Cimara Fortes Ferreira

New Bone Formation around Implants Inserted on Autologous and Xenografts Irradiated or not with IR Laser Light: A Histomorphometric Study in Rabbits

Use of biomaterials and light on bone grafts has been widely reported. This work assessed the influence of low-level laser therapy (LLLT) on bone volume (BV) and bone implant contact (BIC) interface around implants inserted in blocks of bovine or autologous bone grafts (autografts), irradiated or not, in rabbit femurs. Twenty-four adult rabbits were divided in 8 groups: AG: autograft; XG: xenograft; AG/L: autograft + laser; XG/L: xenograft + laser; AG/I: autograft + titanium (Ti) implant; XG/I: xenograft + Ti implant; AG/I/L: autograft + Ti implant + laser; and XG/I/L: xenograft + Ti implant + laser. The animals received the Ti implant after incorporation of the grafts. The laser parameters in the groups AG/L and XG/L were λ=780 nm, 70 mW, CW, 21.5 J/cm 2 , while in the groups AG/I/L and XG/I/L the following parameters were used: λ=780 nm, 70 mW, 0.5 cm 2 (spot), 4 J/cm 2 per point (4), 16 J/cm 2 per session, 48 h interval × 12 sessions, CW, contact mode. LLLT was repeated every other day during 2 weeks. To avoid systemic effect, only one limb of each rabbit was double grafted. All animals were sacrificed 9 weeks after implantation. Specimens were routinely stained and histomorphometry carried out. Comparison of non-irradiated and irradiated grafts (AG/L versus AG and XG/L versus XG) showed that irradiation increased significantly BV on both grafts (p=0.05, p=0.001). Comparison between irradiated and non-irradiated grafts (AG/I/L versus AG/I and XG/I/L versus XG/I) showed a significant (p=0.02) increase of the BIC in autografts. The same was seen when xenografts were used, without significant difference. The results of this investigation suggest that the use of LLLT is effective for enhancing new bone formation with consequent increase of bone-implant interface in both autologous grafts and xenografts.

Relationship Between Smoking and Bleeding on Probing

The objective of this study was to assess and compare bone loss (BL) around the dental implant platform as well as the presence of bacterial plaque (PBP), bleeding on probing (BOP), and periodontal probing depths (PD) of teeth and dental implants of smokers and nonsmokers. Three hundred forty-seven teeth and 98 implants of 20 randomly selected patients were assessed (12 smokers and 8 nonsmokers). The specimens were divided into 4 groups according to the site probed. Group 1 included smoker implant sites, group 2 included smoker tooth sites, group 3 included nonsmoker implant sites, and group 4 included nonsmoker tooth sites. The presence/absence of visible bacterial plaque, presence/absence of BOP, PD ≤ 3 mm or >3 mm, and BL around the dental implant platform were the data assessed. The PBP and BL showed statistical significance between smokers and nonsmokers. Bleeding on probing and PD ≤ 3 mm showed statistical significance between groups 1, 3, and 4. Comparing sites with BOP and PD > 3 mm, there was no statistical significance except for group 1, which did not present sites with these characteristics. Comparing sites with BOP and PD ≤ 3 mm, there was statistical significance between group 2 and groups 3 and 4. When comparing the prevalence of sites without BOP and PD > 3 mm, there was statistical significance between groups 1, 3, and 4. Smoking promotes a greater BL around the dental implant platform and results in vasoconstriction of the peri-implant and periodontal tissues.

Dental implant rehabilitation of a patient with down syndrome: a case report.

Implant-supported rehabilitations show higher patient satisfaction when compared with conventional prostheses. Systemic conditions, however, can affect treatment planning of dental implant supported rehabilitations. The oral structures that are commonly affected in patients with Down syndrome include the tongue (macroglossia), teeth (number and shape), and poor quality alveolar and jaw bones (osteoporotic-like). This clinical case presents an interdisciplinary team approach aimed at achieving functional, phonetic, and esthetic outcomes in a patient with Down syndrome.

The Value of Occlusion in Dentistry: A Clinical Report Showing the Correction of an Anterior Reverse Articulation with Selective Occlusal Adjustment

The subject of occlusion has been deemphasized by academia over the last 30 years. This marginalization in turn has negatively impacted recent graduates who are largely unfamiliar with the use of occlusal adjustment by selective reshaping as a treatment modality. Use of proper occlusal therapy enables clinicians to more effectively help patients recover from parafunctional wear of the anterior and posterior teeth. In addition, familiarity with this field enhances the correction of progressive posterior and anterior reverse articulations. This article aims to highlight the importance of occlusal principles in treatment planning. In addition, we illustrate the benefits of occlusal adjustment by using a conservative technique, selective reshaping, as an option to correct anterior reverse articulation in a 20-year-old patient. The knowledge of occlusal principles enhances diagnosis of malocclusion in the development of a treatment plan. When properly employed, the technique of occlusal adjustment by selective reshaping may be used to correct an adaptive anterior reverse articulation with a high degree of predictability for select patients.

Assessment of the effect of chemical agents used in dentistry on the removal of Porphyromonas gingivalis and escherichia coli from sandblasted acid-etched titanium dental implants: An in vitro study

PURPOSE The aim of this study was to evaluate the capability of chemicals to decontaminate Escherichia coli (E coli) or Porphyromonas gingivalis (P gingivalis) from sandblasted acid-etched (SAE) titanium dental implants. MATERIALS AND METHODS SAE titanium dental implants were contaminated with E coli or P gingivalis and incubated in a sterile bacterial culture media under aerobic and anaerobic conditions, respectively. The implants were treated with 10 different conditions: calcium hydroxide [Ca(OH)₂] paste for 1 minute and saline irrigation for 1 minute; Ca(OH)2 paste for 1 minute and 0.2% chlorhexidine digluconate (CHXD) irrigation for 1 minute; 0.2% CHXD for 1 minute; Dakins solution for 1 minute; tetracycline hydrochloride (T-HCl) as a 1 g per 20 mL solution for 1, 2, and 3 minutes; and T-HCl paste for 1, 2, and 3 minutes. All implants were irrigated with 1 mL of saline solution and incubated under aerobic and anaerobic conditions for 24 hours or 48 hours for E coli- and P gingivalis-contaminated implants, respectively. The control group was submitted to all procedures except for the chemical treatments. Aliquots were removed, and turbidity was measured by spectrophotometry. The level of bacterial growth in control cultures was considered to have a decontamination percentage (DC%) of 0. RESULTS Spectrophotometric analysis showed that all chemical treatments resulted in significantly higher DC% compared to controls for SAE implants contaminated with E coli (P < .05) or P gingivalis (P < .05). For the P gingivalis experiments, SAE implants treated with Ca(OH)₂ paste and saline solution had a lower DC% (39.3%) than those in the other treatment groups. In the E coli experiments, DC% was significantly lower for SAE implants treated with Ca(OH)₂ paste and saline solution (48.7%), Dakins solution (92.7%), or T-HCl paste for 1 minute (96.6%) than those in the other groups. CONCLUSION The DC% of SAE implants contaminated with E coli or P gingivalis by means of chemicals commonly used in dentistry is high, with the exception of Ca(OH)₂ paste burnished for 1 minute and then irrigated with saline solution for 1 minute.

An Alternative Approach for Augmenting the Anterior Maxilla Using Autogenous Free Gingival Bone Graft for Implant Retained Prosthesis

Numerous factors may keep surgeons from placing implants in the anterior maxilla in order to avoid suboptimal restorative outcomes. This paper describes a technique of an autogenous-free gingival-bone block graft, which allows bone and gingival augmentation and a primary seal to be achieved simultaneously. Additionally, it describes a technique for achieving primary soft tissue closure of maxillary extraction sockets using a rotated pedicle palatal connective tissue flap.

A Newly Designed Template Device for Use With the Insertion of Immediately Loaded Implants

This article describes a newly designed surgical template that was used to facilitate dental implant placement. The implants were planned to function by loading them immediately. A case report describing the device and the benefits of its use for a patient with an edentulous mandible is presented. Four implants were placed in the anterior region of the mandible to support an immediately fixed prosthesis. Clinical and radiographic analyses were conducted postoperatively to evaluate bone loss and peri-implant soft-tissue healing. The salutary results demonstrated the positive value of this therapeutic approach and presented the advantages of shorter treatment times, fewer patient visits, lower costs, and elimination of secondary surgical procedures.

Efficiency of Nanotube Surface-Treated Dental Implants Loaded with Doxycycline on Growth Reduction of Porphyromonas gingivalis

PURPOSE The prevalence of peri-implant infection in patients with dental implants has been shown to range from 28% to 56%. A nanotube-modified implant surface can deliver antibiotics locally and suppress periodontal pathogenic bacterial growth. The aim of this study was to evaluate the deliverability of antibiotics via a nanotube-modified implant. MATERIALS AND METHODS Dental implants with a nanotube surface were fabricated and loaded with doxycycline. Afterward, each dental implant with a nanotube surface was placed into 2-mL tubes, removed from solution, and placed in a fresh solution daily for 28 days. Experimental samples from 1, 2, 4, 16, 24, and 28 days were used for this evaluation. The concentration of doxycycline was measured using spectrophotometric analysis at 273-nm absorbance. The antibacterial effect of doxycycline was evaluated by supplementing Porphyromonas gingivalis (P gingivalis) growth media with the solution collected from the dental implants at the aforementioned time intervals for a period of 48 hours under anaerobic conditions. A bacterial viability assay was used to evaluate P gingivalis growth at 550-nm absorbance. RESULTS Doxycycline concentration varied from 0.33 to 1.22 μg/mL from day 1 to day 28, respectively. A bacterial viability assay showed the highest P gingivalis growth at day 1 (2 nm) and the lowest at day 4 (0.17 nm), with a gradual reduction from day 1 to day 4 of approximately 87.5%. The subsequent growth pattern was maintained and slightly increased from baseline in approximately 48.3% from day 1 to day 24. The final P gingivalis growth measured at day 28 was 29.4% less than the baseline growth. CONCLUSION P gingivalis growth was suppressed in media supplemented with solution collected from dental implants with a nanotube surface loaded with doxycycline during a 28-day time interval.

Occlusal Rehabilitation of Pseudo-Class III Patient

To treat a patient with anterior crossbite, the clinician should first assess if it is a genuine class III or a pseudo-class III malocclusion. Cephalometric analysis is important; however, registering a patients centric relation (CR) is simple, quick, and costless and can play a decisive role in a differential diagnosis for this type of patient profile. This clinical report depicts a patient clinically diagnosed as class III. After mandible manipulation in CR, it was noted that the patient in question was a pseudo-class III. The treatment was based on the pseudo-class III diagnosis. Therefore, the patient was rehabilitated by occlusal adjustments and conventional and implant-supported prostheses and without the need for invasive orthognathic surgery.

Assessment of the Effect of CO2 Laser Irradiation on the Reduction of Bacteria Seeded on Commercially Available Sandblasted Acid-Etched Titanium Dental Implants: An In Vitro Study.

PURPOSE To evaluate the capability of carbon dioxide (CO₂) laser in reducing Escherichia coli on sandblasted acid-etched (SAE) titanium dental implants. MATERIALS AND METHODS SAE dental implants were contaminated with E coli, incubated in a sterile bacterial culture medium for 24 hours, and then exposed to CO₂ laser (10,600-nm wavelength) in superpulsed waves (SPW) at 1.5, 1.7, and 2 W at 100-Hz frequency and continuous wave (CW) at 1.5, 2, and 2.5 W. The presence of bacteria trapped in the implant surfaces after contamination and decontamination was verified using spectrophotometry. Scanning electron microscopy (SEM) was used to evaluate the topography of laser irradiation. After implant surface contamination was verified, implants were exposed to CO₂ laser irradiation, and bacterial growth was measured with spectrophotometry. RESULTS The control implants showed the highest bacterial growth (100% growth). Implants exposed to laser showed progressive increase in the percentage of decontamination (DC%) corresponding to the higher wattage in the SPW and CW groups. The DC% were 20.4%, 49.6%, and 51.7% in the SPW group at 100 Hz, at 1.5, 1.7, and 2 W of power, respectively. In the CW group, the DC% were 34.3%, 69.9%, and 85.5% at 1.7, 2, and 2.5 W, respectively. Kruskal-Wallis statistical analysis showed a significant difference between the groups (P < .05). In the pulsed mode (100-Hz) group, statistical analysis showed that the DC% of 1.5 W was significantly lower than the 2 W power. In the CW group, statistical analysis showed that the DC% at 1.7 W was significantly lower (P < .05) than with the other treatments. SEM assessment showed craterlike wear damages and accretions to the implant surfaces that increased progressively as the laser wattage increased. CONCLUSION CO₂ laser irradiation failed to completely decontaminate the implant surfaces. SEM analysis demonstrated damage to the top of the dental implant threads at all settings studied. Thus, CO₂ laser irradiation may not be the optimal method to decontaminate implants.