Yue-Yan Chan

Understanding acute ankle ligamentous sprain injury in sports

This paper summarizes the current understanding on acute ankle sprain injury, which is the most common acute sport trauma, accounting for about 14% of all sport-related injuries. Among, 80% are ligamentous sprains caused by explosive inversion or supination. The injury motion often happens at the subtalar joint and tears the anterior talofibular ligament (ATFL) which possesses the lowest ultimate load among the lateral ligaments at the ankle. For extrinsic risk factors to ankle sprain injury, prescribing orthosis decreases the risk while increased exercise intensity in soccer raises the risk. For intrinsic factors, a foot size with increased width, an increased ankle eversion to inversion strength, plantarflexion strength and ratio between dorsiflexion and plantarflexion strength, and limb dominance could increase the ankle sprain injury risk. Players with a previous sprain history, players wearing shoes with air cells, players who do not stretch before exercising, players with inferior single leg balance, and overweight players are 4.9, 4.3, 2.6, 2.4 and 3.9 times more likely to sustain an ankle sprain injury. The aetiology of most ankle sprain injuries is incorrect foot positioning at landing – a medially-deviated vertical ground reaction force causes an explosive supination or inversion moment at the subtalar joint in a short time (about 50 ms). Another aetiology is the delayed reaction time of the peroneal muscles at the lateral aspect of the ankle (60–90 ms). The failure supination or inversion torque is about 41–45 Nm to cause ligamentous rupture in simulated spraining tests on cadaver. A previous case report revealed that the ankle joint reached 48 degrees inversion and 10 degrees internal rotation during an accidental grade I ankle ligamentous sprain injury during a dynamic cutting trial in laboratory. Diagnosis techniques and grading systems vary, but the management of ankle ligamentous sprain injury is mainly conservative. Immobilization should not be used as it results in joint stiffness, muscle atrophy and loss of proprioception. Traditional Chinese medicine such as herbs, massage and acupuncture were well applied in China in managing sports injuries, and was reported to be effective in relieving pain, reducing swelling and edema, and restoring normal ankle function. Finally, the best practice of sports medicine would be to prevent the injury. Different previous approaches, including designing prophylactice devices, introducing functional interventions, as well as change of games rules were highlighted. This paper allows the readers to catch up with the previous researches on ankle sprain injury, and facilitate the future research idea on sport-related ankle sprain injury.

The use of wearable inertial motion sensors in human lower limb biomechanics studies: a systematic review.

Wearable motion sensors consisting of accelerometers, gyroscopes and magnetic sensors are readily available nowadays. The small size and low production costs of motion sensors make them a very good tool for human motions analysis. However, data processing and accuracy of the collected data are important issues for research purposes. In this paper, we aim to review the literature related to usage of inertial sensors in human lower limb biomechanics studies. A systematic search was done in the following search engines: ISI Web of Knowledge, Medline, SportDiscus and IEEE Xplore. Thirty nine full papers and conference abstracts with related topics were included in this review. The type of sensor involved, data collection methods, study design, validation methods and its applications were reviewed.

Estimating the complete ground reaction forces with pressure insoles in walking

This study presented a method to estimate the complete ground reaction forces from pressure insoles in walking. Five male subjects performed 10 walking trials in a laboratory. The complete ground reaction forces were collected during a right foot stride by a force plate at 1000Hz. Simultaneous plantar pressure data were collected at 100Hz by a pressure insole system with 99 sensors covering the whole plantar area. Stepwise linear regressions were performed to individually reconstruct the complete ground reaction forces in three directions from the 99 individual pressure data until redundancy among the predictors occurred. An additional linear regression was performed to reconstruct the vertical ground reaction force by the sum of the value of the 99 pressure sensors. Five other subjects performed the same walking test for validation. Estimated ground reaction forces in three directions were calculated with the developed regression models, and were compared with the real data recorded from force plate. Accuracy was represented by the correlation coefficient and the root mean square error. Results showed very good correlation in anterior-posterior (0.928) and vertical (0.989) directions, and reasonable correlation in medial-lateral direction (0.719). The root mean square error was about 12%, 5% and 28% of the peak recorded value. Future studies should aim to generalize the methods or to establish specific methods to other subjects, patients, motions, footwear and floor conditions. The method gives an extra option to study an estimation of the complete ground reaction forces in any environment without the constraints from the number and location of force plates.

Differentiation of ankle sprain motion and common sporting motion by ankle inversion velocity.

This study investigated the ankle inversion and inversion velocity between various common motions in sports and simulated sprain motion, in order to provide a threshold for ankle sprain risk identification. The experiment was composed of two parts: firstly, ten male subjects wore a pair of sport shoes and performed ten trials of running, cutting, jump-landing and stepping-down motions. Secondly, five subjects performed five trials of simulated sprain motion by a supination sprain simulator. The motions were analyzed by an eight-camera motion capture system at 120 Hz. A force plate was employed to record the vertical ground reaction force and locate the foot strike time for common sporting motions. Ankle inversion and inversion velocity were calculated by a standard lower extremity biomechanics calculation procedure. Profiles of vertical ground reaction force, ankle inversion angle and ankle inversion velocity were obtained. Results suggested that the ankle was kept in an everted position during the stance. The maximum ankle inversion velocity ranged from 22.5 to 85.1 degrees/s and 114.0 to 202.5 degrees/s for the four tested motions and simulated sprain motion respectively. Together with the ankle inversion velocity reported in the injury case (623 degrees/s), a threshold of ankle inversion velocity of 300 degrees/s was suggested for the identification of ankle sprain. The information obtained in this study can serve as a basis for the development of an active protection apparatus for reducing ankle sprain injury.

A mechanical supination sprain simulator for studying ankle supination sprain kinematics.

This study presents a free-fall mechanical supination sprain simulator for evaluating the ankle joint kinematics during a simulated ankle supination sprain injury. The device allows the foot to be in an anatomical position before the sudden motion, and also allows different degrees of supination, or a combination of inversion and plantarflexion. Five subjects performed simulated supination sprain trials in five different supination angles. Ankle motion was captured by a motion analysis system, and the ankle kinematics were reported in plantarflexion/dorsiflexion, inversion/eversion and internal/external rotation planes. Results showed that all sprain motions were not pure single-plane motions but were accompanied by motion in other two planes, therefore, different degrees of supination were achieved. The presented sprain simulator allows a more comprehensive study of the kinematics of ankle sprain when compared with some previous laboratory research designs.

A three-pressure-sensor (3PS) system for monitoring ankle supination torque during sport motions

This study presented a three-pressure-sensor (3PS) system for monitoring ankle supination torque during sport motions. Five male subjects wore a pair of cloth sport shoes and performed 10 trials of walking, running, cutting, vertical jump-landing and stepping-down motions in a random sequence. A pair of pressure insoles (Novel Pedar model W, Germany) was inserted in the shoes for the measurement of plantar pressure at 100Hz. The ankle joint torque was calculated by a standard lower extremity inverse dynamic calculation procedure with the data obtained by a motion capture system (VICON, UK) and a force plate (AMTI, USA), and was presented in a supination/pronation plane with an oblique axis of rotation at the ankle joint. Stepwise linear regression analysis suggested that pressure data at three locations beneath the foot were essential for reconstructing the ankle supination torque. Another group of five male subjects participated in a validation test with the same procedure, but with the pressure insoles replaced by the 3PS system. Estimated ankle supination torque was calculated from the equation developed by the regression analysis. Results suggested that the correlation between the standard and estimated data was high (R=0.938). The overall root mean square error was 6.91Nm, which was about 6% of the peak values recorded in the five sport motions (113Nm). With the good estimation accuracy, tiny size and inexpensive cost, the 3PS system is readily available to be implanted in sport shoe for the estimation and monitoring of ankle supination torque during dynamic sport motions.

Identification of ankle sprain motion from common sporting activities by dorsal foot kinematics data

This study presented a method to identify ankle sprain motion from common sporting activities by dorsal foot kinematics data. Six male subjects performed 300 simulated supination sprain trials and 300 non-sprain trials in a laboratory. Eight motion sensors were attached to the right dorsal foot to collect three-dimensional linear acceleration and angular velocity kinematics data, which were used to train up a support vector machine (SVM) model for the identification purpose. Results suggested that the best identification method required only one motion sensor located at the medial calcaneus, and the method was verified on another group of six subjects performing 300 simulated supination sprain trials and 300 non-sprain trials. The accuracy of this method was 91.3%, and the method could help developing a mobile motion sensor system for ankle sprain detection.

A mechanical jig for measuring ankle supination and pronation torque in vitro and in vivo

This study presents the design of a mechanical jig for evaluating the ankle joint torque on both cadaver and human ankles. Previous study showed that ankle sprain motion was a combination of plantarflexion and inversion. The device allows measurement of ankle supination and pronation torque with one simple axis in a single step motion. More importantly, the ankle orientation allows rotation starting from an anatomical position. Six cadaveric specimens and six human subjects were tested with simulated and voluntary rotation respectively. The presented mechanical jig makes possible the determination of supination torque for studying ankle sprain injury and the estimation of pronation torque for examining peroneal muscle response.