Young Hoon Cho

Selective Gas Transport Through Few-Layered Graphene and Graphene Oxide Membranes

Gas Separations When gas separation membranes are made thinner, they usually allow permeating gases to pass through faster. However, a thinner membrane may be poorer at separating between gas species. Kim et al. (p. 91) examined the permeability and selectivity of layered graphene and graphene oxide membranes. Gas molecules diffuse through defective pores and channels that form between the layers. Controlling these structures tuned the properties of the membranes to allow the extraction of carbon dioxide from other gases. Li et al. (p. 95) describe membranes as thin as 1.8 nanometers made from only two to three layers of graphene oxide. Small defects within the layers allowed hydrogen to pass through, separating it from carbon dioxide and nitrogen. Stacked graphene and graphene oxide membranes prepared with gas flow channels exhibit tunable gas separation performance. Graphene is a distinct two-dimensional material that offers a wide range of opportunities for membrane applications because of ultimate thinness, flexibility, chemical stability, and mechanical strength. We demonstrate that few- and several-layered graphene and graphene oxide (GO) sheets can be engineered to exhibit the desired gas separation characteristics. Selective gas diffusion can be achieved by controlling gas flow channels and pores via different stacking methods. For layered (3- to 10-nanometer) GO membranes, tunable gas transport behavior was strongly dependent on the degree of interlocking within the GO stacking structure. High carbon dioxide/nitrogen selectivity was achieved by well-interlocked GO membranes in high relative humidity, which is most suitable for postcombustion carbon dioxide capture processes, including a humidified feed stream.

Experimental Evidence of Rapid Water Transport through Carbon Nanotubes Embedded in Polymeric Desalination Membranes

As water molecules permeate ultrafast through carbon nanotubes (CNTs), many studies have prepared CNTs-based membranes for water purification as well as desalination, particularly focusing on high flux membranes. Among them, vertically aligned CNTs membranes with ultrahigh water flux have been successfully demonstrated for fundamental studies, but they lack scalability for bulk production and sufficiently high salt rejection. CNTs embedded in polymeric desalination membranes, i.e., polyamide thin-film composite (TFC) membranes, can improve water flux without any loss of salt rejection. This improved flux is achieved by enhancing the dispersion properties of CNTs in diamine aqueous solution and also by using cap-opened CNTs. Hydrophilic CNTs were prepared by wrapping CNT walls via bio-inspired surface modification using dopamine solution. Cap-opening of pristine CNTs is performed by using a thermo-oxidative process. As a result, hydrophilic, cap-opened CNTs-embedded polyamide TFC membranes are successfully prepared, which show much higher water flux than pristine polyamide TFC membrane. On the other hand, less-disperse, less cap-opened CNTs-embedded TFC membranes do not show any flux improvement and rather lead to lower salt rejection properties.

Graphene-based membranes: status and prospects.

Recently, graphene-based membranes have been extensively studied, represented by two distinct research directions: (i) creating pores in graphene basal plane and (ii) engineering nanochannels in graphene layers. Most simulation results predict that porous graphene membranes can be much more selective and permeable than current existing membranes, also evidenced by some experimental results for gas separation and desalination. In addition, graphene oxide has been widely investigated in layered membranes with two-dimensional nanochannels, showing very intriguing separation properties. This review will cover state-of-the-art of graphene-based membranes, and also provide a material guideline on future research directions suitable for practical membrane applications.