Yahe Zhang

Characterization of sulfide compounds in petroleum: selective oxidation followed by positive-ion electrospray Fourier transform ion cyclotron resonance mass spectrometry.

A novel analytical method for identifying sulfides in petroleum and its fractions was developed. Sulfides in petroleum were selectively oxidized into sulfoxides using tetrabutylammonium periodate (TBAPI) and identified by positive-ion electrospray ionization (ESI) Fourier transform-ion cyclotron resonance mass spectrometry (FT-ICR MS). A variety of model sulfur compounds were examined to evaluate the selective oxidization and ionization efficiencies for sulfur compounds in petroleum. Two fractions, straight-run diesel and saturates of Athabasca oilsands bitumen were investigated using this approach. The oxidization process was highly selective for sulfides from thiophenes and aromatic hydrocarbons. Oxidation generated sulfoxides were ionized by positive-ion ESI and analyzed by FT-ICR MS. Mass spectra revealed the composition characteristics of sulfides in the diesel by contrasting the double bond equivalence (DBE) and carbon number distribution of sulfur compounds before and after oxidation. The abundant sulfides in the straight run diesel and saturates fraction of oilsands bitumen had DBE values of 1-3 and 1-4, respectively.

Study on Transformation of Natural Organic Matter in Source Water during Chlorination and Its Chlorinated Products using Ultrahigh Resolution Mass Spectrometry

Natural organic matter (NOM) can affect the performance of water treatment processes, and serves as a main precursor for the formation of disinfection byproduct (DBPs) during chlorination. To minimize such undesirable effects, a better understanding of its structural information and reactivity toward chlorine is necessary. In this study, electrospray ionization coupled to Fourier transform ion cyclotron resonance mass spectrometry (ESI FT-ICR MS) was used to study the molecular composition of NOM in source water. More than four thousand NOM components were resolved in the sample. NOM molecules with a low degree of oxidation (low O/C ratio) were found to be more reactive toward chlorine than those with high O/C ratio. Totally, 659 one-chlorine containing products and 348 two-chlorine containing products were detected in the chlorinated sample at a high confidence level. The chlorinated products can be arranged into series, which indicate they were originated from precursor compounds in series related by the replacement of CH(4) against oxygen. Of the 1007 chlorine-containing products observed in this study, only 7 molecular formulas can be found in previous studies, showing the distinct difference from previous studies. This study explored the reactivity of NOM toward chlorine on a molecular level, which was previously explained on the level of whole mixtures or fractions of NOM, and the identified chlorinated products may contribute to our knowledge of the unknown total organic halide (TOX).

Characterization of low molecular weight dissolved natural organic matter along the treatment trait of a waterworks using Fourier transform ion cyclotron resonance mass spectrometry

Dissolved natural organic matter (DOM), particularly the low molecular weight DOM, can affect the performance of water treatment processes and serve as a main precursor of disinfection by-products (DBPs) during chlorination. In this study, electrospray ionization coupled to Fourier transform ion cyclotron resonance mass spectrometry (ESI FT-ICR MS) was used to characterize the low molecular weight DOM along the treatment trait of a conventional drinking water treatment plant. The ESI FT-ICR MS data showed that various C, H, O-only class species were the major components in the source water. According to the van Krevelen diagram analysis, lignin- and tannin-like compounds were the most abundant components. Within an isobaric group, the DOM molecules with a high degree of oxidation (high O/C value) were preferentially removed during coagulation, while those with low degree of oxidation were found to be more reactive toward chlorine. In addition, 357 one-chlorine containing products and 199 two-chlorine containing products formed during chlorination were detected in the chlorination effluent sample at a high confidence level. The chlorinated products can be arranged into series, suggesting that they were originated from C, H, O-only precursor compounds, which were in series related by the replacement of CH(4) against oxygen. For the first time, this study explored the behavior of low molecular weight DOM along a drinking water treatment trait on the molecular level, and revealed the presence of abundant unknown chlorinated products, which are probably rich in carboxylic and phenolic groups, in drinking water.

Analysis of saturated hydrocarbons by redox reaction with negative-ion electrospray Fourier transform ion cyclotron resonance mass spectrometry.

A novel technique was developed for characterization of saturated hydrocarbons. Linear alkanes were selectively oxidized to ketones by ruthenium ion catalyzed oxidation (RICO). Branched and cyclic alkanes were oxidized to alcohols and ketones. The ketones were then reduced to alcohols by lithium aluminum hydride (LiAlH(4)). The monohydric alcohols (O(1)) in the products obtained from the RICO and RICO-LiAlH(4) reduction reactions were characterized using negative-ion electrospray ionization (ESI) Fourier transform ion cyclotron resonance mass spectrometry (FTICR MS) for identification of iso-paraffins, acyclic paraffins and cyclic paraffins. Various model saturated compounds were used to determine the RICO reaction and ionization selectivity. The results from the FTICR MS analysis on the petroleum distillates derived saturated fraction were in agreement with those from field ionization gas chromatography time-of-flight mass spectrometry (FI GC-TOF MS) analysis. The technique was also used to characterize a petroleum vacuum residue (VR) derived saturates. The results showed that the saturated molecules in the VR contained up to 11 cyclic rings, and the maximum carbon number was up to 92.

Characterization of Unknown Brominated Disinfection Byproducts during Chlorination Using Ultrahigh Resolution Mass Spectrometry

Brominated disinfection byproducts (Br-DBPs), formed from the reaction of disinfectant(s) with natural organic matter in the presence of bromide in raw water, are generally more cytotoxic and genotoxic than their chlorinated analogues. To date, only a few Br-DBPs in drinking water have been identified, while a significant portion of Br-DBPs in drinking water is still unknown. In this study, negative ion electrospray ionization ultrahigh resolution Fourier transform ion cyclotron resonance mass spectrometry (ESI FT-ICR MS) was used to characterize unknown Br-DBPs in artificial drinking water. In total, 441 formulas for one-bromine-containing products and 37 formulas for two-bromine-containing products, most of which had not been previously reported, were detected in the chlorinated sample. Most Br-DBPs have corresponding chlorine-containing analogues with identical CHO composition. In addition, on-resonance collision-induced dissociation (CID) of single ultrahigh resolved bromine containing mass peaks was performed in the ICR cell to isolate single bromine-containing components in a very complex natural organic matter spectrum and provide structure information. Relatively abundant neutral loss of CO2 was observed in MS-MS spectra, indicating that the unknown Br-DBPs are rich in carboxyl groups. The results demonstrate that the ESI FT-ICR MS method could provide valuable molecular composition and structure information on unknown Br-DBPs.

Characterization of heavy petroleum fraction by positive-ion electrospray ionization FT-ICR mass spectrometry and collision induced dissociation: Bond dissociation behavior and aromatic ring architecture of basic nitrogen compounds

This paper examined the bond dissociation behavior and aromatic ring architecture of basic nitrogen compounds in Sudan heavy petroleum fraction. Both broadband and quadrupole isolation modes positive-ion electrospray ionization (ESI) Fourier transform ion cyclotron resonance mass spectrometry (FT-ICR MS) coupled with collision induced dissociation (CID) techniques were used to characterize a low sulfur crude oil derived vacuum residuum (VR). The appropriate CID operating condition was selected by comparing the molecular weight distributions of the basic nitrogen compounds under various CID operating conditions. Both odd- and even-electron fragment ions were observed from the mass spectrum, indicating that the heterolytic and homolytic bond cleavages occurred simultaneously during the CID process. The odd-electron fragment ions were predominant in each class species, indicating preferential heterolytic bond cleavages. At the optimal CID condition, the alkyl groups decomposed deeply and just left the aromatic cores of the nitrogen compounds. No significant variation in double bond equivalent (DBE) value was observed between the fragment and parent ions, revealing that the domination of single core structure.

Characterization of unknown iodinated disinfection byproducts during chlorination/chloramination using ultrahigh resolution mass spectrometry

Iodinated disinfection byproducts (I-DBPs), formed from the reaction of disinfectant(s) with organic matter in the presence of iodide in raw water, have recently been focused because of their more cytotoxic and genotoxic properties than their chlorinated or brominated analogues. To date, only a few I-DBPs in drinking water have been identified. In this study, C18 solid phase extraction coupled with electrospray ionization ultrahigh resolution Fourier transform ion cyclotron resonance mass spectrometry (ESI FT-ICR MS) was used to characterize unknown I-DBPs in chloraminated/chlorinated water spiked with iodide and humic substances. In total, 178 formulas for one-iodine-containing products, 13 formulas for two-iodine-containing products, and 15 formulas for one-chlorine and one-iodine-containing products were detected in the chloraminated water sample, while only 9 formulas for one-iodine-containing products and 6 formulas for one-chlorine and one-iodine-containing products were found in the chlorinated water sample. Most I-DBPs have corresponding chlorine-containing analogues with identical CHO compositions. As indicated by the modified aromaticity index (AImod), in the C18 extracts, more than 68% of the I-DBPs have aromatic structures or polycyclic aromatic structures. This result demonstrates that the use of chloramination as an alternative disinfection method may lead to the formation of abundant species of I-DBPs in the presence of iodide. Thus, the suitability of adopting chloramination as an alternative disinfection method should be reevaluated, particularly when iodide is present in raw water.

New Insights into Trihalomethane and Haloacetic Acid Formation Potentials: Correlation with the Molecular Composition of Natural Organic Matter in Source Water

Natural organic matter (NOM) represents the major source of precursors for disinfection byproducts (DBPs), such as trihalomethanes (THMs) and haloacetic acids (HAAs), formed during disinfection of drinking water, but the molecular composition and reactivity of NOM remain not well understood. In this study, electrospray ionization coupled to Fourier transform ion cyclotron resonance mass spectrometry (FT-ICR MS) was used to characterize the molecular composition of NOM of 20 source waters taken across China for the purpose of determining the major precursors of THMs and HAAs at molecular level. It was found that there is a core of NOM compositions that are ubiquitous in different source waters, which is supposed to be more relevant for NOM quality. Formation potentials (FP) of THMs and HAAs were determined for NOM from different source waters during chlorination. Spearmans rank correlation was used to link THMFP and HAAFP with the individual molecular composition of NOM. Significant correlation (P < 0.001) was found between DBPFP and the NOM molecules with a high O/C ratio and low H/C ratio, indicating these molecules could contribute greatly to the formation of THMs and HAAs during chlorination. The link of THMFP and HAAFP with individual NOM molecules may allow us to develop more effective treatment strategies to achieve the drinking water safety objective: effective disinfection of waterborne pathogens while minimizing toxic DBPs.

Ionizing Aromatic Compounds in Petroleum by Electrospray with HCOONH4 as Ionization Promoter

Electrospray ionization (ESI) coupled with Fourier ion cyclotron resonance mass spectrometry (FTICR MS) has been successfully used for molecular characterization of petroleum. However, ESI can not ionize nonpolar components which generally are dominant in the petroleum fraction. Here, we introduce a novel approach for aromatic compounds molecular characterization. Aromatics in petroleum fractions were ionized to [M + H](+) by positive-ion ESI with HCOONH4 as an ionization promoter, and when ESI is combined with high resolution FTICR MS, aromatic hydrocarbons and heteroatoms in petroleum fractions can be simultaneously analyzed. The method is easily available and has potential for the characterization of aromatic compounds in any other matrix.

Progress and prospect on petroleum analysis by Fourier transform ion cyclotron resonance mass spectrometry

Petroleum is an ultra-complex hydrocarbon system. Characterization of petroleum has been challenging for the analytical chemistry community. The recent development of Fourier transform ion cyclotron resonance mass spectrometry (FT-ICR MS) enables the characterization of petroleum molecular composition. This new technique provides new insights on petroleum chemistry which can result in technological breakthroughs in petroleum and petrochemical industries. In this paper, the mass resolving power and ionization techniques required in mass spectrometry for petroleum analysis are summarized, the advances in FT-ICR MS for petroleum analysis are discussed, and the technique challenges and the further research issues are discussed. Whats more, the prospective of using FT-ICR MS technique for petroleum characterization and its application to petroleum research are also included.