Xuwei Li

Behavior of fiber glass bolts, rock bolts and cable bolts in shear

This paper experimentally compares the shear behavior of fiber glass (FG) bolt, rock bolt (steel rebar bolt) and cable bolt for the bolt contribution to bolted concrete surface shear strength, and bolt failure mode. Two double shear apparatuses of different size were used for the study. The tensile strength, the shear strength and the deformation modulus of bolt control the shear behavior of a sheared bolted joint. Since the strength and deformation modulus of FG bolt, rock bolt and cable bolt obtained from uniaxial tensile tests are different, their shear behavior in reinforcing joints is accordingly different. Test results showed that the shear stiffness of FG bolted joints decreased gradually from the beginning to end, while the shear stiffness of joints reinforced by rock bolt and cable bolt decreased bi-linearly, which is clearly consistent with their tensile deformation modulus. The bolted joint shear stiffness was highly influenced by bolt pretension in the high stiffness stage for both rock bolt and cable bolt, but not in the low stiffness stage. The rock bolt contribution to joint shear strength standardised by the bolt tensile strength was the largest, followed by cable bolts, then FG bolts. Both the rock bolts and cable bolts tended to fail in tension, while FG bolts in shear due to their low shear strength and constant deformation modulus.

A New Equation for the Shear Strength of Cable Bolts Incorporating the Energy Balance Theory

The application of cable bolts as a secondary support system is an increasing trend in underground coal mines worldwide. The performances of cable bolts have been evaluated under both axial and shear loading conditions. Two methods of testing cables for shear, single and double shear, have been recognised. This paper examines the shear behaviour of a variety of cable bolts under different pre-tension loads by double shear testing. Plain, spiral and the combination of both cable types were used in this study. The initial axial load and the type of cable bolts are the main factors affecting their shear strength. By increasing the axial pre-tension load, the peak shear load occurs at lower shear displacement. The failure angle due to cable bending across the joint at different pre-tension loads varied between 41° and 49°. This demonstrates that the ratio of axial and perpendicular displacements is almost constant and on average the failure occurs at about 45°. A novel analytical model is proposed to evaluate the shear behaviour of pre-tensioned fully grouted cable bolts subjected to double shearing. Energy and Fourier Series methods were incorporated in the model to simulate the shear behaviour of cable bolts. The comparison of the experimental results with the proposed model shows a good agreement.