Xiao-kun OuYang

Composition and anti-inflammatory effect of polysaccharides from Sargassum horneri in RAW264.7 macrophages

Sulfated polysaccharides extracted from brown marine algae have been shown to possess a variety of biological activities. We assessed the potential activity of the sulfated polysaccharide from Sargassum horneri (SP) and its isolated two major components (fraction-1 (F1) and fraction-2 (F2)), on anti-inflammatory activity in lipopolysaccharide (LPS)-stimulated RAW264.7 macrophages. In the present study, analysis of polysaccharide chemical composition found that the constituent ratios of sulfate ester and fucose in SP and F1 were 4.95% vs 7.6%, and 4.48% vs 55.9%, respectively, suggesting that F1 may be a major sulfated polysaccharide containing fucose. Meanwhile, our findings demonstrated that TNF-α secretion levels were significantly (P<0.05) decreased by SP and F1 treatments in LPS-stimulated RAW264.7 cells in a dose-dependent manner under the preventive and repair experimental models. Pro-/anti-inflammatory (TNF-α/IL-10) cytokines secretion ratios by LPS-stimulated RAW264.7 macrophages were significantly (P<0.05) inhibited by SP and F1 treatments, particularly by F1 (at high dose, 200μg/ml). Moreover, NO release and iNOS activity were significantly (P<0.05) inhibited by F1. Collectively, the present study suggested that purified component, F1 from SP, had strong anti-inflammatory effects on LPS-stimulated RAW264.7 macrophages in the preventive and repair manner through inhibiting TNF-α secretion levels and NO release.

Chitosan Nanoparticles Attenuate Hydrogen Peroxide-Induced Stress Injury in Mouse Macrophage RAW264.7 Cells

This study was carried out to investigate the protective effects of chitosan nanoparticles (CNP) against hydrogen peroxide (H2O2)-induced oxidative damage in murine macrophages RAW264.7 cells. After 24 h pre-incubation with CNP (25–200 μg/mL) and chitosan (CS) (50–200 μg/mL, as controls), the viability loss in RAW264.7 cells induced by H2O2 (500 μM) for 12 h was markedly restored in a concentration-dependent manner as measured by MTT assay (P < 0.05) and decreased in cellular LDH release (P < 0.05). Moreover, CNP also exerted preventive effects on suppressing the production of lipid peroxidation such as malondialdehyde (MDA) (P < 0.05), restoring activities of endogenous antioxidant including superoxide dismutase (SOD), and glutathione peroxidase (GSH-Px) (P < 0.05), along with increasing total antioxidant capacity (T-AOC) (P < 0.05). In addition, pre-incubation of CNP with RAW264.7 cells for 24 h resulted in the increase of the gene expression level of endogenous antioxidant enzymes, such as MnSOD and GSH-Px (P < 0.05). At the same concentration, CNP significantly decreased LDH release and MDA (P < 0.05) as well as increased MnSOD, GSH-Px, and T-AOC activities (P < 0.05) as compared to CS. Taken together, our findings suggest that CNP can more effectively protect RAW264.7 cells against oxidative stress by H2O2 as compared to CS, which might be used as a potential natural compound-based antioxidant in the functional food and pharmaceutical industries.

Surface-Imprinted Magnetic Carboxylated Cellulose Nanocrystals for the Highly Selective Extraction of Six Fluoroquinolones from Egg Samples

We herein describe a novel adsorbent based on molecularly imprinted polymers (MIPs) on the surface of magnetic carboxylated cellulose nanocrystals (Fe3O4@CCNs@MIPs) for the separation and purification of six fluoroquinolones (FQs) from egg samples. The obtained Fe3O4@CCNs@MIPs not only exhibited a large surface area and specific recognition toward FQs, but also were easily gathered and separated from the egg samples using an external magnetic field. The morphologies and surface groups of the Fe3O4@CCNs@MIPs were assessed by X-ray photoelectron spectroscopy, transmission electron microscopy, vibrating sample magnetometry, X-ray diffraction, thermogravimetric analysis, Fourier transform infrared spectroscopy, and Brunauer-Emmett-Teller surface area analysis. The Fe3O4@CCNs@MIPs exhibited high selectivity toward six structurally similar FQs. An enrichment approach was established for the measurement of six FQs from egg samples using Fe3O4@CCNs@MIPs coupled to high-performance liquid chromatography. The recovery of spiked FQs ranged from 75.2-104.9% and limit of detection was in the range of 3.6-18.4 ng g-1 for the six FQs. Therefore, the proposed method is a promising technique for the enrichment, separation, and determination of FQs from biomatrices.

Adsorption of Pb(II) from fish sauce using carboxylated cellulose nanocrystal: Isotherm, kinetics, and thermodynamic studies

In the present study, a new adsorbent based on carboxylated cellulose nanocrystal (CCN) was developed for the adsorption of Pb(II) from fish sauce. The prepared adsorbent material was characterized by zeta potential, FT-IR, XRD, and XPS tools. The changes in the morphological structure of the developed CCN surface were evidenced by SEM and TEM. The favorable adsorption conditions were selected by studying the contact time, initial concentration, temperature, and concentration of the used glutamic acid and NaCl. The results indicated that the Langmuir isotherm model agrees very well with experimental adsorption data (R2=0.9962) with a maximum adsorption capacity 232.56mg/g of Pb(II) at 293.2K. Additionally, data of the adsorption kinetics follow the pseudo-second-order kinetics (R2>0.9990). On the other hand, the thermodynamics studies show that the adsorption process is spontaneous and endothermic. Furthermore, the developed CCN could be regenerated using acid treatment with a good reusability for Pb(II) adsorption. The results clearly indicated that the synthesized CCN could be effectively applied as a new material for Pb(II) adsorption from fish sauce solutions.

Adsorptive removal of cationic methylene blue dye using carboxymethyl cellulose/k-carrageenan/activated montmorillonite composite beads: Isotherm and kinetic studies

In the present study, new composite beads based on carboxymethyl cellulose (CMC)/k-carrageenan (kC)/activated montmorillonite (AMMT) were prepared for adsorptive removal of cationic methylene blue (MB) as a dye model. The structure and morphology of the composite beads were investigated by FT-IR and SEM, while the thermal properties were tested using TGA. Factors affecting the removal percent of MB such as CMC/kC/AMMT ratios, initial MB concentration, pH medium, adsorbent dosage, solution temperature, and agitation speed were also explored. Results demonstrated that MB removal (%) exceeded 92% after 120 min using CMC/kC/AMMT (1:1:0.4 ratio) compared to 69% in case of free AMMT beads. Moreover, data obtained from isotherm studies were fitted well to Langmuir model (R2=0.999), and the kinetics of adsorption followed pseudo-second order model. Finally, the composite beads showed good reusability for MB dye removal with high efficiency. Results obtained from this study suggest that the prepared composite beads could be applied effectively for removing cationic dyes from aqueous solutions.

Partially Hydrolyzed Bamboo (Phyllostachys heterocycla) As a Porous Bioadsorbent for the Removal of Pb(II) from Aqueous Mixtures

A novel porous succinylated bioadsorbent was prepared by the partial enzymatic hydrolysis of bamboo (Phyllostachys heterocycla) and its subsequent modification with succinic anhydride. Pb(II) removal from solutions that also contained sodium chloride and an amino acid was investigated using the bioadsorbent. Enzymatic hydrolysis increased the number of accessible hydroxyl groups and surface area of the raw bamboo, and created many pores within the material. The porous succinylated bioadsorbent exhibited high efficiency for Pb(II) binding. The sodium chloride content significantly decreased the Pb(II) adsorption capacity, whereas a minor effect was observed in the presence of arginine. The experimental data could be accurately described by a pseudo-second-order kinetics model, and the adsorption proceeded via an ion exchange mechanism. Even in a solution containing sodium chloride and arginine, the maximum adsorption capacity of Pb(II) by the porous succinylated bioadsorbent was 99.5 mg/g at 303 K.

Bamboo-derived porous bioadsorbents and their adsorption of Cd(II) from mixed aqueous solutions

Two porous bioadsorbents were successfully prepared from the partial enzymatic hydrolysis of bamboo and subsequent chemical modification with succinic anhydride. We investigated the abilities of the partially enzymatically hydrolyzed bamboo (PEB) and the porous succinylated bamboo (PSB) to adsorb Cd(II) from a solution containing sodium chloride and an amino acid. The partial enzymatic hydrolysis created many pores within the raw bamboo, and both the porous structure and the post-succinylation carboxyl group content were important for high adsorption capacity. The presence of sodium chloride and the amino acid markedly decreased the adsorption capacities of the bioadsorbents. The experimental data could be described perfectly with the Langmuir adsorption isotherm model and pseudo second-order kinetics model. Even in solutions containing sodium chloride and arginine, the maximum Cd(II) adsorption capacities at 303 K were 38.18 and 120.34 mg g−1 for PEB and PSB, respectively.

Synthesis and Characterization of Magnetic Molecularly Imprinted Polymer for the Enrichment of Ofloxacin Enantiomers in Fish Samples

A new method for the isolation and enrichment of ofloxacin enantiomers from fish samples was developed using magnetic molecularly imprinted polymers (MMIPs). These polymers can be easily collected and rapidly separated using an external magnetic field, and also exhibit a high specific recognition for ofloxacin enantiomers. The preparation of amino-functionalized MMIPs was carried out via suspension polymerization and a ring-opening reaction using rac-ofloxacin as a template, ethylenediamine as an active group, glycidyl methacrylate and methyl methacrylate as functional monomers, divinylbenzene as a cross-linker, and Fe3O4 nanoparticles as magnetic cores. The characteristics of the MMIPs were assessed using transmission electron microscopy (TEM), X-ray powder diffraction (XRD), Fourier-transform infrared spectroscopy (FT-IR), and vibrating sample magnetometer (VSM) measurements. Furthermore, the adsorption properties were determined using Langmuir and Freundlich isotherm models. The conditions for use of these MMIPs as magnetic solid-phase extraction (MSPE) sorbents, including pH, adsorption time, desorption time, and eluent, were investigated in detail. An extraction method using MMIPs coupled with high performance liquid chromatography (HPLC) was developed for the determination of ofloxacin enantiomers in fish samples. The limits of quantitation (LOQ) for the developed method were 0.059 and 0.067 μg∙mL−1 for levofloxacin and dextrofloxacin, respectively. The recovery of ofloxacin enantiomers ranged from 79.2% ± 5.6% to 84.4% ± 4.6% and ofloxacin enantiomers had good linear relationships within the concentration range of 0.25–5.0 μg∙mL−1 (R2 > 0.999). The obtained results demonstrate that MSPE-HPLC is a promising approach for preconcentration, purification, and simultaneous separation of ofloxacin enantiomers in biomatrix samples.

Enzymatic approaches to the preparation of chiral epichlorohydrin

Enantiomerically pure epichlorohydrin is a key chiral synthon in the preparation of 4-chloro-3-hydroxybutyrate, pheromones, L-carnitine, and β-adrenergic blockers. Various methods are known for obtaining the enantiomerically pure epoxides, including chemical and enzymatic approaches, but a clear understanding of the synthesis process in case of chiral epichlorohydrin is unavailable. This review gives an overview of the enzymatic approaches for preparation of the chiral epichlorohydrin, highlighting the synthetic routes using haloalcohol dehalogenase and epoxide hydrolase as biocatalysts.

Fabrication of Composite Beads Based on Calcium Alginate and Tetraethylenepentamine-Functionalized MIL-101 for Adsorption of Pb(II) from Aqueous Solutions

In this work, a tetraethylenepentamine (TEPA)-grafted metal-organic framework material (MIL-101) was synthesized. The introduction of TEPA increased the abundance of functional groups on the MIL-101. As a powdery adsorbent, MIL-101-TEPA can be difficult to separate. In order to solve this problem, we combined MIL-101-TEPA with sodium alginate (SA) and injected the mixture into a CaCl2 solution to solidify the powder into beads with a particle size of 3 mm. The easily recovered adsorbent was applied to the adsorption of Pb(II) from water. The structure and characterization of the adsorbent were investigated through scanning electron microscope (SEM), Fourier-transform infrared spectroscopy (FTIR), X-Ray diffraction (XRD), thermogravimetric analysis (TGA), and X-ray photoelectron spectroscopy (XPS). We also optimized the adsorption conditions. The results of the study showed that the adsorption process was chemisorptive and endothermic in nature. The maximum adsorption capacity of the composite beads was 558.6 mg/g. Meanwhile MIL-101-TEPA@CA showed good repeatable utilization.