A. Pawełek

Fracture behavior of Mg–Li matrix composites

Abstract Deformation and fracture of Saffil fiber (SF) reinforced Mg, Mg-8 wt.% Li and Mg-12 wt.% Li composites was monitored by means of in-situ scanning electron microscopy during 3-point bend tests. Mg and MgLi matrix composites (10 vol.% SF) were prepared by the melt infiltration technique. Poor interfacial bond causes premature failure of the SF/Mg composite that is usually triggered by the debonding of perpendicular fibers at the convex composite surface. Strong interfaces in SF/Mg12Li composite result in multiple cross-breakage of aligned fibers which is indicative of their participation in the composite strengthening. Resultant composite strengthening is frustrated by massive stress relaxation of the Mg12Li matrix. Strong interfaces and fairly high strength of the Mg8Li matrix cause remarkable strengthening of SF/Mg8Li composites. The cleavage of phases in two-phase Mg8Li matrix plays an insignificant role in the composite failure.

Relation between the plastic instability and fracture of tensile tested Cu-Sn alloys investigated with the application of acoustic emission technique

The work concerns the application of the acoustic emission (AE) method in testing the mechanical properties of continuously cast industrial tin bronze CuSn6P, which reveals tendencies to instable plastic flow connected particularly with the Portevin-Le Chatelier (PLC) effect. The relations between the jerky flow connected with the PLC effect, AE intensity and the evolution of a fracture of the investigated alloy subjected to the tensile test at a strain rate (?? ) of about 1.2·10-3s-1 in the range of temperatures (20÷400?C) has been analyzed. It has been found that the highest intensity of the oscillation of stresses, corresponding to the instability of plastic deformation PLC occurred at 200?C, whereas the maximum of the AE activity is at about 200÷250?C. The brittle intergranular fracture starts in the range of equicohersive temperature (TE) of about 200?C. Plastic deformation of the investigated alloy in the range of the temperature of minimum plasticity, amounting to about 400?C, results in intercrystalline fractures on the entire surface of the stretched samples.

Mechanisms of plastic instability and fracture of compressed and tensile tested Mg-Li alloys investigated using the acoustic emission method

The results of the investigation of both mechanical and acoustic emission (AE) behaviors of Mg4Li5Al alloy subjected to compression and tensile tests at room temperature are compared with the test results obtained using the same alloy and loading scheme but at elevated temperatures. The main aim of the paper is to investigate, to determine and to explain the possible influence of factors related with enhanced internal stresses such as: segregation of precipitates along grain boundaries or solute atoms along dislocations (Cottrell atmospheres) or dislocation pile-ups at grain boundaries which create very high stress concentration leading to fracture. The results show that the plastic instabilities are related to the Portevin–Le Châtelier phenomenon (PL effect) and they are correlated with the generation of AE peaks. The fractography of breaking samples was analyzed on the basis of light (optical), TEM and SEM images.