Young June Won

Preparation and Application of Patterned Membranes for Wastewater Treatment

Membrane fouling remains a critical factor limiting the widespread use of membrane processes in water and wastewater treatment. To mitigate membrane fouling, we introduced a patterned morphology on the membrane surface using a lithographic method. A modified immersion precipitation method was developed to relieve the formation of dense layer at the solvent-nonsolvent interface, that is, the opposite side of the patterned surface. Diverse patterned membranes, such as pyramid-, prism-, and embossing-patterned membranes, were prepared and compared with a flat membrane in terms of morphology, permeability, and biofouling. Patterned membrane fidelity was largely dependent on the polymer concentration in cast solution. The patterned surface augmented the water flux in proportion to the roughness factor of the patterned membrane. However, the type of pattern did not affect substantially the mean pore size on the patterned surface. Deposition of microbial cells on the patterned membrane was significantly reduced compared to that on the flat membrane in the membrane bioreactor (MBR) for wastewater treatment. This was attributed to hydraulic resistance of the apex of the patterned surface, which induced local turbulence.

A facile route to enhance the water flux of a thin-film composite reverse osmosis membrane: incorporating thickness-controlled graphene oxide into a highly porous support layer

In this study, we demonstrated that a reduction in solely the concentration of the polymer solution for preparation of the support layer effectively enhances the water flux of a thin-film composite (TFC) reverse osmosis (RO) membrane. However, a decrease in the polymer concentration caused the sub-surface structure of the support layer to become too porous, which unavoidably weakened the mechanical strength of the support layer. To overcome the problem, we prepared a highly porous support layer with improved mechanical strength by incorporating graphene oxide (GO) platelets. The thickness of the GO platelets was controlled by adjusting the mechanical energy input per volume of the precursor solution. We confirmed that well-exfoliated GO platelets (mean thickness: about 1.5 nm) are more effective in enhancing the mechanical properties of the support layer. The TFC RO membrane made of the GO composite support layer had almost 1.6 to 4 times higher water flux with comparable salt rejection compared to both the current upper bounds of the RO membranes prepared by modification of the active layer and commercial RO membranes.

More Efficient Media Design for Enhanced Biofouling Control in a Membrane Bioreactor: Quorum Quenching Bacteria Entrapping Hollow Cylinder

Recently, membrane bioreactors (MBRs) with quorum quenching (QQ) bacteria entrapping beads have been reported as a new paradigm in biofouling control because, unlike conventional post-biofilm control methods, bacterial QQ can inhibit biofilm formation through its combined effects of physical scouring of the membrane and inhibition of quorum sensing (QS). In this study, using a special reporter strain (Escherichia coli JB525), the interaction between QS signal molecules and quorum quenching bacteria entrapping beads (QQ-beads) was elucidated through visualization of the QS signal molecules within a QQ-bead using a fluorescence microscope. As a result, under the conditions considered in this study, the surface area of QQ-media was likely to be a dominant parameter in enhancing QQ activity over total mass of entrapped QQ bacteria because QQ bacteria located near the core of a QQ-bead were unable to display their QQ activities. On the basis of this information, a more efficient QQ-medium, a QQ hollow cylinder (QQ-HC), was designed and prepared. In batch experiments, QQ-HCs showed greater QQ activity than QQ-beads as a result of their higher surface area and enhanced physical washing effect because of their larger impact area against the membrane surface. Furthermore, it was shown that such advantages of QQ-HCs resulted in more effective mitigation of membrane fouling than from QQ-beads in lab-scale continuous MBRs.