Zilong Liu

Simulation and Demonstration of Directed XOR/XNOR Logic Gates Using Two Cascaded Microring Resonators

We propose and demonstrate a directed optical logic circuit that can perform the XOR and XNOR logic operations consisting of two cascaded microring resonators, i.e., an upper waveguide and an under waveguide. No waveguide crossings exist in the circuit, which is very useful to improve the signal quality and reduce the insertion loss of the device. As proof of principle, XOR and XNOR logic operations with the speed of 10 kb/s are successfully demonstrated. In addition, numerical simulation results indicate that the length difference between the upper waveguide and the under waveguide can change the output spectrum characteristics of the device, which acts like a Mach–Zehnder interferometer (MZI).

Reconfigurable Electro-optic Logic Circuits Using Microring Resonator-Based Optical Switch Array

In this paper, we propose a reconfigurable electro-optic logic circuit, which can perform any combinatorial logic operations using a microring resonator (MRR)-based optical switching array. The operands are represented by electrical signals, which are applied to the corresponding MRRs to control their switching status. The operation results are directed to the output port in the form of light. For proof of concept, the circuit consisting of four thermooptic MRR-based optical switches is fabricated on the silicon-on-insulator (SOI) substrate using the commercial complementary metal-oxide-semiconductor (CMOS) fabrication process. Finally, several logic operations of four operands with the operation speed of 10 kb/s are demonstrated successfully.

Tunable Fano resonances based on microring resonator with feedback coupled waveguide

We experimentally demonstrate a tunable Fano resonance which originates from the optical interference between two different resonant cavities using silicon micro-ring resonator with feedback coupled waveguide fabricated on silicon-on-insulator (SOI) substrate. The resonance spectrum can be periodically tuned via changing the resonant wavelengths of two resonators through the thermo-optic effect. In addition to this, we can also change the transmission loss of the feedback coupled waveguide (FCW) to tune the resonance spectrum by the injection free carriers to FCW. We also build the theoretical model and we analyze the device performance by using the scattering matrix method. The simulation results are in a good agreement with the experimental results. The measurement maximum extinction ratio of the Fano resonance is as high as 30.8dB. Therefore, the proposed device is a most promising candidate for high on/off ratio optical switching/modulating, high-sensitivity biochemical sensing.

Electro-optic directed XOR logic circuits based on parallel-cascaded micro-ring resonators

We report an electro-optic photonic integrated circuit which can perform the exclusive (XOR) logic operation based on two silicon parallel-cascaded microring resonators (MRRs) fabricated on the silicon-on-insulator (SOI) platform. PIN diodes embedded around MRRs are employed to achieve the carrier injection modulation. Two electrical pulse sequences regarded as two operands of operations are applied to PIN diodes to modulate two MRRs through the free carrier dispersion effect. The final operation result of two operands is output at the Output port in the form of light. The scattering matrix method is employed to establish numerical model of the device, and numerical simulator SG-framework is used to simulate the electrical characteristics of the PIN diodes. XOR operation with the speed of 100Mbps is demonstrated successfully.

All-optical tunable microfiber knot resonator with graphene-assisted sandwich structure

We demonstrate an all-optical tunable microfiber knot resonator (MFKR) by direct light-graphene interaction using external vertical incidence pump laser. The 1530 nm CW pump source is employed to irradiate the sample, which can achieve the performance modulation of MFKR including transmission loss, extinction ratio, and resonant wavelength by the saturable absorption, photo-thermal, and optical Kerr effects, respectively. Compared with the MFKR with only the bottom graphene film, the tunable ranges of transmission loss and extinction ratio are increased by 69 and 125 times, respectively, which can induce a remarkable amplitude tuning. The resonant wavelength of MFKR occurs a red-shift under the irradiation of the pump light, and the red-shift range can exceed one free spectral range (FSR), which means the resonant wavelength could be tuned in the full wavelength range of the transparent window of optical fiber. It is promising for the device to be applied as an all-optical modulator, tunable optical filter, etc.

Experimental demonstration of a reconfigurable electro-optic directed logic circuit using cascaded carrier-injection micro-ring resonators

We experimentally demonstrate a reconfigurable electro-optic directed logic circuit which can perform any combinatorial logic operation using cascaded carrier-injection micro-ring resonators (MRRs), and the logic circuit is fabricated on the silicon-on-insulator (SOI) substrate with the standard commercial Complementary Metal-Oxide-Semiconductor (CMOS) fabrication process. PIN diodes embedded around MRRs are employed to achieve the carrier injection modulation. The operands are represented by electrical signals, which are applied to the corresponding MRRs to control their switching states. The operation result is directed to the output port in the form of light. For proof of principle, several logic operations of three-operand with the operation speed of 100 Mbps are demonstrated successfully.

Optical mode switch based on multimode interference couplers

In this paper, we propose an optical mode switch based on two cascaded multimode interference (MMI) couplers. After a fundamental mode divided into two equal-power fundamental modes in the first MMI coupler, the thermo-optic effect is employed to modulate the phase of the two fundamental modes before directed to the next MMI for the purpose of mode switching. By adjusting the electric signals applied to the modulation arms, the proposed device can implement mode switching in three states: (a) one first-order and two fundamental modes simultaneously output, (b) one first-order mode output, and (c) two fundamental modes output. As a result, the simulated excess losses are −0.29 dB, −0.10 dB, and −0.63 dB, respectively.

Experimental realization of an optical digital comparator using silicon microring resonators

Abstract We propose and experimentally demonstrate a silicon photonic circuit that can perform the comparison operation of two-bit digital signals based on microring resonators (MRRs). Two binary electrical signals regarded as two operands of desired comparison digital signals are applied to three MRRs to modulate their resonances through the microheaters fabricated on the top of MRRs, respectively (here, one binary electrical signal is applied to two MRRs by a 1×2 electrical power splitter, which means that the two MRRs are modulated by the same binary electrical signal). The comparison results of two binary electrical signals can be obtained at two output ports in the form of light. The proposed device is fabricated on a silicon-on-insulator substrate using the complementary metal-oxide-semiconductor fabrication process, and the dynamic characterization of the device with the operation speed of 10 kbps is demonstrated successfully.

Experimental realization of a CMOS-compatible optical directed priority encoder using cascaded micro-ring resonators

Abstract In this paper, we propose and experimentally demonstrate an integrated optical device that can implement the logical function of priority encoding from a 4-bit electrical signal to a 2-bit optical signal. For the proof of concept, the thermo-optic modulation scheme is adopted to tune each micro-ring resonator (MRR). A monochromatic light with the working wavelength is coupled into the input port of the device through a lensed fiber, and the four input electrical logic signals regarded as pending encode signals are applied to the micro-heaters above four MRRs to control the working states of the optical switches. The encoding results are directed to the output ports in the form of light. At last, the logical function of priority encoding with an operation speed of 10 Kbps is demonstrated successfully.

Experimental demonstration of an optical Feynman gate for reversible logic operation using silicon micro-ring resonators

Abstract Currently, the reversible logic circuit is a popular research topic in the field of information processing as it is a most effective approach to minimize power consumption, which can achieve the one-to-one mapping function to identify the input signals from its corresponding output signals. In this letter, we propose and experimentally demonstrate an optical Feynman gate for reversible logic operation using silicon micro-ring resonators (MRRs). Two electrical input signals (logic operands) are applied across the micro-heaters above MRRs to determine the switching states of MRRs, and the reversible logic operation results are directed to the output ports in the form of light, respectively. For proof of concept, the thermo-optic modulation scheme is used to achieve MRR’s optical switching function. At last, a Feynman gate for reversible logic operation with the speed of 10 kbps is demonstrated successfully.