Yeşim Aktaş

A Nanomedicine Transports a Peptide Caspase-3 Inhibitor across the Blood–Brain Barrier and Provides Neuroprotection

Caspases play an important role as mediators of cell death in acute and chronic neurological disorders. Although peptide inhibitors of caspases provide neuroprotection, they have to be administered intracerebroventricularly because they cannot cross the blood–brain barrier (BBB). Herein, we present a nanocarrier system that can transfer chitosan nanospheres loaded with N-benzyloxycarbonyl-Asp(OMe)-Glu(OMe)-Val-Asp(OMe)-fluoromethyl ketone (Z-DEVD-FMK), a relatively specific caspase-3 inhibitor, across BBB. Caspase-3 was chosen as a pharmacological target because of its central role in cell death. Polyethylene glycol-coated nanospheres were conjugated to an anti-mouse transferrin receptor monoclonal antibody (TfRMAb) that selectively recognizes the TfR type 1 on the cerebral vasculature. We demonstrate with intravital microscopy that this nanomedicine is rapidly transported across the BBB without being measurably taken up by liver and spleen. Pre- or post-treatment (2 h) with intravenously injected Z-DEVD-FMK-loaded nanospheres dose dependently decreased the infarct volume, neurological deficit, and ischemia-induced caspase-3 activity in mice subjected to 2 h of MCA occlusion and 24 h of reperfusion, suggesting that they released an amount of peptide sufficient to inhibit caspase activity. Similarly, nanospheres inhibited physiological caspase-3 activity during development in the neonatal mouse cerebellum on postnatal day 17 after closure of the BBB. Neither nanospheres functionalized with TfRMAb but not loaded with Z-DEVD-FMK nor nanospheres lacking TfRMAb but loaded with Z-DEVD-FMK had any effect on either paradigm, suggesting that inhibition of caspase activity and subsequent neuroprotection were due to efficient penetration of the peptide into brain. Thus, chitosan nanospheres open new and exciting opportunities for brain delivery of biologically active peptides that are useful for the treatment of CNS disorders.

Intravesical cationic nanoparticles of chitosan and polycaprolactone for the delivery of Mitomycin C to bladder tumors

Cationic nanoparticles of chitosan (CS), poly-epsilon-caprolactone coated with chitosan (CS-PCL) and poly-epsilon-caprolactone coated with poly-L-lysine (PLL-PCL) were developed to encapsulate intravesical chemotherapeutic agent Mitomycin C (MMC) for longer residence time, higher local drug concentration and prevention of drug loss during bladder discharge. Nanoparticle diameters varied between 180 and 340 nm depending on polymer used for preparation and coating. Zeta potential values demonstrated positive charge expected from cationic nanoparticles. MMC encapsulation efficiency depended on hydrophilicity of polymers since MMC is water-soluble. Encapsulation was increased by 2-fold for CS-PCL and 3-fold for PLL-PCL as a consequence of hydrophilic coating. Complete drug release was obtained with only CS-PCL nanoparticles. On the other hand, CS and PLL-PCL nanoparticles did not completely liberate MMC due to strong polymer-drug interactions which were elucidated with DSC studies. As far as cellular interaction was concerned, CS-PCL was the most efficient formulation for uptake of fluorescent markers Nile Red and Rhodamine123 incorporated into nanoparticles. Especially, CS-PCL nanoparticles loaded with Rhodamine123 sharing hydrophilic properties with MMC were selectively incorporated by bladder cancer cell line, but not by normal bladder epithelial cells. CS-PCL nanoparticles seem to be promising for MMC delivery with respect to anticancer efficacy tested against MB49 bladder carcinoma cell line.

Preparation and In Vitro Evaluation of bFGF-Loaded Chitosan Nanoparticles

The objective of our study was to prepare and characterize basic fibroblast growth factor (bFGF)-loaded nanoparticles. Protein-loaded chitosan nanoparticles were obtained by ionotropic gelation process based on the interaction between chitosan and tripolyphosphate (TPP). The protein-loading capacity and encapsulation efficiency were 0.021% and 27.388%, respectively. The bFGF-loaded nanoparticles have a mean diameter of 424 nm, a narrow size distribution, spherical shape and positive surface charges. In vitro release showed that the extent of release was 68% at 24 hr. The protein integrity was investigated by SDS-PAGE analysis that confirmed protein integrity was not affected by the encapsulation procedure and release conditions.

Influence of Hydroxypropyl β-Cyclodextrin on the Corneal Permeation of Pilocarpine

Abstract The influence of hydroxypropyl β-cyclodextrin (HPβCD) on the corneal permeation of pilocarpine nitrate was investigated by an in vitro permeability study using isolated rabbit cornea. Pupillary-response pattern to pilocarpine nitrate with and without HPβCD was examined in rabbit eye. Corneal permeation of pilocarpine nitrate was found to be four times higher after adding HPβCD into the formulation. The reduction of pupil diameter (miosis) by pilocarpine nitrate was significantly increased as a result of HPβCD addition into the simple aqueous solution of the active substance. The highest miotic response was obtained with the formulation prepared in a vehicle of Carbopol® 940. It is suggested that ocular bioavailability of pilocarpine nitrate could be improved by the addition of HPβCD.

Inkjet printing of antiviral PCL nanoparticles and anticancer cyclodextrin inclusion complexes on bioadhesive film for cervical administration

Personalized medicine is an important treatment approach for diseases like cancer with high intrasubject variability. In this framework, printing is one of the most promising methods since it permits dose and geometry adjustment of the final product. With this study, a combination product consisting of anticancer (paclitaxel) and antiviral (cidofovir) drugs was manufactured by inkjet printing onto adhesive film for local treatment of cervical cancers as a result of HPV infection. Furthermore, solubility problem of paclitaxel was overcome by maintaining this poorly soluble drug in a cyclodextrin inclusion complex and release of cidofovir was controlled by encapsulation in polycaprolactone nanoparticles. In vitro characterization studies of printed film formulations were performed and cell culture studies showed that drug loaded film formulation was effective on human cervical adenocarcinoma cells. Our study suggests that inkjet printing technology can be utilized in the development of antiviral/anticancer combination dosage forms for mucosal application. The drug amount in the delivery system can be accurately controlled and modified. Moreover, prolonged drug release time can be obtained. Printing of anticancer and antiviral drugs on film seem to be a potential approach for HPV-related cervical cancer treatment and a good candidate for further studies.

A small variation in average particle size of PLGA nanoparticles prepared by nanoprecipitation leads to considerable change in nanoparticles’ characteristics and efficacy of intracellular delivery

Abstract In this study, it was aimed to investigate characteristics and intracellular delivery of two different-sized PLGA nanoparticles in ouzo region by considering number of nanoparticles. To determine the effect of formulation parameters on average particle size, Dil labeled nanoparticles were prepared using a three-factor, two-level full factorial statistical experimental design. PLGA230 (230.8 ± 4.32 nm) and PLGA160 (157.9 ± 6.16 nm) nanoparticles were obtained by altering polymer amount based on experimental design results and characterized. Same number of PLGA230 and PLGA160 nanoparticles per cell were applied onto HEK293 cells; then, cytotoxicity, uptake kinetics and mechanism were evaluated by flow cytometry and fluorescent microscopy. Also same weight of PLGA230 and PLGA160 nanoparticles were applied and cellular uptake of these nanoparticles was evaluated. It was found that PLGA230 nanoparticles had higher encapsulation efficiency and slower dye release compared to PLGA160 nanoparticles. When they were applied at same counts per cell, PLGA230 nanoparticles displayed faster and higher intracellular dye transfer than PLGA160 nanoparticles. On the other hand, PLGA160 appeared to be a more effective vehicle than PLGA230 when applied at the same weight concentration. It was also shown that for both nanoparticles, HEK293 cells employed macropinocytic, caveolae- and clathrin-mediated endocytic pathways.

Evaluation of brain-targeted chitosan nanoparticles through blood–brain barrier cerebral microvessel endothelial cells

Abstract The blood–brain barrier (BBB) is the major problem for the treatment of central nervous system diseases. A previous study from our group showed that the brain-targeted chitosan nanoparticles-loaded with large peptide moieties can rapidly cross the barrier and provide neuroprotection. The present study aims to determine the efficacy of the brain-targeted chitosan nanoparticles’ uptake by the human BBB cerebral microvessel endothelial cells (hCMECs) and to investigate the underlying mechanisms for enhanced cellular entry. Fluorescently labelled nanoparticles either conjugated with antibodies recognising human transferrin receptor (anti-TfR mAb) or not were prepared, characterised and their interaction with cerebral endothelial cells was evaluated. The antibody decoration of chitosan nanoparticles significantly increased their entry into hCMEC/D3 cell line. Inhibition of cellular uptake by chlorpromazine indicated that the anti-TfR mAb-conjugated nanoparticles were preferentially cell internalised through receptor-mediated endocytosis pathway. Alternatively, as primarily observed with control chitosan nanoparticles, aggregation of nanoparticles may also have induced macropinocytosis.

Development And Characterization Of Insulin-Loaded Liposome-Chitosan Nanoparticle (LCS-NP) Complex And Investigation Of Transport Properties Through Pancreatic Beta TC Cell Line

Objectives: In recent years, studies on oral use have increased rapidly due to the restrictive aspects of parenteral administration of indispensable peptide-structured insulin in the rapidly growing worldwide treatment of diabetes. The aim of the study was to examine the development of a novel insulin-loaded LCS-NP complex, and its characterization and efficacy on pancreatic cells responsible for insulin release. Materials and Methods: Blank liposomes and insulin-loaded LCS-NPs were prepared using dry film hydration and ionotropic gelation methods, respectively. The LCS-NP complex was prepared by mixing liposomes/NPs in a 2:1 (w/w) ratio. The cytotoxic effects of the various concentrations of insulin and formulation components on the pancreatic cell line were determined using a 3-(4,5-dimethyldiazol-2-yl)-2,5 diphenyl tetrazolium bromide assay and quantities to be used in the formulation were determined. Particle size, zeta potential, encapsulation efficiency, in vitro release profile and release kinetics, and transport properties of the prepared complex were investigated. Results: The newly developed insulin-loaded LCS-NP complex had a particle size of 2.85±0.035 μm and zeta potential of 8.11±1.025 mV. The encapsulation yield was found as 48±1.1%. In vitro insulin release from the complex was 80.9±2.71%. Insulin transport from β Tc cells was 30.50%. Permeability coefficients (log k) were calculated as -1.280±0.070 for the insulin solution and -1.020±0.062 for the insulin-loaded complex. Conclusion: This study suggests that insulin could be successfully loaded into the newly developed LCS-NP complex, and it is thought that this complex carries an effective formulation potential for long-term efficacy in the treatment of diabetes.

Nanoliposomal Resveratrol as a Novel Approach to Treatment of Diabetes Mellitus

Diabetes mellitus (DM) is a chronic metabolic disease and the subgroup of DM is called type II which is the most common form. The incidence of type II is increasing worldwide and it focuses on several new approaches to efficiently treatment of diabetes. Resveratrol (RSV) is known to be strong antioxidant and has an insulin-like effect in streptozotocin (STZ)-induced diabetic cells. It plays an active role at treatment of diabetes with reducing the oxidative stress, lowering glucose levels and protection of beta cells which are responsible for insulin secretion. In our study, we prepared two different RSV-loaded nanoliposomes (LPs), characterized in vitro and evaluated efficiencies of LPs on diabetes and related oxidative stress. Release and transport studies of RSV through dialyse membrane and pancreatic beta TC (β TC) cells were investigated from its solution and LPs. Stability studies were performed at two different conditions (4 °C and 25 °C ± 60% relative humidity) for 3 months. Particle size (PS), zeta potential (ZP), polydispersity index (PDI), encapsulation efficiency (EE) and type of the formulations were determined. β TC cell line was used in cell culture studies and cell viability was measured with using 3-(4,5-dimethyldiazol-2-yl)-2,5 diphenyl tetrazolium bromide (MTT) cytotoxicity test. The antidiabetic effects of RSV LPs were investigated on β TC cell induced with glucose and STZ and we evaluated relationship between glucose and insulin concentration before and after incubation with LPs containing RSV. Antioxidant and preventive effects of RSV-loaded LPs against diabetes-associated oxidative stress were determined with superoxide dismutase (SOD) and glutathione peroxidase (GSH-Px) enzyme assay. When all results were evaluated together, these new developed liposomal formulations significantly decreased high glucose levels in diabetic cell groups synchronous with increasing insulin levels and they showed prolonged antioxidant activity against oxidative stress for 24 hours compared to RSV solution.