C. Christensen

First results from Alcator-C-MOD

Early operation of the Alcator‐C‐MOD tokamak [I.H. Hutchinson, Proceedings of IEEE 13th Symposium on Fusion Engineering, Knoxville, TN, edited by M. Lubell, M. Nestor, and S. Vaughan (Institute of Electrical and Electronic Engineers, New York, 1990), Vol. 1, p. 13] is surveyed. Reliable operation, with plasma current up to 1 MA, has been obtained, despite the massive conducting superstructure and the associated error fields. However, vertical disruptions are not slowed by the long vessel time constant. With pellet fueling, peak densities up to 9×1020 m−3 have been attained and ‘‘snakes’’ are often seen. Initial characterization of divertor and scrape‐off layer is presented and indicates approximately Bohm diffusion. The edge plasma shows a wealth of marfe‐like phenomena, including a transition to detachment from the divertor plates with accompanying radiative divertor regions. Energy confinement generally appears to exceed the expectations of neo‐Alcator scaling. A transition to Ohmic H mode has been observed. Ion cyclotron heating experiments have demonstrated good power coupling, in agreement with theory.

Experimental investigation of transport phenomena in the scrape-off layer and divertor

Abstract Transport physics in the divertor and scrape-off layer of Alcator C-Mod is investigated for a wide range of plasma conditions. Parallel (∥) transport topics include: low recycling, high-recycling, and detached regimes, thermoelectric currents, asymmetric heat fluxes driven by thermoelectric currents, and reversed divertor flows. Perpendicular (⊥) transport topics include: expected and measured scalings of ⊥ gradients with local conditions, estimated χ⊥ profiles and scalings, divertor neutral retention effects, and L-mode/H-mode effects. Key results are: (i) classical ∥ transport is obeyed with ion-neutral momentum coupling effects, (ii) ⊥ heat transport is proportional to local gradients, (iii) χ⊥ αTe−0.6 n−0.6 L−0.7 in L-mode, insensitive to toroidal field, (iv) χ⊥ is dependent on divertor neutral retention, (v) H-mode transport barrier effects partially extend inside the SOL, (vi) inside/outside divertor asymmetries may be caused by a thermoelectric instability, and (vii) reversed ∥ flows depend on divertor asymmetries and their implicit ionization source imbalances.

Scaling and transport analysis of divertor conditions on the Alcator C-Mod tokamak

Detailed measurements and transport analysis of divertor conditions in Alcator C‐Mod [Phys. Plasmas 1, 1511 (1994)] are presented for a range of line‐averaged densities, 0.7<ne<2.2×1020 m−3. Three parallel heat transport regimes are evident in the scrape‐off layer: sheath‐limited conduction, high‐recycling divertor, and detached divertor, which can coexist in the same discharge. Local cross‐field pressure gradients are found to scale simply with a local electron temperature. This scaling is consistent with classical electron parallel conduction being balanced by anomalous cross‐field transport (χ⊥∼0.2 m2 s−1) proportional to the local pressure gradient. A 60%–80% of divertor power is radiated in attached discharges, approaching 100% in detached discharges. Detachment occurs when the heat flux to the plate is low and the plasma pressure is high (Te∼5 eV). High neutral pressures in the divertor are nearly always present (1–20 mTorr), sufficient to remove parallel momentum via ion–neutral collisions.

Radiofrequency-heated enhanced confinement modes in the Alcator C-Mod tokamak

Enhanced confinement modes up to a toroidal field of BT=8 T have been studied with up to 3.5 MW of radiofrequency (rf) heating power in the ion cyclotron range of frequencies (ICRF) at 80 MHz. H-mode is observed when the edge temperature exceeds a threshold value. The high confinement mode (H-mode) with higher confinement enhancement factors (H) and longer duration became possible after boronization by reducing the radiated power from the main plasma. A quasi-steady state with high confinement (H=2.0), high normalized beta (βN=1.5), low radiated power fraction (Pradmain/Ploss=0.3), and low effective charge (Zeff=1.5) has been obtained in Enhanced Dα H-mode. This type of H-mode has enhanced levels of continuous Dα emission and very little or no edge localized mode (ELM) activity, and reduced core particle confinement time relative to ELM-free H-mode. The pellet enhanced performance (PEP) mode is obtained by combining core fueling with pellet injection and core heating. A highly peaked pressure profile with...

Comparison of detached and radiative divertor operation in Alcator C-Mod

The divertor of the Alcator C‐Mod tokamak [Phys. Plasmas 1, 1511 (1994)] routinely radiates a large fraction of the power entering the scrape‐off layer. This dissipative divertor operation occurs whether the divertor is detached or not, and large volumetric radiative emissivities, up to 60 MW m−3 in ion cyclotron range of frequency (ICRF) heated discharges, have been measured using bolometer arrays. An analysis of both Ohmic and ICRF‐heated discharges has demonstrated some of the relative merits of detached divertor operation versus high‐recycling divertor operation. An advantage of detached divertor operation is that the power flux to the divertor plates is decreased even further than its already low value. Some disadvantages are that volumetric losses outside the separatrix in the divertor region are decreased, the neutral compression ratio is decreased, and the penetration efficiency of impurities increases.

Electron heating via mode converted ion Bernstein waves in the Alcator C-Mod tokamak

Highly localized direct electron heating [full width at half-maximum (FWHM)≅0.2a] via mode converted ion Bernstein waves has been observed in the Alcator C-Mod Tokamak [I. H. Hutchinson et al., Phys. Plasmas 1, 1511 (1994)]. Electron heating at or near the plasma center (r/a⩾0.3) has been observed in H(3He) discharges at B0=(6.0–6.5) T and ne(0)≅1.8×1020 m−3. [Here, the minority ion species is indicated parenthetically.] Off-axis heating (r/a⩾0.5) has also been observed in D(3He) plasmas at B0=7.9 T. The concentration of 3He in these experiments was in the range of n3He/ne≅(0.2–0.3) and the locations of the mode conversion layer and electron heating peak could be controlled by changing the 3He concentration or toroidal magnetic field (B0). The electron heating profiles were deduced using a rf modulation technique. Detailed comparisons with one-dimensional and toroidal full-wave models in the ion cyclotron range of frequencies have been carried out. One-dimensional full-wave code predictions were found to ...

Transport experiments in Alcator‐C‐Mod

A series of transport experiments has been carried out in Alcator‐C‐Mod. [Phys Plasmas 1, 1511 (1994)]. Data from both Ohmic and ICRF (ion cyclotron range of frequencies) heated plasmas can be fitted with an L‐mode (low mode) scaling law. The Ohmic τE’s show no scaling with density in any regime and can reach values of 2–3 times neo‐Alcator. Impurity confinement has been studied with the laser blow‐off technique with τI showing nearly linear scaling with plasma current. Ohmic and ICRF H modes are obtained over a wide range of discharge parameters, extending the range in the international database for nB, by almost a factor of 10. The power threshold for ELM‐free (edge localized mode) discharges is in rough agreement with the scaling P/S=0.044nB. Energy diffusivities of Ohmic and ICRF heated plasmas have been measured from local analysis of plasma profiles and power fluxes. The same analysis produces a value for plasma resistivity which lies between the Spitzer and neoclassical calculations. Analysis of pl...

Characteristics of high‐confinement modes in Alcator C Mod

The regime of high particle and energy confinement known as the H mode [Phys. Rev. Lett. 49, 1408 (1982)] has been extended to a unique range of operation for divertor tokamaks up to toroidal fields of nearly 8 T, line‐averaged electron densities of 3×1020 m−3, and surface power densities of nearly 0.6 MW/m2 in the compact high‐field tokamak Alcator C Mod [Phys. Plasmas 1, 1511 (1994)]. H modes are achieved in Alcator C Mod with Ion Cyclotron Resonant Frequency (ICRF) heating and with Ohmic heating alone without boronization of the all molybdenum tiled first wall. Large increases in charge exchange flux are observed during the H mode over the entire range of energies from 2 to 10 keV. There appears to be an upper limit to the midplane neutral pressure, of about 0.08 Pa above which no H modes have been observed. The plasmas with the best energy confinement have the lowest midplane neutral pressures, below 0.01 Pa. There is an edge electron temperature threshold such that Te≥280 eV ±40 eV for sustaining the...

ICRF heating in the Alcator C‐Mod tokamak

ICRF heating experiments have been carried out in the Alcator C‐Mod tokamak at power levels up to 3.5 MW. Features of Alcator C‐Mod include high density operation, molybdenum plasma facing components, and a closed divertor configuration. The heating is accomplished with two two‐strap antennas each run with dipole phasing at 80 MHz in deuterium plasmas with a hydrogen minority resonant at 5.3 T. Plasmas with Ti=4 keV and Te=5 keV at ne=1×1020 m−3 have been produced with 3.5 MW of heating power. The heating has been shown to be strongest with a low minority concentration (1–5%) and the resonance on axis. For ne≳2×1020 m−3, the central Zeff remains below 1.5 with more than 2.5 MW of applied rf power. L‐mode confinement scaling is observed both for ohmic and ICRF‐heated plasmas with some deterioration at higher densities. H‐mode transitions have been produced with the threshold for ELM‐free H‐modes at or below the ASDEX/DIII‐D scaling. Enhanced confinement with strongly peaked density profiles has been achi...