Ian H. Hutchinson

First results from Alcator-C-MOD

Early operation of the Alcator‐C‐MOD tokamak [I.H. Hutchinson, Proceedings of IEEE 13th Symposium on Fusion Engineering, Knoxville, TN, edited by M. Lubell, M. Nestor, and S. Vaughan (Institute of Electrical and Electronic Engineers, New York, 1990), Vol. 1, p. 13] is surveyed. Reliable operation, with plasma current up to 1 MA, has been obtained, despite the massive conducting superstructure and the associated error fields. However, vertical disruptions are not slowed by the long vessel time constant. With pellet fueling, peak densities up to 9×1020 m−3 have been attained and ‘‘snakes’’ are often seen. Initial characterization of divertor and scrape‐off layer is presented and indicates approximately Bohm diffusion. The edge plasma shows a wealth of marfe‐like phenomena, including a transition to detachment from the divertor plates with accompanying radiative divertor regions. Energy confinement generally appears to exceed the expectations of neo‐Alcator scaling. A transition to Ohmic H mode has been observed. Ion cyclotron heating experiments have demonstrated good power coupling, in agreement with theory.

A fluid theory of ion collection by probes in strong magnetic fields with plasma flow

A one‐dimensional fluid theory of Langmuir probe operation in strong magnetic fields is presented. Cross‐field diffusion of ions both into and out of the the collection region is consistently accounted for, in effect taking momentum and particle diffusivity to be equal. The results differ by significant factors from previous analyses, which did not account for outward diffusion but in effect set momentum diffusivity to zero. The differences are especially large when parallel flow of the external plasma is present. It is thus clear that the value assumed for the momentum diffusivity strongly affects the interpretation of recent probe measurements. It is argued that the present results offer a more reliable basis for this interpretation.

Principal physics developments evaluated in the ITER design review

As part of the ITER Design Review and in response to the issues identified by the Science and Technology Advisory Committee, the ITER physics requirements were reviewed and as appropriate updated. The focus of this paper will be on recent work affecting the ITER design with special emphasis on topics affecting near-term procurement arrangements. This paper will describe results on: design sensitivity studies, poloidal field coil requirements, vertical stability, effect of toroidal field ripple on thermal confinement, material choice and heat load requirements for plasma-facing components, edge localized modes control, resistive wall mode control, disruptions and disruption mitigation.

Experimental investigation of transport phenomena in the scrape-off layer and divertor

Abstract Transport physics in the divertor and scrape-off layer of Alcator C-Mod is investigated for a wide range of plasma conditions. Parallel (∥) transport topics include: low recycling, high-recycling, and detached regimes, thermoelectric currents, asymmetric heat fluxes driven by thermoelectric currents, and reversed divertor flows. Perpendicular (⊥) transport topics include: expected and measured scalings of ⊥ gradients with local conditions, estimated χ⊥ profiles and scalings, divertor neutral retention effects, and L-mode/H-mode effects. Key results are: (i) classical ∥ transport is obeyed with ion-neutral momentum coupling effects, (ii) ⊥ heat transport is proportional to local gradients, (iii) χ⊥ αTe−0.6 n−0.6 L−0.7 in L-mode, insensitive to toroidal field, (iv) χ⊥ is dependent on divertor neutral retention, (v) H-mode transport barrier effects partially extend inside the SOL, (vi) inside/outside divertor asymmetries may be caused by a thermoelectric instability, and (vii) reversed ∥ flows depend on divertor asymmetries and their implicit ionization source imbalances.

Edge radial electric field structure and its connections to H-mode confinement in Alcator C-Mod Plasmas

High-resolution charge-exchange recombination spectroscopic measurements of B5+ ions have enabled the first spatially resolved calculations of the radial electric field (Er) in the Alcator C-Mod pedestal region [E. S. Marmar, Fusion Sci. Technol. 51, 261 (2006)]. These observations offer new challenges for theory and simulation and provide for important comparisons with other devices. Qualitatively, the field structure observed on C-Mod is similar to that on other tokamaks. However, the narrow high-confinement mode (H-mode) Er well widths (5 mm) observed on C-Mod suggest a scaling with machine size, while the observed depths (up to 300 kV/m) are unprecedented. Due to the strong ion-electron thermal coupling in the C-Mod pedestal, it is possible to infer information about the main ion population in this region. The results indicate that in H-mode the main ion pressure gradient is the dominant contributor to the Er well and that the main ions have significant edge flow. C-Mod H-mode data show a clear correl...

Observations of central toroidal rotation in ICRF heated Alcator C-Mod plasmas

Impurity toroidal rotation has been observed in the centre of Alcator C-Mod ion cyclotron range of frequencies (ICRF) heated plasmas, from the Doppler shifts of argon X ray lines. Rotation velocities greater than 1.2 × 107 cm/s (ω = 200 krad/s) in the co-current direction have been observed in H mode discharges that had no direct momentum input. There is a correlation between the increase in the central impurity rotation velocity and the increase in the plasma stored energy (confinement enhancement), induced by ICRF heating, although other factors may be at play. The toroidal rotation velocity is highest near the magnetic axis, and decreases with increasing minor radius. A radial electric field of 300 V/cm at r/a = 0.3 has been inferred from the force balance equation. The direction of the rotation changes when the plasma current direction is reversed, remaining co-current. Impurity toroidal rotation in ICRF heated plasmas is in the direction opposite to the rotation in ohmic L mode plasmas; co-current rotation has also been observed during purely ohmic H modes. When the ICRF heating is turned off, the toroidal rotation decays with a characteristic time of order 50 ms, similar to the energy confinement time, and much shorter than the calculated neoclassical momentum damping time.

Ion collection by a sphere in a flowing plasma: 2. non-zero Debye length

The spatial distribution of ion flux to a sphere in a flowing collisionless plasma is calculated using a particle-in-cell code SCEPTIC. The code is validated by comparing with prior stationary-plasma and approximate calculations. Comprehensive results are provided for ion temperatures 1 and 0.1 times the electron temperature, and for Debye length from 0.01 to 100 times the probe size. A remarkable qualitatively new result is obtained: over a range of Debye lengths from roughly 0.1 to 10 times the probe radius at Ti = 0.1Te, the downstream side of the probe receives substantially higher flux density than the upstream side when the flow is subsonic. This unexpected reversal of the asymmetry reinforces the need for these fully self-consistent calculations, but renders the use of the flux ratio for Mach-probe purposes problematic, even for deriving the direction of the flow.

Characterization of enhanced Dα high-confinement modes in Alcator C-Mod

Regimes of high-confinement mode have been studied in the Alcator C-Mod tokamak [Hutchinson et al., Phys. Plasmas 1, 1511 (1994)]. Plasmas with no edge localized modes (ELM-free) have been compared in detail to a new regime, enhanced Dα (EDA). EDA discharges have only slightly lower energy confinement than comparable ELM-free ones, but show markedly reduced impurity confinement. Thus EDA discharges do not accumulate impurities and typically have a lower fraction of radiated power. The edge gradients in EDA seem to be relaxed by a continuous process rather than an intermittent one as is the case for standard ELMy discharges and thus do not present the first wall with large periodic heat loads. This process is probably related to fluctuations seen in the plasma edge. EDA plasmas are more likely at low plasma current (q>3.7), for moderate plasma shaping, (triangularity ∼0.35–0.55), and for high neutral pressures. As observed in soft x-ray emission, the pedestal width is found to scale with the same parameters that determine the EDA/ELM-free boundary.

Nonaxisymmetric field effects on Alcator C-Mod

A set of external coils (A-coils) capable of producing nonaxisymmetric, predominantly n=1, fields with different toroidal phase and a range of poloidal mode m spectra has been used to determine the threshold amplitude for mode locking over a range of plasma parameters in Alcator C-Mod [I. H. Hutchinson, R. Boivin, F. Bombarda, P. Bonoli, S. Fairfax, C. Fiore, J. Goetz, S. Golovato, R. Granetz, M. Greenwald et al., Phys. Plasmas 1, 1511 (1994)]. The threshold perturbations and parametric scalings, expressed in terms of (B21∕BT), are similar to those observed on larger, lower field devices. The threshold is roughly linear in density, with typical magnitudes of order 10−4. This result implies that locked modes should not be significantly more problematic for the International Thermonuclear Experimental Reactor [I. P. B. Editors, Nucl. Fusion 39, 2286 (1999)] than for existing devices. Coordinated nondimensional identity experiments on the Joint European Torus [Fusion Technol. 11, 13 (1987)], DIII-D [Fusion T...

Scaling and transport analysis of divertor conditions on the Alcator C-Mod tokamak

Detailed measurements and transport analysis of divertor conditions in Alcator C‐Mod [Phys. Plasmas 1, 1511 (1994)] are presented for a range of line‐averaged densities, 0.7<ne<2.2×1020 m−3. Three parallel heat transport regimes are evident in the scrape‐off layer: sheath‐limited conduction, high‐recycling divertor, and detached divertor, which can coexist in the same discharge. Local cross‐field pressure gradients are found to scale simply with a local electron temperature. This scaling is consistent with classical electron parallel conduction being balanced by anomalous cross‐field transport (χ⊥∼0.2 m2 s−1) proportional to the local pressure gradient. A 60%–80% of divertor power is radiated in attached discharges, approaching 100% in detached discharges. Detachment occurs when the heat flux to the plate is low and the plasma pressure is high (Te∼5 eV). High neutral pressures in the divertor are nearly always present (1–20 mTorr), sufficient to remove parallel momentum via ion–neutral collisions.