Brian S. Aitken

Dechlorination comparison of mono-substituted PCBs with Mg/Pd in different solvent systems

It is widely recognized that polychlorinated biphenyls (PCBs) are a dangerous environmental pollutant. Even though the use and production of PCBs have been restricted, heavy industrial use has made them a wide-spread environmental issue today. Dehalogenation using zero-valent metals has been a promising avenue of research for the remediation of chlorinated compounds and other contaminants that are present in the environment. However, zero-valent metals by themselves have shown little capability of dechlorinating polychlorinated biphenyls (PCBs). Mechanically alloying the metal with a catalyst, such as palladium, creates a bimetallic system capable of dechlorinating PCBs very rapidly to biphenyl. This study primarily aims to evaluate the effects of solvent specificity on the kinetics of mono-substituted PCBs, in an attempt to determine the mechanism of degradation. Rate constants and final byproducts were determined for the contaminant systems in both water and methanol, and significant differences in the relative rates of reaction were observed between the two solvents.

The use of mechanical alloying for the preparation of palladized magnesium bimetallic particles for the remediation of PCBs

The kinetic rate of dechlorination of a polychlorinated biphenyl (PCB-151) by mechanically alloyed Mg/Pd was studied for optimization of the bimetallic system. Bimetal production was first carried out in a small-scale environment using a SPEX 8000M high-energy ball mill with 4-μm-magnesium and palladium impregnated on graphite, with optimized parameters including milling time and Pd-loading. A 5.57-g sample of bimetal containing 0.1257% Pd and ball milled for 3 min resulted in a degradation rate of 0.00176 min(-1)g(-1) catalyst as the most reactive bimetal. The process was then scaled-up, using a Red Devil 5400 Twin-Arm Paint Shaker, fitted with custom plates to hold milling canisters. Optimization parameters tested included milling time, number of ball bearings used, Pd-loading, and total bimetal mass milled. An 85-g sample of bimetal containing 0.1059% Pd and ball-milled for 23 min with 16 ball bearings yielded the most reactive bimetal with a degradation rate of 0.00122 min(-1)g(-1) catalyst. Further testing showed adsorption did not hinder extraction efficiency and that dechlorination products were only seen when using the bimetallic system, as opposed to any of its single components. The bimetallic system was also tested for its ability to degrade a second PCB congener, PCB-45, and a PCB mixture (Arochlor 1254); both contaminants were seen to degrade successfully.