Charles Dague

Design features, developmental status, and experimental results with the Heartmate III centrifugal left ventricular assist system with a magnetically levitated rotor.

A long-term left ventricular assist system for permanent use in advanced heart failure is being developed on the basis of a compact centrifugal pump with a magnetically levitated rotor and single-fault–tolerant electronics. Key features include its “bearingless” (magnetic levitation) design, textured surfaces similar to the HeartMate XVE left ventricular assist device (LVAD) to reduce anticoagulation requirements and thromboembolism, a sensorless flow estimator, and an induced pulse mode for achieving an increased level of pulsatility with continuous flow assistance. In vitro design verification testing is underway. Preclinical testing has been performed in calves demonstrating good in vivo performance at an average flow rate of 6 L/min (maximum: >11 L/min) and normal end-organ function and host response. Induced pulse mode demonstrated the ability to produce a physiological pulse pressure in vivo. Thirteen LVADs have achieved between 16 to 40 months of long-term in vitro reliability testing and will be continued until failure. Both percutaneous and fully implanted systems are in development, with a modular connection for upgrading without replacing the LVAD.

Design Rationale and Preclinical Evaluation of the HeartMate 3 Left Ventricular Assist System for Hemocompatibility.

The HeartMate 3 (HM3) left ventricular assist device (LVAD) is designed to support advanced heart failure patients. This centrifugal flow pump has a magnetically levitated rotor, artificial pulse, textured blood-contacting surfaces, optimized fluid dynamics, large blood-flow gaps, and low shear stress. Preclinical tests were conducted to assess hemocompatibility. A computational fluid dynamics (CFD) model guided design for low shear stress and sufficient washing. Hemolysis testing was conducted on six pumps. Plasma-free hemoglobin (PfHb) and modified index of hemolysis (MIH) were compared with HeartMate II (HMII). CFD showed secondary flow path residence times between 27 and 798 min, comparable with main flow residence times between 118 and 587 min; HM3 vs. HMII shear stress exposure above 150 Pa was 3.3 vs. 11 mm3 within the pump volume and 134 vs. 604 mm2 on surfaces. In in vitro hemolysis tests at 2, 5, and 10 L/min, average pfHb 6 hours after test initiation was 58, 74, and 157 mg/dl, compared with 112, 123, and 353 mg/dl for HMII. The HM3/HMII ratio of average MIH at 2, 5, and 10 L/min was 0.29, 0.36, and 0.22. Eight 60 day bovine implants were tested with average flow rates from 5.6 to 6.4 L/min with no device failures, thrombosis, or hemolysis. Results support advancing HM3 to clinical trials.