Xiaoming Yuan

Tunable Polarity in a III–V Nanowire by Droplet Wetting and Surface Energy Engineering

Controllable axial switching of polarity in GaAs nanowires with minimal tapering and perfect twin-free ZB structure based on the fundamental understanding of nanowire growth and kinking mechanism is presented. The polarity of the bottom segment is confirmed to be (111)A by atomically resolved scanning transmission electron microscopy.

Room temperature GaAsSb single nanowire infrared photodetectors

Antimonide-based ternary III-V nanowires (NWs) allow for a tunable bandgap over a wide range, which is highly interesting for optoelectronics applications, and in particular for infrared photodetection. Here we demonstrate room temperature operation of GaAs0.56Sb0.44 NW infrared photodetectors grown by metal organic vapor phase epitaxy. These GaAs0.56Sb0.44 NWs have uniform axial composition and show p-type conductivity with a peak field-effect mobility of ∼12 cm(2) V(-1) s(-1)). Under light illumination, single GaAs0.56Sb0.44 NW photodetectors exhibited typical photoconductor behavior with an increased photocurrent observed with the increase of temperature owing to thermal activation of carrier trap states. A broadband infrared photoresponse with a long wavelength cutoff at ∼1.66 μm was obtained at room temperature. At a low operating bias voltage of 0.15 V a responsivity of 2.37 (1.44) A/W with corresponding detectivity of 1.08 × 10(9) (6.55 × 10(8)) cm√Hz/W were achieved at the wavelength of 1.3 (1.55) μm, indicating that ternary GaAs0.56Sb0.44 NWs are promising photodetector candidates for small footprint integrated optical telecommunication systems.

Controlling the morphology, composition and crystal structure in gold-seeded GaAs1−xSbx nanowires

While III-V binary nanowires are now well controlled and their growth mechanisms reasonably well understood, growing ternary nanowires, including controlling their morphology, composition and crystal structure remains a challenge. However, understanding and control of ternary alloys is of fundamental interest and critical to enable a new class of nanowire devices. Here, we report on the progress in understanding the complex growth behaviour of gold-seeded GaAs1-xSbx nanowires grown by metalorganic vapour phase epitaxy. The competition between As and Sb atoms for incorporation into the growing crystal leads to a tunability of the Sb content over a broad range (x varies from 0.09 to 0.6), solely by changing the AsH3 flow. In contrast, changing TMSb flow is more effective in affecting the morphology and crystal structure of the nanowires. Inclined faults are found in some of these nanowires and directly related to the kinking of the nanowires and controlled by TMSb flow. Combined with the observed sharp increase of wetting angle between the Au seed and nanowire, the formation of inclined faults are attributed to the Au seed being dislodged from the growth front to wet the sidewalls of the nanowires, and are related to the surfactant role of Sb. The insights provided by this study should benefit future device applications relying on taper- and twin-free ternary antimonide III-V nanowire alloys and their heterostructures.

Design and Room-Temperature Operation of GaAs/AlGaAs Multiple Quantum Well Nanowire Lasers

We present the design and room-temperature lasing characteristics of single nanowires containing coaxial GaAs/AlGaAs multiple quantum well (MQW) active regions. The TE01 mode, which has a doughnut-shaped intensity profile and is polarized predominantly in-plane to the MQWs, is predicted to lase in these nanowire heterostructures and is thus chosen for the cavity design. Through gain and loss calculations, we determine the nanowire dimensions required to minimize loss for the TE01 mode and determine the optimal thickness and number of QWs for minimizing the threshold sheet carrier density. In particular, we show that there is a limit to the minimum and maximum number of QWs that are required for room-temperature lasing. Based on our design, we grew nanowires of a suitable diameter containing eight uniform coaxial GaAs/AlGaAs MQWs. Lasing was observed at room temperature from optically pumped single nanowires and was verified to be from TE01 mode by polarization measurements. The GaAs MQW nanowire lasers have a threshold fluence that is a factor of 2 lower than that previously demonstrated for room-temperature GaAs nanowire lasers.

Growth and optical properties of InxGa1−xP nanowires synthesized by selective-area epitaxy

Ternary III–V nanowires (NWs) cover a wide range of wavelengths in the solar spectrum and would greatly benefit from being synthesized as position-controlled arrays for improved vertical yield, reproducibility, and tunable optical absorption. Here, we report on successful selective-area epitaxy of metal-particle-free vertical InxGa1−xP NW arrays using metal–organic vapor phase epitaxy and detail their optical properties. A systematic growth study establishes the range of suitable growth parameters to obtain uniform NW growth over a large array. The optical properties of the NWs were characterized by room-temperature cathodoluminescence spectroscopy. Tunability of the emission wavelength from 870 nm to approximately 800 nm was achieved. Transmission electron microscopy and energy dispersive X-ray measurements performed on cross-section samples revealed a pure wurtzite crystal structure with very few stacking faults and a slight composition gradient along the NW growth axis.

Thermodynamic modeling of the Sc-Zn system coupled with first-principles calculation

The Sc-Zn system has been critically reviewed and assessed by means of CALPHAD (CALculation of PHAse Diagram) approach. By means of first-principles calculation, the enthalpies of formation at 0 K for the ScZn, ScZn2, Sc17Zn58, Sc3Zn17 and ScZn12 have been computed with the desire to assist thermodynamic modeling. A set of self-consistent thermodynamic parameters for the Sc-Zn system is then obtained. The calculated phase diagram and thermodynamic properties agree well with the experimental data and first-principles calculations, respectively.

Single nanowire green InGaN/GaN light emitting diodes

Single nanowire (NW) green InGaN/GaN light-emitting diodes (LEDs) were fabricated by top-down etching technology. The electroluminescence (EL) peak wavelength remains approximately constant with an increasing injection current in contrast to a standard planar LED, which suggests that the quantum-confined Stark effect is significantly reduced in the single NW device. The strain relaxation mechanism is studied in the single NW LED using Raman scattering analysis. As compared to its planar counterpart, the EL peak of the NW LED shows a redshift, due to electric field redistribution as a result of changes in the cavity mode pattern after metallization. Our method has important implication for single NW optoelectronic device applications.

Growth and characterization of GaAs 1−x Sb x nanowires

We report the structural and optical characterization of GaAs1-xSbx nanowires (NWs) grown on GaAs (111)B substrates using metalorganic chemical vapour deposition (MOCVD). The NWs are perpendicular to the substrate with almost defect-free zinc blende (ZB) structure. Micro-photoluminescence results demonstrate high emission efficiency at around 1.3 μm from the NWs.