Yoko Nunome

Use of Soft Plasma Ionization Source at Evacuated Air Atmospheres in Time-of-Flight Mass Spectrometry to Suppress Fragmentation of Volatile Organic Compounds

ABSTRACT This study describes a measuring system for mass spectrometry, consisting of a glow discharge ionization source for soft plasma ionization and a time-of-flight mass spectrometer, to detect toxic volatile organic compounds rapidly and easily. It is the most important to determine how the complicated fragmentation of such compounds can be suppressed to occur so as to recognize the mass spectra of the volatile organic compounds as their fingerprints. The novelty of this work is that the optimal discharge condition for the soft plasma ionization–time-of-flight mass spectrometer system could be selected, so that the parent mass peak of analyte molecules could be observed both with high sensitivity and with little or no fragmentation of them. Use of air gas at a pressure of 1000 Pa provided the most favorable result for these criteria, whereas, in a previous report, the soft plasma ionization source operating with argon at a pressure of 346 Pa had yielded additional mass peaks of the fragmented species. The reason for this would be explained by the fact that energetic electrons in the plasma, which principally cause the fragmentation of the volatile organic compounds, have lower number density at higher gas pressures, through de-accelerated collisions with the plasma gas.

Contribution of Volatile Interactions During Co-Gasification of Biomass with Coal

Abstract: Thermo-gravimetric behavior during steam co-gasification of Japanese cedar and coal was investigated. The difference between co-gasification behavior and the average gasification behavior of cedar and coal indicates two synergetic peaks. The first peak occurred between 300 °C and 550 °C while the second peak was observed above 800 °C. The first peak coincides with volatile release and therefore associated with volatile interactions while the second peak is linked with catalytic effect of alkali and alkaline earth metal (AAEM). Acid washed cellulose and Na rich lignin chemicals were used as artificial biomass components. In reference to Japanese cedar, mixture of cellulose and lignin i.e. simulated biomass , was also investigated. Co-gasification of cellulose with coal and co-gasification of lignin with coal, demonstrates contribution of volatile interactions and AAEM catalysis respectively. Morphology of partially gasified blends, shows hastened pore development and physical cracking on coal particles. Brunauer−Emmett−Teller (BET) surface area of the charred blend was lower than the average surface area for charred biomass and coal.

Control of ash deposition on the surface of heat transfer tube

Ash deposition, called fouling, is one of major problems occurring in boiler that incinerates waste products as fuel. Ash deposition layer on heat transfer tube in a boiler causes not only heat transfer inhibition but also corrosion of the surface of heat transfer tube. Compared with pulverized coal combustion boiler, a concern of fouling becomes larger under waste incineration conditions due to their high contents of chlorine compounds. In this study, using ash samples derived from waste incineration processes, ash deposition experiments were carried out in vertical ash deposition furnace with a thermal spraying burner. Ash samples deposited on the tube surface were analyzed for elemental compositions and their distributions, using CCSEM equipped with EDX. A thermal spraying technique was applied to improve the surface properties of heat transfer tubes in boiler for reduction of ash deposition. Ni alloy as a thermal spraying material showed a positive effect to reduce ash deposition even under waste incineration conditions. In addition, to clarify the mechanism of ash deposition, thermal equilibrium analysis was also carried out.