed agricultural watershed in the south west of England which had a distinct upper and lower zone related to topography and (ii) a distributed mixed agricultural and forested watershed in the mid-hills of Nepal with two distinct sub-watersheds. In the former, geochemical fingerprints were based upon weathering profiles and anthropogenic soil amendments. In the latter compound-specific stable isotope markers based on soil vegetation cover were applied. Mixing model posterior distributions of proportional sediment source contributions differed when sources were pooled across the watersheds (pooled-MixSIAR) compared to those where source terms were stratified by sub-watershed and the outputs deconvoluted (D-MixSIAR). In the first example, the stratified source data and the deconvolutional approach provided greater distinction between pasture and cultivated topsoil source signatures resulting in a different posterior distribution to non-deconvolutional model (conventional approaches over-estimated the contribution of cultivated land to downstream sediment by 2 to 5 times). In the second example, the deconvolutional model elucidated a large input of sediment delivered from a small tributary resulting in differences in the reported contribution of a discrete mixed forest source. Overall D-MixSIAR model posterior distributions had lower (by ca 25–50%) uncertainty and quicker model run times. In both cases, the structured, deconvoluted output cohered more closely with field observations and local knowledge underpinning the need for closer attention to hierarchy in source and mixture terms in river basin source apportionment. Soil erosion and siltation challenge the energy-food-water-environment nexus. This new tool for source apportionment offers wider application across complex environmental systems affected by natural and human-induced change and the lessons learned are relevant to source apportionment applications in other disciplines.