D. H. J. Jager

Reduction of Erosive Wear in situ by Stannous Fluoride-Containing Toothpaste

Background/Aims: Stannous fluoride (SnF) has been suggested as a dental erosion-preventive agent. The aim of this single-centre, randomized, double-blind, in situ study was to evaluate the effect of toothpastes with SnF in the prevention of erosive enamel wear. Methods: A combined split-mouth (extra-oral water or toothpaste brushing) and crossover (type of toothpaste) set-up was used. Twelve volunteers wore palatal appliances containing human enamel samples. Three toothpastes were used, in three consecutive runs, in randomized order: two toothpastes containing SnF (coded M and PE) and one toothpaste containing only sodium fluoride (coded C). On day 1 of each run the appliances were worn for pellicle formation. On days 2–5 the samples were also brushed twice with a toothpaste-water slurry or only water (control). Erosion took place on days 2–5 extra-orally 3 times a day (5 min) in a citric acid solution (pH 2.3). Enamel wear depth was quantified by optical profilometry. The effect of toothpastes was tested using General Linear Modeling. Results: Average erosive wear depth of control samples was 23 µm. Both SnF toothpastes significantly reduced erosive wear: M by 34% (SD 39%) and PE by 26% (SD 25%). The control toothpaste reduced erosive wear non-significantly by 7% (SD 20%). Both SnF-containing toothpastes significantly reduced erosive wear compared to the sodium fluoride toothpaste. Conclusion: We conclude that SnF-containing toothpastes are able to reduce erosive tooth wear in situ.

Inhibition of Erosive Wear by Fluoride Varnish

It has been suggested that fluoride products with a protective mechanical component are advantageous in the prevention of erosive wear. The aim of this study was to evaluate in situ the effect of fluoride varnish (FV) in the prevention of wear due to erosion and combined erosion and toothbrush abrasion. Eleven volunteers wore for 3 weeks, during working hours, appliances containing 2 control and 2 FV-treated human enamel samples. Erosion took place extraorally 3 times a day (5 min) in the soft drink Sprite. At the end of each experimental day one control and one FV sample (C-er+abr and FV-er+abr) were brushed (5 s) with fluoridated dentrifice. The remaining control and FV sample (C-er and FV-er) were left unbrushed. Enamel volume loss was quantified by optical profilometry at day 5, 10 and 15. A statistically significant progression in enamel loss was found for the C-er, C-er+abr and FV-er+abr groups (p < 0.001, p < 0.001 and p = 0.001, respectively) but not for the FV-er group (p = 0.053). The values of cumulative normalized volume loss (×108 µm) at day 15 were: C-er 5.53 ± 2.14, C-er+abr 5.70 ± 2.07, FV-er 0.79 ± 0.67 and FV-er+abr 2.76 ± 1.35. The FV-er and FV-er+abr groups showed significant lower volume loss than the C-er group (p < 0.001 and p = 0.005, respectively) and the C-er+abr group (p < 0.001 and p = 0.002, respectively). The results indicate that fluoride varnish is effective in the reduction of erosive wear.

Influence of Beverage Composition on the Results of Erosive Potential Measurement by Different Measurement Techniques

The influence of beverage composition on the measurement of erosive potential is unclear. The aim of this study was to evaluate whether beverage composition influences the measurement of erosive potential and to evaluate the influence of exposure in small and large volumes. Eleven beverages were included: water (control), 3 alcopops, 2 beers and 5 soft drinks. For each beverage 15 bovine enamel samples were used: 5 for chemical and 10 for profilometric analysis. After exposure to the beverages (63 min) the resulting solutions were analyzed for Ca and inorganic phosphorus (Pi) content. The samples for optical profilometry were submersed sequentially in 500 ml or in 1 ml of the drinks for 3, 6, 9, 15 and 30 min (total 63 min). For some of the beverages high baseline concentrations of Ca (energy drink) or Pi (cola drink, cola lemon drink, beer, beer lemon) were found. Some of the beverages showed a good correlation between the chemical methods. Profilometry (both for 1 and 500 ml) showed generally lower enamel losses than the chemical methods. Lower enamel losses were found for the profilometry 1 ml compared to the profilometry 500 ml only for the cola drinks. It can be concluded that the composition of the beverages had a significant effect on the determination of the erosive potential with chemical analyses. Drink composition also influenced the effect of small versus large exposure volumes, indicating the need for standardization of exposure parameters.

Effect of Salivary Factors on the Susceptibility of Hydroxyapatite to Early Erosion

Objective: Salivary pellicle is known to reduce the erosion of enamel and differences in the level of protection exist between individual saliva sources, but which parameters or components are important is not known. The focus of this study was to investigate the relationship between saliva parameters and early erosion of hydroxyapatite (HAp) with an in situ grown saliva film. Methods: Twenty-eight volunteers carried two HAp and one porcelain discs in their buccal sulcus for 1.5 h. Next, the discs covered with pellicle and the attached saliva film were exposed extraorally to 50 mM (pH = 3) citric acid for 2 min and unstimulated and stimulated saliva was collected. Calcium loss from HAp after erosive challenge was measured, corrected for calcium loss from pellicle on porcelain discs and averaged. Several salivary parameters were analysed. Pearson’s linear correlation and multiple regression analysis were used to study the relation between saliva parameters and HAp erosion. Results: Significant correlations were found between HAp erosion and the concentration of phosphorus in unstimulated saliva (r = 0.40, p = 0.03) and between HAp erosion and the concentration of sodium (r = –0.40, p = 0.03), chloride (r = –0.47, p = 0.01), phosphorus (r = 0.45, p = 0.01) and flow (r = –0.39, p = 0.04) of stimulated saliva. Multivariate analysis revealed a significant role in the HAp erosion for sodium, urea, total protein, albumin, pH and flow of unstimulated saliva and for sodium, potassium, urea, and phosphorus of stimulated saliva. Conclusions: Several salivary parameters are associated with the susceptibility of HAp to erosion.

Saliva parameters and erosive wear in adolescents

The aim of this study was to investigate the relationship between several parameters of saliva and erosive wear in adolescents. (Un-)stimulated saliva was collected from 88 adolescents with erosion and 49 controls (age 16 ± 1 years). Flow rate, pH and buffer capacity were determined immediately. Total protein content, carbonic anhydrase VI, amylase, albumin, calcium, phosphate, urea, sodium, chloride and potassium were measured at a later time. Unstimulated flow rate was found to be significantly lower in subjects with erosive wear (p = 0.016). The chloride concentration in unstimulated saliva was found to be significantly higher in the erosion group (p = 0.019).

Estimated erosive potential depends on exposure time

OBJECTIVES Evaluate erosive potential of beverages, using exposure times from 3 to 30 min, and to analyse the relationship between erosion and several drink parameters. METHODS pH, calcium, phosphate and fluoride concentration, saturation, titratable-acidity to pH 5.5 and the viscosity of sixteen beverages were measured or calculated. Enamel samples (N = 90) were serially exposed to 1 ml of the beverages for 3, 6, 9, 15 and 30 min and erosion was measured as the loss of calcium to the beverage. Rate of erosion per min was calculated by linear curve fitting using all exposure times. Linear regression analysis was performed to determine the correlation between erosion and the drink parameters. A limited multivariate analysis was performed for the outcome parameter with the highest univariate correlations (erosion per minute) and 4 drink variables. RESULTS A negative relationship was observed only for pH for all exposure times. Only for erosion per min a significant relationship with pH and saturation was found. In a model for erosion per min using only saturation, fluoride concentration, titratable acidity and viscosity, both saturation and viscosity were shown to have a significant effect (p = 0.01 and p = 0.05, respectively). CONCLUSION Exposure times between 3 and 30 min result in very different estimates of erosive potential. There is no sound theoretical ground for preferring one or other exposure time/outcome as being more clinically relevant. CLINICAL RELEVANCE This study shows that effect of the choice of study methodology on the measurement of erosive potential of beverages is large.

Reduction of Erosion by Protein-Containing Toothpastes

Aim: To assess the effect of protein-containing toothpastes on the progression of dental erosion in situ (with pellicle) and in vitro (without pellicle). Methods: A combined split-mouth (extraoral water or toothpaste brushing) and crossover (type of toothpaste) setup was used. Two protein-containing (high/low concentrations of colostrum) and one nonprotein (placebo) toothpaste were investigated. Sixteen volunteers wore intraoral appliances containing 2 human enamel samples on 3 afternoons for pellicle growth during 90 min. One enamel sample was brushed for 5 s with one of the three toothpastes and subsequently exposed to a slurry of the corresponding toothpaste for 2 min. The other sample was exposed to water. Both samples were subsequently exposed to citric acid (extraorally). Loss of calcium and inorganic phosphate were determined. The same sequence of exposures was applied to 16 enamel samples in an in vitro setup without pellicle. Results: With the in situ-formed pellicle, all toothpastes significantly reduced calcium loss compared to water brushing, although no significant differences were found among toothpastes (p = 0.073). For the loss of phosphate, a significant reduction could be found with the use of the high-protein toothpaste compared to the nonprotein toothpaste. Overall there were only slight differences between the toothpastes. Toothpaste effects were less clear in the in vitro experiment. Conclusion: The addition of proteins to toothpaste shows some promise for the prevention of erosion. Further research is needed to investigate the performance of the protein-containing toothpastes in longer in situ studies with regard to erosive wear.

Soft Tissue Augmentation Techniques and Materials Used in the Oral Cavity: An Overview.

Purpose:Oral soft tissue augmentation or grafting procedures are often necessary to achieve proper wound closure after deficits resulting from tumor excision, clefts, trauma, dental implants, and tooth recessions. Materials and Methods:Autologous soft tissue grafts still remain the gold standard to acquire a functionally adequate zone of keratinized attached gingiva. However, soft tissue substitutes are more commonly used because they minimize morbidity and shorten surgical time. Results:This review aimed to assess soft tissue grafting techniques and materials used in the oral cavity from existing literature. There are a large variety of materials and techniques, including grafts, local flaps, allogenic derived matrices such as acellular dermal allograft, xenogenic tissue matrices from animal origin, and synthetic materials. Conclusions:Tissue engineering of oral mucosa represents an interesting alternative to obtain sufficient autologous tissue for reconstructing oral wounds using biodegradable scaffolds, and may improve vascularization and epithelialization, which are critical for successful outcomes.

Relationship among perceived stress, xerostomia, and salivary flow rate in patients visiting a saliva clinic

ObjectiveThis aimed to assess the potential role of chronic stress in saliva secretion, xerostomia, and oral health in a population attending a saliva clinic.Materials and methodsData of 114 patients who met the inclusion criteria and completed all questionnaires were analyzed in this study. Participants completed several validated questionnaires, including the Perceived Stress Scale, the Oral Health Impact Profile (OHIP-14), Xerostomia Inventory (XI), and Bother xerostomia Index (BI). Subsequently, the unstimulated, chewing-stimulated, and citric acid-stimulated saliva secretion rates were determined gravimetrically. Data were evaluated using Spearman’s correlation analysis and the Mann–Whitney U test.ResultsA significant correlation was observed between perceived stress and XI score (r = 0.312, p = 0.001), as well as between perceived stress and BI score (r = 0.334, p = 0.001). Stress levels also were significantly associated with OHIP-14 scores (r = 0.420, p < 0.001), but an association between experienced stress and salivary flow rate could not be established.ConclusionIn this population, perceived chronic stress seems to be related to several aspects of dry mouth, including the perception of dry mouth, suffering from dry mouth, and the impact on quality of life. These effects were independent of the use of psychotropic medication. No actual reduction in salivary flow was found. Further studies to explore the causal linkage of stress with xerostomia seem warranted.Clinical relevancePerceived chronic stress seems to be related with several aspects of dry mouth. This finding might be relevant in future prevention and treatment of xerostomia.

Dental erosion: prevalence, incidence, and distribution

Dental erosion is one of the most common dental diseases and it is a growing problem. Numerous epidemiological studies have investigated the prevalence of dental erosion. For these studies different cross sections of the population are investigated. Large differences were found between countries, geographic locations and age groups. Most prevalence data is available from European studies and it is estimated that 29 % of the adults is affected by tooth wear. Next to geographical differences there are large differences per age group and the highest prevalence (11–100 %) was found in children between 9 and 17 years old. Studies with adults aged 18–88 years showed prevalence between 4 and 83 %. There is evidence that the prevalence of erosion is growing steadily, especially in the older age group. Furthermore, it is suggested that gastro-oesophageal reflux disease (GERD) is an important aggravating factor of dental erosion. Erosive wear is most common on, but not limited to, occlusal and palatal surfaces of the teeth. The occlusal erosions are often found on first mandibular molars. Lingually located lesions are most common on the palatal surfaces of the maxillary anterior teeth, and are often linked to intrinsic erosion.