Wu-Er Gan

Mechanism of porous core electroosmotic pump flow injection system and its application to determination of chromium(VI) in waste-water

An electroosmotic pump flow injection system is introduced in this paper. According to electroosmotic theory, the pumps properties were described. A large flow range (mul min(-1)-ml min(-1)), moderate carrier pressure (>0.15 MPa), reduced performance voltage (<500 V) and stable flow rate (RSD<3.0% in 4 h) are the main properties of the pump. NH(4)OH (0.35 mM) was used as carrier for improving the pumps flow stability. The electroosmotic efficiency of the pumps medium, porous core, can be recovered and regenerated. A sandwich zone was used for sample and reagent introduction in order to adapt to the pump performance. Flow injection-spectrophotometry was employed for the determination of Cr(VI) in waste-water, based on the formation of the complex with 1,5-diphenylcarbazide and absorbance measurement at 540 nm. Within the calibration range of 0-7.0 mg l(-1) of Cr(VI), the RSD was 0.4% (n=5). The recovery of 0.70 mg l(-1) Cr(VI) added to the waste-water sample was 94.5+/-2.0% (n=5).

Determination of kanamycin A, amikacin and tobramycin residues in milk by capillary zone electrophoresis with post-column derivatization and laser-induced fluorescence detection.

An analytical method for kanamycin A, amikacin and tobramycin of aminoglycoside (AG) antibiotics in milk samples was proposed using capillary zone electrophoresis (CZE) with post-column derivatization and laser-induced fluorescence detection. A simple and convenient homemade coaxial-gap reactor was adopted in the post-column derivatization of the AGs with 1.0 mmol/L naphthalene-2,3-dicarboxaldehyde and 8.0 mmol/L 2-mercaptoethanol in 35 mmol/L sodium tetraborate buffer (pH 10.0) of 30% (v/v) methanol. 50 mmol/L sodium acetate (pH 5.0) containing 0.5 mmol/L cetyltrimethyl ammonium bromide was used as the separation buffer. The linear calibration concentrations and detection limits were from 2.1 x 10(-5) to 5.0 x 10(-2)g/L and in the range of 7 x 10(-6) to 2 x 10(-5)g/L, respectively. The recoveries of the AGs in milk samples were from 81.6 to 93.1% (n=3).

Determination of benzoic acid and sorbic acid in food products using electrokinetic flow analysis–ion pair solid phase extraction–capillary zone electrophoresis

An electrokinetic flow analysis system (EFA), consisting of one electroosmotic pump, five solenoid valves and one on-line homemade solid phase extraction (SPE) unit, combined with capillary zone electrophoresis (CZE) was proposed to determine benzoic acid and sorbic acid in food products. Tetrabutylammonium bromide (TBAB) was adopted as an ion pair reagent to improve the retention of the preservatives on C(8)-bonded silica sorbent, which was also used to remove sample matrices. By using the SPE unit, the EFA-SPE-CZE system was able to perform the SPE operation and CZE separation simultaneously. With a modified interface of EFA and CZE, the buffer consumption was reduced to 130 microL for each running. The preservatives were separated and determined under optimized conditions with p-hydroxybenzoic acid as an internal standard. The relative standard deviation (R.S.D.) of peak area for each analyte was less than 3.1% (n=5) and the limits of detection (LODs) ranged from 10 to 20 ngmL(-1) (K=3, n=11).

On-column liquid–liquid–liquid microextraction coupled with base stacking as a dual preconcentration method for capillary zone electrophoresis

A simple and efficient dual preconcentration method of on-column liquid-liquid-liquid microextraction (LLLME) coupled with base stacking was developed for capillary zone electrophoresis (CZE) in this paper. Four N-methyl carbamates were used as target compounds to evaluate the enrichment means. The carbamates in sample solutions (donor phase) were extracted into a dodecanol phase immobilized on a porous hollow fiber, hydrolyzed and back extracted into 0.20 microL running buffer (acceptor phase) of 30 mmol/L methylamine hydrochloride (pH 11.6) containing 0.5 mmol/L tetradecyltrimethylammonium bromide inside the hollow fiber, stacked further with 0.5 mol/L NaOH injected at -10 kV for 60s, and separated by CZE. Analytical parameters affecting the LLLME, base stacking and CZE were investigated, including sample solution volume, pH and temperature, extraction time, stirring rate, buffer component, buffer pH, NaOH concentration, stacking time, etc. The enrichment factors of the carbamates were higher than 1100. The relative standard deviation (RSD) of peak height and limits of detection (LODs) were 4.5-5.5% (n=6) and 2-4 ng/mL (S/N=3) for standard solutions, respectively. The proposed method was applied to the analysis of vegetable and fruit samples with the RSD less than 6.0% (n=3) and LODs of 6-10 ng/g (S/N=3). The calibration solutions were prepared by diluting the stock solutions with blank sample solutions, and the calibration concentrations ranged from 0.012 to 1.0 microg/mL (r>0.9951). The analytical results demonstrated that the LLLME coupled with base stacking was a simple, convenient and reliable on-column sample pretreatment method for the analysis of anionic analytes in CZE.

Determination of preservatives by integrative coupling method of headspace liquid-phase microextraction and capillary zone electrophoresis

An integrative coupling method of headspace liquid-phase microextraction (HS-LPME) and capillary zone electrophoresis (CZE) was proposed in this paper. In the method, a separation capillary was used to create a microextraction droplet of the running buffer solution of CZE, hold the droplet at the capillary inlet, extract analytes of sample solutions in the headspace of a sample vial, inject concentrated analytes into the capillary and separate the analytes by CZE. The proposed method was applied to determine the preservatives of benzoic acid and sorbic acid in soy sauce and soft drink samples, in which the running buffer solution of 50 mmol/L tetraborate (pH 9.2) was directly used to form the acceptor droplet at the capillary inlet by pressure, and the preservatives in a 6-mL sample solution containing 0.25 g/mL NaCl were extracted at 90°C for 30 min in the headspace of a 14-mL sample vial. Then the concentrated preservatives were injected into the capillary at 10 cm height difference for 20 s and separated by CZE. The enrichment factors of benzoic acid and sorbic acid achieved 266 and 404, and the limits of detection (LODs) were 0.03 and 0.01 μg/mL (S/N=3), respectively. The recoveries were in the range of 88.7-105%. The integrative coupling method of HS-LPME and CZE was simple, convenient, reliable and suitable for concentrating volatile and semi-volatile organic acids and eliminating matrix interferences of real samples.

On-line sample digestion using an electromagnetic heating column for the determination of zinc and manganese in tea leaf by flame atomic absorption spectrometry

A new on-line sample digestion system using electromagnetic induction heating technique was developed for the determination of zinc and manganese in tea leaf by flame atomic absorption spectrometry (FAAS). The homemade electromagnetic heating column (EMHC), whose effective diameter was about 1mm, was composed of a polytetrafluoroethylene (PTFE) outer tube and seven compactly packed PTFE coil-coated iron wires. The pre-digested sample solution was pumped through EMHC and then transferred directly to FAAS for determination. An analytical throughput of 72samplesh(-1) was obtained in the present system. Under optimal condition, the detection limits (3sigma) of zinc and manganese were 4.2mugL(-1) and 3.0mugL(-1), along with relative standard deviations (R.S.D.) of 3.2% and 3.6% respectively for zinc and manganese. Certified reference materials GBW 07602, GBW 07605 and GBW 08505 were analyzed to validate the proposed method, good agreement was achieved between the certified values and the obtained results.

Determination of chromium(VI) and lead(II) in drinking water by electrokinetic flow analysis system and graphite furnace atomic absorption spectrometry

An electrokinetic flow analysis system (EKFA) using an electroosmotic pump (Peo) and a bi-directional electrostacking (BDES) unit is introduced in this paper. Large flow range, moderate carrier pressure, low performance voltage and stable flow rate, especially in mulmin(-1) level, are the main specialties of the Peo. Diethanolamine, 0.5 mM, is selected as its carrier to improve the pump efficiency and stability further. Moreover, BDES, a feasibility investigation for the simultaneous separation and pre-concentration of cations and anions, and graphite furnace atomic absorption spectrometry (GFAAS) determination are presented. The calibration series for both of Cr(VI) and Pb(II) are from 0.2 to 40 mugl(-1) with 10 mul pipette volume and GFAAS determination directly. The detection limit of Cr(VI) and Pb(II) with 10 min BDES is 10 and 13 ngl(-1)(3sigma of blank, n=11), respectively. The recovery of Cr(VI) and Pb(II) is (103-105)+/-1% and (95.9-96.9)+/-1.0% with three independent determinations, respectively. The investigated method is also suitable for the simultaneous separation and pre-concentration of trace cations and anions in low conductivity sample solutions with different detection instruments.

In-line coupling headspace liquid-phase microextraction with capillary electrophoresis

An analytical technique of in-line coupling headspace liquid-phase microextraction (HS-LPME) with capillary electrophoresis (CE) was proposed to determine volatile analytes. A special cover unit of the sample vial was adopted in the coupling method. To evaluate the proposed method, phenols were used as model analytes. The parameters affecting the extraction efficiency were investigated, including the configuration of acceptor phase, kind and concentration of acceptor solution, extraction temperature and time, salt-out effect, sample volume, etc. The optimal enrichment factors of HS-LPME were obtained with the sample volume of about half of sample vials, which were confirmed by both the theoretical prediction and experimental results. The enrichment factors were obtained from 520 to 1270. The limits of detection (LODs, S/N=3) were in the range from 0.5 to 1 ng/mL each phenol. The recoveries were from 87.2% to 92.7% and the relative standard deviations (RSDs) were lower than 5.7% (n=6). The proposed method was successfully applied to the quantitative analysis of the phenols in tap water, and proved to be a simple, convenient and reliable sample preconcentration and determination method for volatile analytes in water samples.

Determination of nitrite by sequential injection analysis of electrokinetic flow analysis system.

A new sequential injection analysis (SIA) method of an electrokinetic flow analysis (EKFA) system for the determination of nitrite-nitrogen is presented in this paper. The proposed system mainly consisted of an electroosmotic pump, two solenoid valves and a spectrophotometer etc. All the pump and valves were controlled by a personal computer automatically. The determination method of nitrite-nitrogen was based on the reaction among nitrite, sulfanilamide and naphthylethylenediamine to form a colored compound, which was measured at 540 nm. The linear calibration range of nitrite-nitrogen was 10-800 mug l(-1). The detection limit was 1 mug l(-1) (K=3, n=11). The analytical method can provide a throughput of 33 samples per h.

Electrochemical hydride generation atomic fluorescence spectrometry for detection of tin in canned foods using polyaniline-modified lead cathode

An electrochemical hydride generation system with polyaniline-modified lead cathode was developed for tin determination by coupling with atomic fluorescence spectrometry. The tin fluorescence signal intensity was improved evidently as the polyaniline membrane could facilitate the transformation process from atomic tin to the SnH(4) and prevent the aggradation of Sn atom on Pb electrode surface. The effects of experimental parameters and interferences have been studied. The limit of detection (LOD) was 1.5 ng mL(-1) (3σ) and the relative standard deviation (RSD) was 3.3% for 11 consecutive measurements of 50 ng mL(-1) Sn(IV) standard solution.