B. Aja

The Quijote CMB Experiment

We present the current status of the QUIJOTE (Q-U-I JOint TEnerife) CMB Experiment, a new instrument which will start operations early in 2009 at Teide Observatory with the aim of characterizing the polarization of the CMB and other processes of galactic and extragalactic emission in the frequency range 10–30GHz and at large angular scales. QUIJOTE will be a valuable complement at low frequencies for the PLANCK mission, and will have the required sensitivity to detect a primordial gravitational-wave component if the tensor-to-scalar ratio is larger than r = 0.05.

Very low-noise differential radiometer at 30 GHz for the PLANCK LFI

The PLANCK mission of the European Space Agency is devoted to produce sky maps of the cosmic microwave background radiation. The low-frequency instrument is a wide-band cryogenic microwave radiometer array operating at 30, 44, and 70 GHz. The design, test techniques, and performance of the complete differential radiometer at 30 GHz are presented. This elegant breadboard 30-GHz radiometer is composed of a front-end module (FEM) assembled at the Jodrell Bank Observatory, Cheshire, U.K., and a back-end module assembled at the Universidad de Cantabria, Cantabria, Spain, and Telecomunicacio/spl acute/, Universitat Polite/spl acute/cnica de Catalunya, Barcelona, Spain. The system noise temperature was excellent, mainly due to the very low noise performance of the FEM amplifiers, which achieved an average noise temperature of 9.4 K.

Design, development and verification of the 30 and 44 GHz front-end modules for the Planck Low Frequency Instrument

We give a description of the design, construction and testing of the 30 and 44 GHz Front End Modules (FEMs) for the Low Frequency Instrument (LFI) of the Planck mission to be launched in 2009. The scientific requirements of the mission determine the performance parameters to be met by the FEMs, including their linear polarization characteristics. The FEM design is that of a differential pseudo-correlation radiometer in which the signal from the sky is compared with a 4-K blackbody load. The Low Noise Amplifier (LNA) at the heart of the FEM is based on indium phosphide High Electron Mobility Transistors (HEMTs). The radiometer incorporates a novel phase-switch design which gives excellent amplitude and phase match across the band. The noise temperature requirements are met within the measurement errors at the two frequencies. For the most sensitive LNAs, the noise temperature at the band centre is 3 and 5 times the quantum limit at 30 and 44 GHz respectively. For some of the FEMs, the noise temperature is still falling as the ambient temperature is reduced to 20 K. Stability tests of the FEMs, including a measurement of the 1/f knee frequency, also meet mission requirements. The 30 and 44 GHz FEMs have met or bettered the mission requirements in all critical aspects. The most sensitive LNAs have reached new limits of noise temperature for HEMTs at their band centres. The FEMs have well-defined linear polarization characteristcs.

Noise properties of the Planck-LFI receivers

The Planck Low Frequency Instrument (LFI) radiometers have been tested extensively during several dedicated campaigns. The present paper reports the principal noise properties of the LFI radiometers. A brief description of the LFI radiometers is given along with details of the test campaigns relevant to determination of noise properties. Current estimates of flight sensitivities, 1/f parameters, and noise effective bandwidths are presented. The LFI receivers exhibit exceptional 1/f noise, and their white noise performance is sufficient for the science goals of Planck.

The QUIJOTE-CMB experiment: studying the polarisation of the galactic and cosmological microwave emissions

The QUIJOTE (Q-U-I JOint Tenerife) CMB Experiment will operate at the Teide Observatory with the aim of characterizing the polarisation of the CMB and other processes of Galactic and extragalactic emission in the frequency range of 10-40GHz and at large and medium angular scales. The first of the two QUIJOTE telescopes and the first multi-frequency (10-30GHz) instrument are already built and have been tested in the laboratory. QUIJOTE-CMB will be a valuable complement at low frequencies for the Planck mission, and will have the required sensitivity to detect a primordial gravitational-wave component if the tensor-to-scalar ratio is larger than r = 0.05.

LFI 30 and 44 GHz receivers Back-End Modules

The 30 and 44 GHz Back End Modules (BEM) for the Planck Low Frequency Instrument are broadband receivers (20% relative bandwidth) working at room temperature. The signals coming from the Front End Module are amplified, band pass filtered and finally converted to DC by a detector diode. Each receiver has two identical branches following the differential scheme of the Planck radiometers. The BEM design is based on MMIC Low Noise Amplifiers using GaAs P-HEMT devices, microstrip filters and Schottky diode detectors. Their manufacturing development has included elegant breadboard prototypes and finally qualification and flight model units. Electrical, mechanical and environmental tests were carried out for the characterization and verification of the manufactured BEMs. A description of the 30 and 44 GHz Back End Modules of Planck-LFI radiometers is given, with details of the tests done to determine their electrical and environmental performances. The electrical performances of the 30 and 44 GHz Back End Modules: frequency response, effective bandwidth, equivalent noise temperature, 1/f noise and linearity are presented.

System Simulation of a Differential Radiometer Using Standard RF-Microwave Simulators

A complete radiometer simulation framework with special emphasis on high frequencies and switched system performance is proposed. The simulation procedures have been tested on a system configuration used in a branch of the 30-GHz Planck Radiometer, which detects radiation from the cosmic microwave background in a window with 20% relative bandwidth centered at 30 GHz. The goal of the article is not to obtain detailed conclusions about this radiometer in particular but to test the viability of proposed techniques in a realistic context. Basic RF performance of an ideal and a more realistic version of the radiometer is compared. Furthermore, the whole system simulation is implemented in the frequency domain and the time domain, on the same platform that is used to design separate microwave components, introducing realistic parameters for the high-frequency components, such us measured S parameters of the amplifiers and measured current-voltage characteristics of the detectors.

The thirty gigahertz instrument receiver for the Q-U-I Joint Tenerife experiment: concept and experimental results

This paper presents the analysis, design, and characterization of the thirty gigahertz instrument receiver developed for the Q-U-I Joint Tenerife experiment. The receiver is aimed to obtain polarization data of the cosmic microwave background radiation from the sky, obtaining the Q, U, and I Stokes parameters of the incoming signal simultaneously. A comprehensive analysis of the theory behind the proposed receiver is presented for a linearly polarized input signal, and the functionality tests have demonstrated adequate results in terms of Stokes parameters, which validate the concept of the receiver based on electronic phase switching.

A single chip broadband noise source for noise measurements at cryogenic temperatures

This paper presents the design and performance of a single chip broadband noise source dedicated for on-chip measurements in a cryogenic environment. The noise source is used to generate the two input noise powers Pc and Ph which are required by the commonly used Y-factor method. High accuracy in temperature control and impedance presented to the device under test is achieved over a wide temperature range from 7 K to 100 K. Noise temperature measurements of a cryogenic low noise amplifier were performed on-chip and show a typical accuracy of ±1 K.

Stability Investigation of Large Gate-Width Metamorphic High Electron-Mobility Transistors at Cryogenic Temperature

An investigation of metamorphic high electron mobility transistor stability at cryogenic temperature is presented in this paper. Unlike in the case of two-finger transistors, the measurements of cooled four-finger devices with large gate widths exhibit unstable behavior in the form of steps in the current-voltage characteristics, discontinuities in the transconductance, and reduced gain. This unstable behavior has hampered the reliable realization of low-noise amplifiers for cryogenic applications. We study different gate-width devices with a multiport transistor model, allowing the separation of gate and drain feeder structures from the active part of the transistor. The simulation reveals the presence of resonances in the frequency region of several hundreds of gigahertz. We demonstrate that the resonances disappear when an air bridge is placed across the fingers of the drain feeder structure, and confirm the stabilizing effect of the air bridge both on device and circuit level by cryogenic measurements.