Yinxiu Zuo

Freestanding flexible polymer films based on bridging of two EDOT units with functionalized chains for use in long-term-stable supercapacitors

Freestanding flexible capacitive materials are ideal for use in bendable electronic devices. However, it is difficult to prepare pure PEDOT films in a freestanding state by chemical and electrochemical methods. Here, we used a simple strategy of introducing alkoxy, ether, ester, and amide chains for bridging two EDOT units to form precursors, which could then be electrodeposited readily to produce freestanding and flexible films. The precursor with the amide group was suitable for obtaining higher-quality films with improved thermal stability, mechanical properties, and capacitive performance. In addition, the asymmetric PBEDTA//PEDOT capacitors exhibited a capacitance retention rate of 98.5% after 5000 cycles, which is higher than those of PBEDTH//PEDOT (92.7%), PBEDTG//PEDOT (80.5%), and PBEDTE//PEDOT (86.8%) capacitors. This result indicates that the polymer films and, in particular, the PBEDTA films, are suitable for use in flexible supercapacitors.

Simple and green synthesis of piperazine-grafted reduced graphene oxide and its application for the detection of Hg(II)

In this paper, piperazine-grafted reduced graphene oxide (NH-rGO) was synthesized via a simple and green two-step procedure: (i) opening of the resulting epoxides of graphene oxide (GO) with piperazine (NH) through nucleophilic substitution; (ii) reduction of GO with ascorbic acid. Its structure and morphology were characterized by scanning electron microscopy and x-ray photoelectron spectroscopy. The NH-rGO modified glassy carbon electrode was explored as an electrochemical sensor for the determination of Hg(II) using a differential pulse anodic stripping voltammetry technique. Hg(II) can be efficiently accumulated and deposited on the surface of a modified electrode by strong coordination chemical bonds formed between Hg(II) and NH. And then the anodic stripping current can be significantly enhanced by rGO with the merits of large specific surface area and high conductivity, which served as a signal amplifier, finally realizing the highly sensitive determination of Hg(II). The experimental parameters including the pH value of the acetate buffer, deposition potential and deposition time were optimized. Under optimal conditions, the developed sensor exhibited a wide linear range from 0.4-12 000 nM with a low limit of detection of 0.2 nM, which is well below the guideline value in drinking water set by the WHO. Moreover, the practical application of this method was confirmed by an assay of Hg(II) in tap water samples with acceptable results.