Yixuan Feng

Turning induced residual stress prediction of AISI 4130 considering dynamic recrystallization

ABSTRACT Machining-induced residual stress distribution is strongly influenced by the machining process condition, tool geometry and workpiece material mechanical properties. The high temperature, large strain and high strain rate environment will promote the material micro-structural attribute changes. The material micro-structural attribute changes could directly affect the material mechanical properties. An analytical model is proposed for the residual stress prediction in the orthogonal turning by considering the material dynamical recrystallization induced grain growth effect. The grain size effect on the material flow stress behavior is included by adding a grain size dependent term into the traditional Johnson–Cook model. The Johnson–Mehl–Avrami–Kolmogorov model calculates the recrystallized volume fraction and grain size as a function strain, strain rate and time. The average grain size is calculated with a rule of mixture by volume. Then the modified Johnson–Cook model is embedded into a classic residual stress prediction model for the machining induced residual stress profile prediction on the machined workpiece surface. Experimental tests are conducted for the model validation. The predicted residual stress shows good approximation with the measurement in both the trend and magnitude of the residual stress. Also, the effects of cutting speed and feed rate on the residual stress profile are investigated.

Coupled thermal and mechanical analyses of micro-milling Inconel 718

Micro-milling forces, cutting temperature, and thermal–mechanical coupling are the key research topics about the mechanism of micro-milling nickel-based superalloy Inconel 718. Most current analyses of thermal–mechanical coupling in micro-milling are based on finite element or experimental methods. The simulation is not conducive to revealing the micro-milling mechanism, while the results of experiments are only valid for certain machine tool and workpiece material. Few analytical coupling models of cutting force and cutting temperature during micro-milling process have been proposed. Therefore, the authors studied coupled thermal–mechanical analyses of micro-milling Inconel 718 and presented a revised three-dimensional analytical model of micro-milling forces, which considers the effects of the cutting temperature and the ploughing force caused by the arc of cutting edge during shear-dominant cutting process. Then, an analytical cutting temperature model based on Fourier’s law is presented by regarding the contact area as a moving finite-length heat source. Coupling calculation between micro-milling force model and temperature model through an iterative process is conducted. The novelty is including cutting temperature into micro-milling force model, which simulates the interaction between cutting force and cutting temperature during micro-milling process. The established model predicts both micro-milling force and temperature. Finally, experiments are conducted to verify the accuracy of the proposed analytical method. Based on the coupled thermal–mechanical analyses and experimental results, the authors reveal the effects of cutting parameters on micro-milling forces and temperature.

A New Method for the Prediction of Micro-Milling Tool Breakage

Micro-milling tool breakage has become a bottleneck for the development of micro-milling technology. A new method to predict micro-milling tool breakage based on theoretical model is presented in this paper. Based on the previously built micro-milling force model, the bending stress of the micro-milling cutter caused by the distributed load along the spiral cutting edge is calculated; Then, the ultimate stress of carbide micro-milling tool is obtained by experiments; Finally, the bending stress at the dangerous part of the micro-milling tool is compared with the ultimate stress. Tool breakage curves are drawn with feed per tooth and axial cutting depth as horizontal and vertical axes respectively. The area above the curve is the tool breakage zone, and the area below the curve is the safety zone. The research provides a new method for the prediction of micro-milling tool breakage, and therefore guides the cutting parameters selection in micro-milling.Copyright