Andrea Speltini

Photochemical degradation of marbofloxacin and enrofloxacin in natural waters.

The photochemical fate of Marbofloxacin (MAR) and Enrofloxacin (ENR), two Fluoroquinolones (FQs) largely used as veterinary bactericides known to be present in surface waters, was investigated in aqueous solution. The degradation of these pollutants (5-50 microg L(-1) starting concentration) was complete in about 1 h by exposure to solar light (summer) and obeyed a first-order kinetics. The structure of the primary photoproducts was determined. Those from ENR arose through three paths, namely, oxidative degradation of the piperazine side-chain, reductive defluorination, and fluorine solvolysis. More heavily degraded products that had been previously reported were rationalized as secondary photoproducts from the present ones. As for MAR, this underwent homolytic cleavage of the tetrahydrooxadiazine moiety to give two quinolinols. All of the primary products were themselves degraded in about 1 h. The photoreactions rates were scarcely affected by Ca(2+) (200 mg L(-1)), Mg(2+) (30 mg L(-1)), Cl(-) (30 mg L(-1)), and humic acid (1 mg L(-1)), but increased in the presence of phosphate (20 mg L(-1)). The fastest degradation of ENR occurred at pH about 8 where the zwitterionic form was present, while in the case of MAR the cationic form was the most reactive.

Separation of alkanes and aromatic compounds by packed column gas chromatography using functionalized multi-walled carbon nanotubes as stationary phases.

In the present work, we show a novel application of pristine and functionalized Multi-Walled Carbon Nanotubes (MWCNTs) as stationary phase in low-cost packed columns for the gas chromatographic separation of alkanes and aromatic hydrocarbons. The MWCNTs were deeply investigated by means of physical and chemical methods, like thermal analysis, IR and atomic force microscopy, and Inverse Gas Chromatography (IGC) in order to correlate the adsorption process and surface properties with the material purity level and functionalization degree. The derivatization process of the pristine nanotubes was a key factor to achieve a successful separation of both the light n-alkanes (C3-C5) and the related isomers (C4-C5 branched alkanes). Satisfactory results were similarly obtained in the case of separation of aromatic hydrocarbons (BTX).

Fluoroquinolone antibiotics in environmental waters: sample preparation and determination.

The aim of this review is to provide a general overview on the analytical methods proposed in the last decade for trace fluoroquinolone (FQ) determination in environmental waters. A large number of studies have been developed on this topic in reason of the importance of their monitoring in the studies of environmental mobility and potential degradation pathways. Every step of the analysis has been carefully considered, with a particular attention to sample preparation, in relationship with the problems involved in the analysis of real matrices. The different strategies to minimise interference from organic matter and to achieve optimal sensitivity, especially important in those samples with lower FQ concentrations, were also highlighted. Results and progress in this field have been described and critically commented. Moreover, a worldwide overview on the presence of FQs in the environmental waters has been reported.

Analytical application of carbon nanotubes, fullerenes and nanodiamonds in nanomaterials-based chromatographic stationary phases: A review

An overview of the most significative results so far attained in the application of carbon nanotubes, fullerenes and nanodiamonds as chromatographic separation media is presented. In particular, the authors focus on their use in capillary and packed-column gas chromatography, in high performance liquid chromatography and capillary electrochromatography, paying also attention to recently developed stationary phases for fast chromatography and nanochromatography. The performance of the nanomaterials is compared to that of planar and amorphous carbon sorbents and critically discussed in regard to retentive capability and selectivity. A wide part of this review is devoted to the most recent improvements achieved in terms of selectivity by use of functionalized nanotubes and by combination of carbon nanotubes with ionic liquids. Practical aspects of synthetic procedures in preparing novel stationary phases in relationship with their chromatographic behaviour are also commented.

Improving selectivity in gas chromatography by using chemically modified multi-walled carbon nanotubes as stationary phase.

Amino-terminated alkyl MWCNTs (MWCNTs-R-NH2), synthesized by chemical modification of the nanotube skeleton by nucleophilic substitution with 2,2′-(ethylenedioxy)diethylamine, were successfully used as stationary phases for gas chromatographic separation of esters and chloroaromatics. The presence of alkyl chains with polar embedded groups made the functionalized MWCNTs (f-MWCNTs) a mixed-mode GC separation material able to interact in different ways with the analytes. Compared with non-functionalized MWCNTs (nf-MWCNTs), MWCNTs-R-NH2 had higher selectivity, enhanced resolution, and optimum retention behaviour, and they were proved to perform better than the commercial stationary phase Porapak QS (PQS), claimed to be suitable for similar applications. The so-prepared stationary phase was used for analysis of a synthetic mixture containing different classes of analytes, viz. esters, ketones, alcohols, alkanes, and aromatic hydrocarbons, and finally used for investigation of similar real matrices. In particular, the constituents of a commercial paint thinner were determined by direct injection of the sample, with good reproducibility (inter-day precision RSDs from 5 to 19%). Two unknown samples of commercial white spirit were also analysed for determination of the aromatic hydrocarbon content, and their composition was profiled on the basis of the different compounds identified.

Sunlight-induced degradation of soil-adsorbed veterinary antimicrobials Marbofloxacin and Enrofloxacin

Marbofloxacin (MAR) and Enrofloxacin (ENR), two largely employed veterinary Fluoroquinolones (FQs), were found to be present at the micrograms per kilogram level in agricultural soils of South Lombardy (Italy) several months after manuring. Distribution coefficients (K(d)) from sorption experiments indicated a strong binding to the soil. Soil samples fortified with environmentally significant FQs amounts (0.5 mg kg(-1)) were exposed to solar light that promoted extensive degradation (80%) of both drugs in 60-150 h. Thus, photochemistry could be considered a significant depollution path in the soil, although it was two orders of magnitudes slower than in aqueous solution and a fraction of the drug (ca. 20%) remained unaffected. For MAR the photoprocess was the same as in solution, and involved cleavage of the tetrahydrooxadiazine ring. On the contrary, with ENR only some of the photoproducts determined in water (those arising from a stepwise oxidation of the piperazine side chain) were observed. Substitution of the 6-fluoro by a hydroxyl group and reduction did not occur in the soil, supporting the previous contention that such processes required polar solvation of FQs. Consistently with this rationalization, the irradiation of thin layers of solid drugs led to essentially the same products distribution as in the soil. From the environmental point of view it is important to notice that photodegradation mainly affects the side-chains, while the fluoroquinolone ring, to which the biological effect is associated, is conserved up to the later stages of the degradation.

Solid-phase extraction and HPLC determination of fluoroquinolones in surface waters

An investigation on filtration procedures and SPE sorbents used for the determination of traces of the most common veterinary fluoroquinolones (FQs), marbofloxacin (MAR) and enrofloxacin (ENR) used as antibacterial agents in cattle and swine farms in the province of Pavia (Italy), was performed in natural waters. The filter composition and the sorbent used in the SPE strongly influence the correct recovery, both in terms of total and dissolved FQs concentration. An accurate comparison among different filters and SPE sorbents showed that a full determination of analytes was possible on nylon filters followed by anionic (WAX) and hydrophilic-lipophilic balance (HLB) resins as SPE. Quantitative analysis was done by chromatography with fluorescence detection (HPLC-FD). Fluoroquinolones recovery was between 90 and 116% with RSD not greater than 10% (sample volume 250 mL). The developed method allowed to determine both dissolved and NOM-absorbed fractions of FQs, therefore a full determination of the analytes was possible. Limits of detection (LOD) and quantification (LOQ) were, respectively, 0.7 and 2.2 ng/L for ENR and 2 and 6 ng/L for MAR. The kinetics of degradation under solar light was explored.

Graphene-derivatized silica as an efficient solid-phase extraction sorbent for pre-concentration of fluoroquinolones from water followed by liquid-chromatography fluorescence detection.

This work presents a novel analytical method based on graphene for the determination of five widely used fluoroquinolones (FQs) in aqueous matrices. The procedure entails solid-phase extraction (SPE) on graphene-derivatized silica (200mg), followed by liquid chromatography with fluorescence detection. Monolayer graphene oxide (GO) flakes were covalently bonded onto aminopropyl silica microparticles, and then treated with aqueous hydrazine to obtain the reduced GO (RGO). The final material (RGO-silica) was characterized by thermogravimetric analysis (TGA), scanning electron microscopy (SEM) and BET analysis, and for the first time evaluated as mixed-mode sorbent for the SPE of FQs from natural waters. Accuracy was studied on tap/raw river water in the concentration range 5-10,000ngL(-1), obtaining mean absolute recoveries from 72 to 118%. The inter-day precision was good, showing relative standard deviations (RSDs) in the range 5-15%. Sample volumes up to 1L provided enrichment factors up to 1000, achieving accurate quantification of concentrations as low as 5ngL(-1). The analytes were simultaneously and quantitatively eluted from the RGO-silica cartridge in a single fraction by using acetonitrile combined with aqueous tetrabutyl ammonium hydroxide. The batch-to-batch reproducibility was verified on three independently prepared RGO-silica samples. RGO-silica was advantageous in terms of adsorption capacity and reusability with respect to commercial sorbents; the cartridge proved to be reusable for at least 10 consecutive extractions, with no significant loss of efficiency (recovery >70%). The analytical procedure was applied to the determination of FQs in actual environmental waters.

Newest applications of molecularly imprinted polymers for extraction of contaminants from environmental and food matrices: A review

This paper presents an overview of the recent applications of molecularly imprinted polymers (MIPs) to sample preparation. The review is thought to cover analytical procedures for extraction of contaminants (mainly illegal/noxious organic compounds) from food and environmental matrices, with a particular focus on the various pre-concentration/cleanup techniques, that is offline and online solid-phase extraction (SPE), dispersive SPE (d-SPE), magnetic SPE (MSPE), solid-phase microextraction (SPME) and stir-bar sorptive extraction (SBSE), applied before instrumental quantification. The selectivity and extraction efficiency of MIP-based sorbent phases are critically discussed, also in relation to the physical-chemical properties resulting from the synthetic procedures. A variety of molecularly imprinted sorbents is presented, including hybrid composites embedding carbon nanomaterials and ionic liquids. The analytical performance of MIP materials in sample preparation is commented as function of the complexity of the matrix, and it is compared to that exhibited by (commercial) aspecific and/or immunosorbent phases.

Solvent-free microwave-assisted extraction of fluoroquinolones from soil and liquid chromatography-fluorescence determination

Presented hereafter is a novel method entailing solvent free microwave-assisted extraction (MAE) and HPLC equipped with Fluorimetric Detector (HPLC-FD) for the simultaneous determination at μgkg(-1) concentration of eight fluoroquinolone antibiotics (FQs) (Ciprofloxacin, Danofloxacin, Enrofloxacin, Flerofloxacin, Levofloxacin, Marbofloxacin, Norfloxacin and Orbifloxacin) in agricultural soils. The extraction was quantitatively performed, in a single step, by using an aqueous solution containing Mg(II) as complexing agent, thus avoiding consumption of organic solvents. The optimal MAE conditions have been established through a chemometric approach by considering temperature, irradiation time and matrix moisture or solvent, as the most important recognized variables affecting the extraction yield. Satisfying recoveries (69-110%, spikes 0.03-0.5mgkg(-1)) were gained with a single MAE cycle of 20min, at 80°C in 20% (w/v) Mg(NO(3))(2) solution as leaching agent. MAE-SPE recoveries at 10μgkg(-1), concentration near method quantification limits (MQLs), were in the range 60-85%. Good repeatability and within-lab reproducibility were observed (both in the range 1-16%). The applicability of the method to real samples was assessed on natural contaminated soils. Compared to ultrasonic-assisted extraction (UAE), MAE was shown to be highly competitive in terms of extraction efficacy and analysis speed.