William W. Yu

The effect of nanocrystalline magnetite size on arsenic removal

Abstract Higher environmental standards have made the removal of arsenic from water an important problem for environmental engineering. Iron oxide is a particularly interesting sorbent to consider for this application. Its magnetic properties allow relatively routine dispersal and recovery of the adsorbent into and from groundwater or industrial processing facilities; in addition, iron oxide has strong and specific interactions with both As(III) and As(V). Finally, this material can be produced with nanoscale dimensions, which enhance both its capacity and removal. The objective of this study is to evaluate the potential arsenic adsorption by nanoscale iron oxides, specifically magnetite (Fe3O4) nanoparticles. We focus on the effect of Fe3O4 particle size on the adsorption and desorption behavior of As(III) and As(V). The results show that the nanoparticle size has a dramatic effect on the adsorption and desorption of arsenic. As particle size is decreased from 300 to 12 nm the adsorption capacities for both As(III) and As(V) increase nearly 200 times. Interestingly, such an increase is more than expected from simple considerations of surface area and suggests that nanoscale iron oxide materials sorb arsenic through different means than bulk systems. The desorption process, however, exhibits some hysteresis with the effect becoming more pronounced with small nanoparticles. This hysteresis most likely results from a higher arsenic affinity for Fe3O4 nanoparticles. This work suggests that Fe3O4 nanocrystals and magnetic separations offer a promising method for arsenic removal.

Color-Switchable Electroluminescence of Carbon Dot Light-Emitting Diodes

Carbon-dot based light-emitting diodes (LEDs) with driving current controlled color change are reported. These devices consist of a carbon-dot emissive layer sandwiched between an organic hole transport layer and an organic or inorganic electron transport layer fabricated by a solution-based process. By tuning the device structure and the injecting current density (by changing the applied voltage), we can obtain multicolor emission of blue, cyan, magenta, and white from the same carbon dots. Such a switchable EL behavior with white emission has not been observed thus far in single emitting layer structured nanomaterial LEDs. This interesting current density-dependent emission is useful for the development of colorful LEDs. The pure blue and white emissions are obtained by tuning the electron transport layer materials and the thickness of electrode.

Synthesis of monodisperse iron oxide nanocrystals by thermal decomposition of iron carboxylate salts

Iron oxide (Fe(3)O(4), magnetite) nanocrystals of 6 to 30 nm with narrow size distributions (sigma = 5-10%) were prepared by the pyrolysis of iron carboxylate salts.

Biological interactions of quantum dot nanoparticles in skin and in human epidermal keratinocytes

Quantum dots nanoparticles have novel optical properties for biomedical applications and electronics, but little is known about their skin permeability and interaction with cells. QD621 are nail-shaped nanoparticles that contain a cadmium/selenide core with a cadmium sulfide shell coated with polyethylene glycol (PEG) and are soluble in water. QD were topically applied to porcine skin flow-through diffusion cells to assess penetration at 1 microM, 2 microM and 10 microM for 24 h. QD were also studied in human epidermal keratinocytes (HEK) to determine cellular uptake, cytotoxicity and inflammatory potential. Confocal microscopy depicted the penetration of QD621 through the uppermost stratum corneum (SC) layers of the epidermis and fluorescence was found primarily in the SC and near hair follicles. QD were found in the intercellular lipid bilayers of the SC by transmission electron microscopy (TEM). Inductively coupled plasma-optical emission spectroscopy (ICP-OES) analysis for cadmium (Cd) and fluorescence for QD both did not detect Cd nor fluorescence signal in the perfusate at any time point or concentration. In HEK, viability decreased significantly (p<0.05) from 1.25 nM to 10 nM after 24 h and 48 h. There was a significant increase in IL-6 at 1.25 nM to 10 nM, while IL-8 increased from 2.5 nM to 10 nM after 24 h and 48 h. TEM of HEK treated with 10 nM of QD621 at 24 h depicted QD in cytoplasmic vacuoles and at the periphery of the cell membranes. These results indicate that porcine skin penetration of QD621 is minimal and limited primarily to the outer SC layers, yet if the skin were damaged allowing direct QD exposure to skin or keratinocytes, an inflammatory response could be initiated.

Aqueous dispersion of monodisperse magnetic iron oxide nanocrystals through phase transfer

A facile method was developed for completely transferring high quality monodisperse iron oxide nanocrystals from organic solvents to water. The as-prepared aqueous dispersions of iron oxide nanocrystals were extremely stable and could be functionalized for bioconjugation with biomolecules. These iron oxide nanocrystals showed negligible cytotoxicity to human breast cancer cells (SK-BR-3) and human dermal fibroblast cells. This method is general and versatile for many organic solvent-synthesized nanoparticles, including fluorescent semiconductor nanocrystals.

Size-dependent composition and molar extinction coefficient of PbSe semiconductor nanocrystals.

Atomic compositions and molar extinction coefficients of PbSe semiconductor nanocrystals were determined by atomic absorption spectrometry, UV-vis-NIR spectrophotometry, and transmission electron microscopy. The Pb/Se atomic ratio was found to be size-dependent with a systematic excess of Pb atoms in the PbSe nanocrystal system. Experimental results indicated that the individual PbSe nanocrystal was nonstoichiometric, consisting of a PbSe core and an extra layer of Pb atoms. For these nonstoichiometric PbSe semiconductor nanocrystals, we proposed a new computational approach to calculate the total number of Pb and Se atoms in different sized particles. This calculation played a key role on the accurate determination of the strongly size-dependent extinction coefficient, which followed a power law with an exponent of approximately 2.5.

Two-Photon-Pumped Perovskite Semiconductor Nanocrystal Lasers

Two-photon-pumped lasers have been regarded as a promising strategy to achieve frequency up-conversion for situations where the condition of phase matching required by conventional approaches cannot be fulfilled. However, their practical applications have been hindered by the lack of materials holding both efficient two-photon absorption and ease of achieving population inversion. Here, we show that this challenge can be tackled by employing colloidal nanocrystals of perovskite semiconductors. We observe highly efficient two-photon absorption (with a cross section of 2.7 × 10(6) GM) in toluene solutions of CsPbBr3 nanocrystals that can excite large optical gain (>500 cm(-1)) in thin films. We have succeeded in demonstrating stable two-photon-pumped lasing at a remarkable low threshold by coupling CsPbBr3 nanocrystals with microtubule resonators. Our findings suggest perovskite nanocrystals can be used as excellent gain medium for high-performance frequency-up-conversion lasers toward practical applications.

Efficient and Stable White LEDs with Silica‐Coated Inorganic Perovskite Quantum Dots

A white light-emitting diode (0.33, 0.33) is fabricated using perovskite quantum dot/silica composites. It is shown to have greatly improved stability.

Superior Optical Properties of Perovskite Nanocrystals as Single Photon Emitters.

The power conversion efficiency of photovoltaic devices based on semiconductor perovskites has reached ~20% after just several years of research efforts. With concomitant discoveries of other promising applications in lasers, light-emitting diodes and photodetectors, it is natural to anticipate what further excitements these exotic perovskites could bring about. Here we report on the observation of single photon emission from single CsPbBr3 perovskite nanocrystals (NCs) synthesized from a facile colloidal approach. Compared with traditional metal-chalcogenide NCs, these CsPbBr3 NCs exhibit nearly two orders of magnitude increase in their absorption cross sections at similar emission colors. Moreover, the radiative lifetime of CsPbBr3 NCs is greatly shortened at both room and cryogenic temperatures to favor an extremely fast output of single photons. The above findings have not only added a novel member to the perovskite family for the integration into current optoelectronic architectures, but also paved the way towards quantum-light applications of single perovskite NCs in various quantum information processing schemes.The power conversion efficiency of photovoltaic devices based on semiconductor perovskites has reached ∼20% after just several years of research efforts. With concomitant discoveries of other promising applications in lasers, light-emitting diodes, and photodetectors, it is natural to anticipate what further excitement these exotic perovskites could bring about. Here we report on the observation of single photon emission from single CsPbBr3 perovskite nanocrystals (NCs) synthesized from a facile colloidal approach. Compared with traditional metal-chalcogenide NCs, these CsPbBr3 NCs exhibit nearly 2 orders of magnitude increase in their absorption cross sections at similar emission colors. Moreover, the radiative lifetime of CsPbBr3 NCs is greatly shortened at both room and cryogenic temperatures to favor an extremely fast output of single photons. The above superior optical properties have paved the way toward quantum-light applications of perovskite NCs in various quantum information processing schemes.

Facile Synthesis of Tin Oxide Nanoflowers: A Potential High-Capacity Lithium-Ion-Storage Material

A facile and reproducible approach was reported to synthesize nanoparticle-attached SnO nanoflowers via decomposition of an intermediate product Sn6O4(OH)4. Sn6O4(OH)4 formed after introducing water into the traditional nonaqueous reaction, and then decomposed to SnO nanoflowers with the help of free metal cations, such as Sn2+, Fe2+, and Mn2+. This free cation-induced formation process was found independent of the nature of the surface ligand. It was demonstrated further that the as-prepared SnO nanoflowers could be utilized as good anode materials for lithium ion rechargeable batteries with a high capacity of around 800 mA h g(-1), close to the theoretical value (875 mA h g(-1)).