A. T. Ramsey

Simulations of deuterium-tritium experiments in TFTR

A transport code (TRANSP) is used to simulate future deuterium-tritium (DT) experiments in TFTR. The simulations are derived from 14 TFTR DD discharges, and the modelling of one supershot is discussed in detail to indicate the degree of accuracy of the TRANSP modelling. Fusion energy yields and alpha particle parameters are calculated, including profiles of the alpha slowing down time, the alpha average energy, and the Alfven speed and frequency. Two types of simulation are discussed. The main emphasis is on the DT equivalent, where an equal mix of D and T is substituted for the D in the initial target plasma, and for the D0 in the neutral beam injection, but the other measured beam and plasma parameters are unchanged. This simulation does not assume that alpha heating will enhance the plasma parameters or that confinement will increase with the addition of tritium. The maximum relative fusion yield calculated for these simulations is QDT ~ 0.3, and the maximum alpha contribution to the central toroidal β is βα(0) ~ 0.5%. The stability of toroidicity induced Alfven eigenmodes (TAE) and kinetic ballooning modes (KBM) is discussed. The TAE mode is predicted to become unstable for some of the simulations, particularly after the termination of neutral beam injection. In the second type of simulation, empirical supershot scaling relations are used to project the performance at the maximum expected beam power. The MHD stability of the simulations is discussed

Nondimensional transport scaling in the Tokamak Fusion Test Reactor: Is tokamak transport Bohm or gyro-Bohm?

General plasma physics principles state that power flow Q(r) through a magnetic surface in a tokamak should scale as Q(r)= {32π2Rr3Te2c nea/[eB (a2−r2)2]} F(ρ*,β,ν*,r/a,q,s,r/R,...) where the arguments of F are local, nondimensional plasma parameters and nondimensional gradients. This paper reports an experimental determination of how F varies with normalized gyroradius ρ*≡(2TeMi)1/2c/eBa and collisionality ν*≡(R/r)3/2qRνe(me/ 2Te)1/2 for discharges prepared so that other nondimensional parameters remain close to constant. Tokamak Fusion Test Reactor (TFTR) [D. M. Meade et al., in Plasma Physics and Controlled Nuclear Fusion Research, 1990, Proceedings of the 13th International Conference, Washington (International Atomic Energy Agency, Vienna, 1991), Vol. 1, p. 9] L‐mode data show F to be independent of ρ* and numerically small, corresponding to Bohm scaling with a small multiplicative constant. By contrast, most theories predict gyro‐Bohm scaling: F∝ρ*. Bohm scaling implies that the largest scale size f...

Parallel electric resistivity in the TFTR tokamak

The average parallel resistivity and the location of the q=1 surface are found to be consistent with the predictions of neoclassical transport theory and inconsistent with classical resistivity (uncorrected for toroidal effects) for Ohmic plasmas in the TFTR tokamak [Plasma Physics and Controlled Nuclear Fusion Research 1986 (IAEA, Vienna, 1987), Vol. I, p. 51], both in near‐equilibrium and during ramping of the plasma current. These observations are incompatible with theories predicting anomalous parallel resistivity in concert with anomalous perpendicular transport.

High poloidal beta equilibria in the Tokamak Fusion Test Reactor limited by a natural inboard poloidal field null

Recent operation of the Tokamak Fusion Test Reactor (TFTR) [Plasma Phys. Controlled Nucl. Fusion Research 1, 51 (1986)] has produced plasma equilibria with values of Λ≡βp eq+li/2 as large as 7, eβp dia≡2μ0e〈p⊥〉/〈〈Bp〉〉2 as large as 1.6, and Troyon normalized diamagnetic beta [Plasma Phys. Controlled Fusion 26, 209 (1984); Phys. Lett. 110A, 29 (1985)], βNdia≡108〈βt⊥〉aB0/Ip as large as 4.7. When eβp dia≳1.25, a separatrix entered the vacuum chamber, producing a naturally diverted discharge that was sustained for many energy confinement times, τE. The largest values of eβp and plasma stored energy were obtained when the plasma current was ramped down prior to neutral beam injection. The measured peak ion and electron temperatures were as large as 24 and 8.5 keV, respectively. Plasma stored energy in excess of 2.5 MJ and τE greater than 130 msec were obtained. Confinement times of greater than 3 times that expected from L‐mode predictions have been achieved. The fusion power gain QDD reached a value of 1.3×10−...

First-wall conditioning for enhanced confinement discharges and the DT experiments in TFTR

The conditioning techniques applied to the TFTR first-wall configuration that will be in place for the DT experiments in 1990–1991 are reviewed. Of primary interest is the helium conditioning procedure that was developed to control hydrogenic recycling from the graphite, inner-wall bumper limiter. Operation of TFTR over the plasma density range for gas-fueled ohmic plasmas, ne = (2–5) × 1019m−3, typically results in hydrogenic recycling coefficients near unity. The use of the helium conditioning procedure produced recycling coefficients as low as 0.5, and decreased the minimum ohmic plasma density to ne = 0.5 × 1019m−3 at IP = 0.8 MA. Low density ohmic target plasmas with low recycling conditions are prerequisite conditions for the enhanced confinement (e.g., “supershot”), neutral-beam-heated discharges observed in TFTR during 1986–1987, which is the primary mode being considered for study in the DT experiments. The recycling changes induced by the helium conditioning procedure are believed to be the result of a plasma pumping effect in the graphite induced by He and C ion desorption of hydrogenic species from the near-surface (< 20 nm) layer of the limiter. The capacity of the conditioned limiter to pump gas-fueled, pellet-fueled, and neutral-beam-fueled discharges is compared. The helium conditioning technique is also beneficial for isotopic exchange and for minimizing the in-vessel tritium inventory.

Plasma-material interactions in TFTR

This paper presents a summary of plasma-material interactions which influence the operation of TFTR with high current (≤ 2.2 MA) ohmically heated, and high-power (∼ 10 MW) neutral-beam heated plasmas. The conditioning procedures which are applied routinely to the first-wall hardware are reviewed. Fueling characteristics during gas, pellet, and neutral-beam fueling are described. Recycling coefficients near unity are observed for most gas fueled discharges. Gas fueled discharges after helium discharge conditioning of the toroidal bumper limiter, and discharges fueled by neutral beams and pellets, show R<1. In the vicinity of the gas fueled density limit (at ne = 5–6 × 1019 m−3) values of Zeff are ≦1.5. Increases in Zeff of ≦1 have been observed with neutral beam heating of 10 MW. The primary low Z impurity is carbon with concentrations decreasing from ∼10% to <1% with increasing ne. Oxygen densities tend to increase with ne, and at the ohmic plasma density limit oxygen and carbon concentrations are comparable. Chromium getter experiments and He2+/D+ plasma comparisons indicate that the limiter is the primary source of carbon and that the vessel wall is a significant source of the oxygen impurity. Metallic impurities, consisting of the vacuum vessel metals (Ni, Fe, Cr) have significant (∼10−4 ne) concentrations only at low plasma densities (ne <1019 m−3). The primary source of metallic impurities is most likely ion sputtering from metals deposited on the carbon limiter surface.

D‐T radiation effects on TFTR diagnostics (invited)

For a 50%‐50% deuterium‐tritium plasma, the neutron production is 80× higher and the total‐energy release is 200× higher than the same plasma composed only of deuterium. With this increase in radiation, diagnostics which see only negligible amounts of noise during DD operation may find themselves overwhelmed during DT. The neutrons are not only more numerous, but have 6× as much energy, which causes the calculated 2.5× increase in the gamma flux per neutron near TFTR. Here the effects of this increased radiation on the TFTR diagnostics set are reported. The most noticeable effects are luminescence and transmission losses in fiber‐optic signal cables. Silicon detectors show signs of neutron interactions as well as gamma response, and microchannel electron multipliers show an increased background due to the gamma flux. Bolometers show n and γ heating, and the Thomson scattering intensifier gate spark gap was unreliable until the gas pressure was adjusted. All of these effects were anticipated, and in many c...

Modeling of neutral hydrogen velocities in the Tokamak Fusion Test Reactor

Monte Carlo neutral transport simulations of hydrogen velocities in the Tokamak Fusion Test Reactor (TFTR) [K. M. McGuire et al., Phys. Plasmas 2, 2176 (1995)] are compared with experiment using the Doppler‐broadened Balmer‐α spectral line profile. Good agreement is obtained under a range of conditions, validating the treatment of charge exchange, molecular dissociation, surface reflection, and sputtering in the neutral gas code DEGAS [D. Heifetz et al., J. Comput. Phys. 46, 309 (1982)]. A residual deficiency of 10–100 eV neutrals in most of the simulations indicates that further study of the energetics of H+2 dissociation for electron energies in excess of 100 eV is needed.

Overview of TFTR transport studies

A review of TFTR plasma transport studies is presented. Parallel transport and the confinement of suprathermal ions are found to be relatively well described by theory. Cross-field transport of the thermal plasma, however, is anomalous with the momentum diffusivity being comparable to the ion thermal diffusivity and larger than the electron thermal diffusivity in neutral beam heated discharges. Perturbative experiments have studied nonlinear dependencies in the transport coefficients and examined the role of possible nonlocal phenomena. The underlying turbulence has been studied using microwave scattering, beam emission spectroscopy and microwave reflectometry over a much broader range in k perpendicular to than previously possible. Results indicate the existence of large-wavelength fluctuations correlated with enhanced transport.

Correlations of heat and momentum transport in the TFTR tokamak

Measurements of the toroidal rotation speed vφ(r) driven by neutral beam injection in tokamak plasmas and, in particular, simultaneous profile measurements of vφ, Ti, Te, and ne, have provided new insights into the nature of anomalous transport in tokamaks. Low‐recycling plasmas heated with unidirectional neutral beam injection exhibit a strong correlation among the local diffusivities, χφ≊χi>χe. Recent measurements have confirmed similar behavior in broad‐density L‐mode plasmas. These results are consistent with the conjecture that electrostatic turbulence is the dominant transport mechanism in the tokamak fusion test reactor tokamak (TFTR) [Phys. Rev. Lett. 58, 1004 (1987)], and are inconsistent with predictions both from test‐particle models of strong magnetic turbulence and from ripple transport. Toroidal rotation speed measurements in peaked‐density TFTR ‘‘supershots’’ with partially unbalanced beam injection indicate that momentum transport decreases as the density profile becomes more peaked. In hi...