A. Vecchio

High-precision timing of 42 millisecond pulsars with the European Pulsar Timing Array

We report on timing, flux density, and polarimetric observations of the transient magnetar and 5.54 s radio pulsar XTE J1810-197 using the GBT, Nancay, and Parkes radio telescopes beginning in early 2006, until its sudden disappearance as a radio source in late 2008. Repeated observations through 2016 have not detected radio pulsations again. The torque on the neutron star, as inferred from its rotation frequency derivative f-dot, decreased in an unsteady manner by a factor of 3 in the first year of radio monitoring. In contrast, during its final year as a detectable radio source, the torque decreased steadily by only 9%. The period-averaged flux density, after decreasing by a factor of 20 during the first 10 months of radio monitoring, remained steady in the next 22 months, at an average of 0.7+/-0.3 mJy at 1.4 GHz, while still showing day-to-day fluctuations by factors of a few. There is evidence that during this last phase of radio activity the magnetar had a steep radio spectrum, in contrast to earlier behavior. There was no secular decrease that presaged its radio demise. During this time the pulse profile continued to display large variations, and polarimetry indicates that the magnetic geometry remained consistent with that of earlier times. We supplement these results with X-ray timing of the pulsar from its outburst in 2003 up to 2014. For the first 4 years, XTE J1810-197 experienced non-monotonic excursions in f-dot by at least a factor of 8. But since 2007, its f-dot has remained relatively stable near its minimum observed value. The only apparent event in the X-ray record that is possibly contemporaneous with the radio shut-down is a decrease of ~20% in the hot-spot flux in 2008-2009, to a stable, minimum value. However, the permanence of the high-amplitude, thermal X-ray pulse, even after the radio demise, implies continuing magnetar activity.

Status of the GEO600 detector

Of all the large interferometric gravitational-wave detectors, the German/British project GEO600 is the only one which uses dual recycling. During the four weeks of the international S4 data-taking run it reached an instrumental duty cycle of 97% with a peak sensitivity of 7 × 10−22 Hz−1/2 at 1 kHz. This paper describes the status during S4 and improvements thereafter.

Update on quadruple suspension design for Advanced LIGO

We describe the design of the suspension systems for the major optics for Advanced LIGO, the upgrade to LIGO—the Laser Interferometric Gravitational-Wave Observatory. The design is based on that used in GEO600—the German/UK interferometric gravitational wave detector, with further development to meet the more stringent noise requirements for Advanced LIGO. The test mass suspensions consist of a four-stage or quadruple pendulum for enhanced seismic isolation. To minimize suspension thermal noise, the final stage consists of a silica mirror, 40 kg in mass, suspended from another silica mass by four silica fibres welded to silica ears attached to the sides of the masses using hydroxide-catalysis bonding. The design is chosen to achieve a displacement noise level for each of the seismic and thermal noise contributions of 10^(−19) m/√Hz at 10 Hz, for each test mass. We discuss features of the design which has been developed as a result of experience with prototypes and associated investigations.

European Pulsar Timing Array Limits on Continuous Gravitational Waves from Individual Supermassive Black Hole Binaries

We have searched for continuous gravitational wave (CGW) signals produced by individually resolvable, circular supermassive black hole binaries (SMBHBs) in the latest European Pulsar Timing Array (EPTA) data set, which consists of ultraprecise timing data on 41-ms pulsars. We develop frequentist and Bayesian detection algorithms to search both for monochromatic and frequency-evolving systems. None of the adopted algorithms show evidence for the presence of such a CGW signal, indicating that the data are best described by pulsar and radiometer noise only. Depending on the adopted detection algorithm, the 95 per cent upper limit on the sky-averaged strain amplitude lies in the range 6 × 10−15 10^9M⊙ out to a distance of about 25 Mpc, and with Mc > 10^10M⊙ out to a distance of about 1Gpc (z ≈ 0.2). We show that state-of-the-art SMBHB population models predict <1 per cent probability of detecting a CGW with the current EPTA data set, consistent with the reported non-detection. We stress, however, that PTA limits on individual CGW have improved by almost an order of magnitude in the last five years. The continuing advances in pulsar timing data acquisition and analysis techniques will allow for strong astrophysical constraints on the population of nearby SMBHBs in the corning years.

The status of GEO 600

The GEO 600 laser interferometer with 600m armlength is part of a worldwide network of gravitational wave detectors. GEO 600 is unique in having advanced multiple pendulum suspensions with a monolithic last stage and in employing a signal recycled optical design. This paper describes the recent commissioning of the interferometer and its operation in signal recycled mode.

Towards a generic test of the strong field dynamics of general relativity using compact binary coalescence

Coalescences of binary neutron stars and/or black holes are amongst the most likely gravitational-wave signals to be observed in ground based interferometric detectors. Apart from the astrophysical importance of their detection, they will also provide us with our very first empirical access to the genuinely strong-field dynamics of General Relativity (GR). We present a new framework based on Bayesian model selection aimed at detecting deviations from GR, subject to the constraints of the Advanced Virgo and LIGO detectors. The method tests the consistency of coefficients appearing in the waveform with the predictions made by GR, without relying on any specific alternative theory of gravity. The framework is suitable for low signal-to-noise ratio events through the construction of multiple subtests, most of which involve only a limited number of coefficients. It also naturally allows for the combination of information from multiple sources to increase ones confidence in GR or a violation thereof. We expect it to be capable of finding a wide range of possible deviations from GR, including ones which in principle cannot be accommodated by the model waveforms, on condition that the induced change in phase at frequencies where the detectors are the most sensitive is comparable to the effect of a few percent change in one or more of the low-order post-Newtonian phase coefficients. In principle the framework can be used with any GR waveform approximant, with arbitrary parameterized deformations, to serve as model waveforms. In order to illustrate the workings of the method, we perform a range of numerical experiments in which simulated gravitational waves modeled in the restricted post-Newtonian, stationary phase approximation are added to Gaussian and stationary noise that follows the expected Advanced LIGO/Virgo noise curves.

The LISA verification binaries

The Laser Interferometer Space Antenna (LISA) guarantees the detection of gravitational waves by monitoring a handful of known nearby galactic binary systems, the so-called verification binaries. We consider the most updated information on the source parameters for the 30 more promising verification binaries. We investigate which of them are indeed guaranteed sources for LISA and estimate the accuracy of the additional information that can be extracted during the mission. Our analysis considers the two independent Michelson outputs that can be synthesized from the LISA constellation, and we model the LISA transfer function using the rigid adiabatic approximation. We carry out extensive Monte Carlo simulations to explore the dependency of our results on unknown or poorly constrained source parameters. We find that four sources-RXJ0806.3+1527, V407 Vul, ES Cet and AM CVn-are clearly detectable in one year of observation; RXJ0806.3+1527 should actually be observable in less than a week. For these sources LISA will also provide information on yet unknown parameters with an error between ≈1% and ≈10%. Four additional binary systems-HP Lib, 4U 1820-30, WZ Sge and KPD 1930+2752-might also be marginally detectable.

Gravitational waves and pulsar timing: stochastic background, individual sources and parameter estimation

Massive black holes are key ingredients of the assembly and evolution of cosmic structures. Pulsar Timing Arrays (PTAs) currently provide the only means to observe gravitational radiation from massive black hole binary systems with masses ≳ 10 7 M ⊙ . The whole cosmic population produces a signal consisting of two components: (i) a stochastic background resulting from the incoherent superposition of radiation from the all the sources, and (ii) a handful of individually resolvable signals that raise above the background level and are produced by sources sufficiently close and/or massive. Considering a wide range of massive black hole binary assembly scenarios, we investigate both the level and shape of the background and the statistics of resolvable sources. We predict a characteristic background amplitude in the interval h c (f = 10 -8 Hz) ≈ 5 x 10 -16 -5 × 10 -15 , within the detection range of the complete Parkes PTA. On average, at least one resolvable source produces timing residuals that integrated over the typical time of observation lay in the range ∼5-50 ns. We also quantify the capability of PTAs of measuring the parameters of individual sources, focusing on the astrophysically more likely monochromatic signals produced by binaries in circular orbit. We investigate how the results depend on the number and distribution of pulsars in the array, by computing the variance-covariance matrix of the parameter measurements. For plausible Square Kilometre Array (SKA) observations (100 pulsars uniformly distributed in the sky), and assuming a coherent signal-to-noise ratio of 10, the sky position of massive black hole binaries can be located within an ≈ 40 deg 2 error box, opening promising prospects for detecting a putative electromagnetic counterpart to the gravitational wave emission. The planned SKA can plausibly observe these unique systems, although the number of detections is likely to be small. These observations would naturally complement on the high-mass end of the black hole distribution function future surveys carried out by the Laser Interferometer Space Antenna (LISA).

Sensors and actuators for the Advanced LIGO mirror suspensions

We have developed, produced and characterized integrated sensors, actuators and the related read-out and drive electronics that will be used for the control of the Advanced LIGO suspensions. The overall system consists of the BOSEMs (a displacement sensor with an integrated electromagnetic actuator), the satellite boxes (the BOSEM readout and interface electronics) and six different types of coil-driver units. In this paper, we present the design of this read-out and control system, we discuss the related performance relevant for the Advanced LIGO suspensions, and we report on the experimental activity finalized at the production of the instruments for the Advanced LIGO detectors.

From spin noise to systematics: stochastic processes in the first International Pulsar Timing Array data release

We analyse the stochastic properties of the 49 pulsars that comprise the first International Pulsar Timing Array (IPTA) data release. We use Bayesian methodology, performing model selection to determine the optimal description of the stochastic signals present in each pulsar. In addition to spin-noise and dispersion-measure (DM) variations, these models can include timing noise unique to a single observing system, or frequency band. We show the improved radio-frequency coverage and presence of overlapping data from different observing systems in the IPTA data set enables us to separate both system and band-dependent effects with much greater efficacy than in the individual PTA data sets. For example, we show that PSR J1643−1224 has, in addition to DM variations, significant band-dependent noise that is coherent between PTAs which we interpret as coming from time-variable scattering or refraction in the ionised interstellar medium. Failing to model these different contributions appropriately can dramatically alter the astrophysical interpretation of the stochastic signals observed in the residuals. In some cases, the spectral exponent of the spin noise signal can vary from 1.6 to 4 depending upon the model, which has direct implications for the long-term sensitivity of the pulsar to a stochastic gravitational-wave (GW) background. By using a more appropriate model, however, we can greatly improve a pulsars sensitivity to GWs. For example, including system and band-dependent signals in the PSR J0437−4715 data set improves the upper limit on a fiducial GW background by ∼ 60% compared to a model that includes DM variations and spin-noise only.