Zhongwei Zhu

Evolution of Structure and Chemistry of Bimetallic Nanoparticle Catalysts under Reaction Conditions

Three series of bimetallic nanoparticle catalysts (Rh(x)Pd(1-x), Rh(x)Pt(1-x), and Pd(x)Pt(1-x), x = 0.2, 0.5, 0.8) were synthesized using one-step colloidal chemistry. X-ray photoelectron spectroscopy (XPS) depth profiles using different X-ray energies and scanning transmission electron microscopy showed that the as-synthesized Rh(x)Pd(1-x) and Pd(x)Pt(1-x) nanoparticles have a core-shell structure whereas the Rh(x)Pt(1-x) alloys are more homogeneous in structure. The evolution of their structures and chemistry under oxidizing and reducing conditions was studied with ambient-pressure XPS (AP-XPS) in the Torr pressure range. The Rh(x)Pd(1-x) and Rh(x)Pt(1-x) nanoparticles undergo reversible changes of surface composition and chemical state when the reactant gases change from oxidizing (NO or O(2) at 300 degrees C) to reducing (H(2) or CO at 300 degrees C) or catalytic (mixture of NO and CO at 300 degrees C). In contrast, no significant change in the distribution of the Pd and Pt atoms in the Pd(x)Pt(1-x) nanoparticles was observed. The difference in restructuring behavior under these reaction conditions in the three series of bimetallic nanoparticle catalysts is correlated with the surface free energy of the metals and the heat of formation of the metallic oxides. The observation of structural evolution of bimetallic nanoparticles under different reaction conditions suggests the importance of in situ studies of surface structures of nanoparticle catalysts.

A Pt-cluster-based heterogeneous catalyst for homogeneous catalytic reactions: X-ray absorption spectroscopy and reaction kinetic studies of their activity and stability against leaching.

The design and development of metal-cluster-based heterogeneous catalysts with high activity, selectivity, and stability under solution-phase reaction conditions will enable their applications as recyclable catalysts in large-scale fine chemicals production. To achieve these required catalytic properties, a heterogeneous catalyst must contain specific catalytically active species in high concentration, and the active species must be stabilized on a solid catalyst support under solution-phase reaction conditions. These requirements pose a great challenge for catalysis research to design metal-cluster-based catalysts for solution-phase catalytic processes. Here, we focus on a silica-supported, polymer-encapsulated Pt catalyst for an electrophilic hydroalkoxylation reaction in toluene, which exhibits superior selectivity and stability against leaching under mild reaction conditions. We unveil the key factors leading to the observed superior catalytic performance by combining X-ray absorption spectroscopy (XAS) and reaction kinetic studies. On the basis of the mechanistic understandings obtained in this work, we also provide useful guidelines for designing metal-cluster-based catalyst for a broader range of reactions in the solution phase.

Formation of Nanometer-Sized Surface Platinum Oxide Clusters on a Stepped Pt(557) Single Crystal Surface Induced by Oxygen: A High-Pressure STM and Ambient-Pressure XPS Study

We studied the oxygen-induced restructuring process on a stepped Pt(557) single crystal surface using high-pressure scanning tunneling microscopy (HP-STM) and ambient-pressure X-ray photoelectron spectroscopy (AP-XPS) at O(2) pressures up to 1 Torr. HP-STM has revealed that nanometer-sized clusters are created on Pt(557) at 1 Torr of O(2) and at room temperature. These clusters are identified as surface Pt oxide by AP-XPS. The appearance of clusters is preceded by the formation of 1D chain structures at the step edges. By using a Pt(111) surface as a reference, it was found that the step sites are the nucleation centers for the formation of surface oxide clusters. These surface oxide clusters disappear and the stepped structure is restored on Pt(557) after evacuating O(2) to 10(-8) Torr. Changes in the surface oxide concentration in response to variations in the O(2) gas pressure are repeatable for several cycles. Our results that small clusters are initiated at step sites at high pressures demonstrate the importance of performing in situ characterization of stepped Pt catalysts under reaction conditions.

Influence of size-induced oxidation state of platinum nanoparticles on selectivity and activity in catalytic methanol oxidation in the gas phase.

Pt nanoparticles with various sizes of 1, 2, 4, and 6 nm were synthesized and studied as catalysts for gas-phase methanol oxidation reaction toward formaldehyde and carbon dioxide under ambient pressure (10 Torr of methanol, 50 Torr of oxygen, and 710 Torr of helium) at a low temperature of 60 °C. While the 2, 4, and 6 nm nanoparticles exhibited similar catalytic activity and selectivity, the 1 nm nanoparticles showed a significantly higher selectivity toward partial oxidation of methanol to formaldehyde, but a lower total turnover frequency. The observed size effect in catalysis was correlated to the size-dependent structure and oxidation state of the Pt nanoparticles. X-ray photoelectron spectroscopy and infrared vibrational spectroscopy using adsorbed CO as molecular probes revealed that the 1 nm nanoparticles were predominantly oxidized while the 2, 4, and 6 nm nanoparticles were largely metallic. Transmission electron microscopy imaging witnessed the transition from crystalline to quasicrystalline structure as the size of the Pt nanoparticles was reduced to 1 nm. The results highlighted the important impact of size-induced oxidation state of Pt nanoparticles on catalytic selectivity as well as activity in gas-phase methanol oxidation reactions.

Structure and chemical state of the Pt(557) surface during hydrogen oxidation reaction studied by in situ scanning tunneling microscopy and X-ray photoelectron spectroscopy.

The surface structure of Pt(557) during the catalytic oxidation of hydrogen was studied with in situ scanning tunneling microscopy and X-ray photoelectron spectroscopy. At 298 K, the surface Pt oxide formed after exposing Pt(557) to approximately 1 Torr of O2 can be readily removed by H2, at H2 partial pressures below 50 mTorr. Water is detected as the product in the gas phase, which also coadsorbs with hydroxyl groups on the Pt(557) surface.

Influence of Step Geometry on the Reconstruction of Stepped Platinum Surfaces under Coadsorption of Ethylene and CO

We demonstrate the critical role of the specific atomic arrangement at step sites in the restructuring processes of low-coordinated surface atoms at high adsorbate coverage. By using high-pressure scanning tunneling microscopy (HP-STM) and ambient-pressure X-ray photoelectron spectroscopy (AP-XPS), we have investigated the reconstruction of Pt(332) (with (111)-oriented triangular steps) and Pt(557) surfaces (with (100)-oriented square steps) in the mixture of CO and C2H4 in the Torr pressure range at room temperature. CO creates Pt clusters at the step edges on both surfaces, although the clusters have different shapes and densities. A subsequent exposure to a similar partial pressure of C2H4 partially reverts the clusters on Pt(332). In contrast, the cluster structure is barely changed on Pt(557). These different reconstruction phenomena are attributed to the fact that the 3-fold (111)-step sites on Pt(332) allows for adsorption of ethylidyne-a strong adsorbate formed from ethylene-that does not form on the 4-fold (100)-step sites on Pt(557).