Danielle Cleveland

Copper Oxide Nanoparticle Mediated DNA Damage in Terrestrial Plant Models

Engineered nanoparticles, due to their unique electrical, mechanical, and catalytic properties, are presently found in many commercial products and will be intentionally or inadvertently released at increasing concentrations into the natural environment. Metal- and metal oxide-based nanomaterials have been shown to act as mediators of DNA damage in mammalian cells, organisms, and even in bacteria, but the molecular mechanisms through which this occurs are poorly understood. For the first time, we report that copper oxide nanoparticles induce DNA damage in agricultural and grassland plants. Significant accumulation of oxidatively modified, mutagenic DNA lesions (7,8-dihydro-8-oxoguanine; 2,6-diamino-4-hydroxy-5-formamidopyrimidine; 4,6-diamino-5-formamidopyrimidine) and strong plant growth inhibition were observed for radish (Raphanus sativus), perennial ryegrass (Lolium perenne), and annual ryegrass (Lolium rigidum) under controlled laboratory conditions. Lesion accumulation levels mediated by copper ions and macroscale copper particles were measured in tandem to clarify the mechanisms of DNA damage. To our knowledge, this is the first evidence of multiple DNA lesion formation and accumulation in plants. These findings provide impetus for future investigations on nanoparticle-mediated DNA damage and repair mechanisms in plants.

Pilot estuarine mesocosm study on the environmental fate of Silver nanomaterials leached from consumer products.

Although nanosilver consumer products (CPs) enjoy widespread availability, the environmental fate, leaching, and bioaccumulation behaviors of silver nanoparticles (AgNPs) from these products are not well understood. In this work, three nanosilver CPs, two AgNP standards, and an ionic silver (Ag(+)) standard were studied in estuarine mesocosms. The CPs exhibited long-term release of significant amounts of silver over a 60d residence time in the mesocosms, and ultimately released 82 - 99% of their total silver loads. Measurements of total silver as a function of time, by inductively coupled plasma mass spectrometry (ICP-MS), indicated that the silver was transferred from the water column and accumulated in the estuarine biota, including hard clams, grass shrimp, mud snails, cordgrass stalks and leaves, biofilms, intertidal sediment, and sand. The ICP-MS results and calculations of bioconcentration and trophic transfer factors indicated that significant amounts of silver were taken up by the organisms through trophic transfer. Silver was also adsorbed from the seawater into the biofilms, sediment, and sand, and from the sand into the clams.

NIST gold nanoparticle reference materials do not induce oxidative DNA damage

Abstract One primary challenge in nanotoxicology studies is the lack of well-characterised nanoparticle reference materials which could be used as positive or negative nanoparticle controls. The National Institute of Standards and Technology (NIST) has developed three gold nanoparticle (AuNP) reference materials (10, 30 and 60 nm). The genotoxicity of these nanoparticles was tested using HepG2 cells and calf-thymus DNA. DNA damage was assessed based on the specific and sensitive measurement of four oxidatively-modified DNA lesions (8-hydroxy-2´-deoxyguanosine, 8-hydroxy-2´-deoxyadenosine, (5´S)-8,5´-cyclo-2´-deoxyadenosine and (5´R)-8,5´-cyclo-2´-deoxyadenosine) using liquid chromatography/tandem mass spectrometry. Significantly elevated, dose-dependent DNA damage was not detected at concentrations up to 0.2 μg/ml, and free radicals were not detected using electron paramagnetic resonance spectroscopy. These data suggest that the NIST AuNPs could potentially serve as suitable negative-control nanoparticle reference materials for in vitro and in vivo genotoxicity studies. NIST AuNPs thus hold substantial promise for improving the reproducibility and reliability of nanoparticle genotoxicity studies.

A REVIEW OF RECENT APPLICATIONS OF NEAR INFRARED SPECTROSCOPY, AND OF THE CHARACTERISTICS OF A NOVEL PbS CCD ARRAY-BASED NEAR-INFRARED SPECTROMETER

ABSTRACT Near-infrared spectroscopy (NIRS) has been gaining popularity as an analytical tool due to advances in the power of personal computers, which allow the extraction of chemical and physical information about a sample, and the utilization of cost efficient and robust CCD array-based spectrometers. In this review, applications of NIRS are explored, within various fields of analytical chemistry, which take advantage of the inherent rapid analysis time and minimal sample preparation that is possible. For the purposes of illustration, the usefulness and limitations of a novel, PbS array-based spectrometer are described in the context of its application to the analysis of a variety of samples.

Resonant Laser Ablation of Metals Detected by Atomic Emission in a Microwave Plasma and by Inductively Coupled Plasma Mass Spectrometry

It has been shown that an increase in sensitivity and selectivity of detection of an analyte can be achieved by tuning the ablation laser wavelength to match that of a resonant gas-phase transition of that analyte. This has been termed resonant laser ablation (RLA). For a pulsed tunable nanosecond laser, the data presented here illustrate the resonant enhancement effect in pure copper and aluminum samples, chromium oxide thin films, and for trace molybdenum in stainless steel samples, and indicate two main characteristics of the RLA phenomenon. The first is that there is an increase in the number of atoms ablated from the surface. The second is that the bandwidth of the wavelength dependence of the ablation is on the order of 1 nm. The effect was found to be virtually identical whether the atoms were detected by use of a microwave-induced plasma with atomic emission detection, by an inductively coupled plasma with mass spectrometric detection, or by observation of the number of laser pulses required to penetrate through thin films. The data indicate that a distinct ablation laser wavelength dependence exists, probably initiated via resonant radiation trapping, and accompanied by collisional broadening. Desorption contributions through radiation trapping are substantiated by changes in crater morphology as a function of wavelength and by the relatively broad linewidth of the ablation laser wavelength scans, compared to gas-phase excitation spectra. Also, other experiments with thin films demonstrate the existence of a distinct laser–material interaction and suggest that a combination of desorption induced by electronic transition (DIET) with resonant radiation trapping could assist in the enhancement of desorption yields. These results were obtained by a detailed inspection of the effect of the wavelength of the ablation laser over a narrow range of energy densities that lie between the threshold of laser-induced desorption of species and the usual analytical ablation regime. Normal ablation employs high-power lasers in an attempt to create a vapor plume without selective vaporization, and with a stoichiometry that accurately represents the stoichiometry of species in the solid sample. RLA, as a method of selective vaporization, appears to provide an opportunity to exploit selective vaporization in new ways.

Chromatographic methods for the quantification of free and chelated gadolinium species in MRI contrast agent formulations.

AbstractSpeciation measurements of gadolinium in liposomal MRI contrast agents (CAs) are complicated by the presence of emulsifiers, surfactants, and therapeutic agents in the formulations. The present paper describes two robust, hyphenated chromatography methods for the separation and quantification of gadolinium in nanoemulsion-based CA formulations. Three potential species of gadolinium, free gadolinium ion, gadolinium chelated by diethylenetriamine pentaacetic acid, and gadolinium chelated by 1,2-dimyristoyl-sn-glycero-3-phosphoethanolamine-N-diethylenetriaminepentaacetic acid, were present in the CA formulations. The species were separated by reversed-phase chromatography (reversed phase high-performance liquid chromatography, RP-HPLC) or by high-pressure size-exclusion chromatography (HPSEC). For RP-HPLC, fluorescence detection and post-column online isotope dilution inductively coupled plasma mass spectrometry (ID-ICP-MS) were used to measure the amount of gadolinium in each species. Online ID-ICP-MS and species-specific isotope dilution (SID)-ICP-MS were used in combination with the HPSEC column. The results indicated that some inter-species conversions and degradation had occurred within the samples and that SID-ICP-MS should be used to provide the most reliable measurements of total and speciated gadolinium. However, fluorescence and online ID-ICP-MS might usefully be applied as qualitative, rapid screening procedures for the presence of free gadolinium ions. FigureChromatographic methods, including size exclusion chromatography coupled to ICP-MS detection, were developed for the preclinical speciation and quantification of gadolinium in several liposome-based contrast agent formulations

A Review of Near‐Field Laser Ablation for High‐Resolution Nanoscale Surface Analysis

Abstract Traditional laser ablation is a well‐known method of solid sampling for surface characterization, but the resolution of the technique has been limited by the diameter of the incident laser beam and is typically on the order of 100–200 µm. Unfortunately, this microscale resolution can be too low to characterize isolated surface features that have submicron dimensions. Near‐field laser ablation is an emerging analytical tool for nanoscale, high‐resolution surface analysis. In this review, applications of near‐field laser ablation for solid sample introduction are explored. Also, a descriptive overview of the near‐field region is given, and methods of generating a near‐field region and several processes for tip manufacture are described.

Raman Spectroscopy for the Undergraduate Teaching Laboratory: Quantification of Ethanol Concentration in Consumer Alcoholic Beverages and Qualitative Identification of Marine Diesels Using a Miniature Raman Spectrometer

Abstract Raman spectroscopy has steadily gained popularity as a powerful tool in both the analytical lab and the undergraduate classroom. The technique is attractive because it allows for rapid, nondestructive qualitative or quantitative analyses of many analytes with little or no sample preparation requirements. The introduction of less expensive, smaller, and more powerful diode laser excitation sources and the recent availability of rugged, red‐sensitive, charge‐coupled device–based miniature modular spectrometers has prompted the integration of Raman spectroscopy into the undergraduate curriculum. We have evaluated the analytical utility of a small, portable Raman instrument for the qualitative and quantitative analyses of two “real” samples. The experiments in this paper were designed to be used as a laboratory component for undergraduate education and include the quantification of ethanol in consumer alcoholic beverages and the qualitative identification of marine diesel fuels that had been spilled on surface waters. In the case of the liquor samples, the ethanol concentration in colorless, odorless alcoholic beverages could be determined very rapidly, but colored and heavily scented liquors proved more difficult and required pretreatment with activated carbon to remove fluorescence that masked the Raman signal. Similarly, a high‐intensity fluorescence background was observed to mask characteristic Raman bands of the diesel fuels. Some reduction in the intensity of the fluorescence was observed after carbon pretreatment of the fuels. The set of undergraduate experiments described in this paper treat the concepts of quantitative and qualitative analysis using portable instrumentation, instrumental calibration by the standard addition and external curve methods, and method development for the analysis of real consumer and environmental samples.

Teaching Raman Spectroscopy in Both the Undergraduate Classroom and the Laboratory with a Portable Raman Instrument

Abstract We have evaluated a small portable Raman instrument on loan from B&W Tek, Inc., and have determined that it can successfully be used in the classroom both as a visual aid for teaching the fundamentals of Raman spectroscopy and for a variety of undergraduate experiments as a normal component of an instrumental analysis class. Having portable Raman instrumentation would allow the instructor to demonstrate the principles of Raman spectroscopy, as well as the concepts of calibration curves, blank subtraction, detection limits, and regression analysis. Both qualitative and quantitative types of experiments were done for solid Tylenol tablets, aqueous solutions of isopropyl alcohol, dimethyl sulfoxide, methanol, and ethanol, and gaseous CO2 and N2O4. Additionally, surface‐enhanced resonance Raman spectra of Rhodamine 6G were obtained using a chloride ion–activated silver colloid. Spectra from the B&W Tek, Inc., instrument were comparable to literature Raman spectra.

Acute and chronic toxicity of aluminum to a unionid mussel (Lampsilis siliquoidea) and an amphipod (Hyalella azteca) in water‐only exposures

The US Environmental Protection Agency (USEPA) is reviewing the protectiveness of the national ambient water quality criteria (WQC) for aluminum (Al) and compiling a toxicity data set to update the WQC. Freshwater mussels are one of the most imperiled groups of animals in the world, but little is known about their sensitivity to Al. The objective of the present study was to evaluate acute 96-h and chronic 28-d toxicity of Al to a unionid mussel (Lampsilis siliquoidea) and a commonly tested amphipod (Hyalella azteca) at a pH of 6 and water hardness of 100 mg/L as CaCO3 . The acute 50% effect concentration (EC50) for survival of both species was >6200 μg total Al/L. The EC50 was greater than all acute values in the USEPA acute Al data set for freshwater species at a pH range of 5.0 to <6.5 and hardness normalized to 100 mg/L, indicating that the mussel and amphipod were insensitive to Al in acute exposures. The chronic 20% effect concentration (EC20) based on dry weight was 163 μg total Al/L for the mussel and 409 μg total Al/L for the amphipod. Addition of the EC20s to the USEPA chronic Al data set for pH 5.0 to <6.5 would rank the mussel (L. siliquoidea) as the fourth most sensitive species and the amphipod (H. azteca) as the fifth most sensitive species, indicating the 2 species were sensitive to Al in chronic exposures. The USEPA-proposed acute and chronic WQC for Al would adequately protect the mussel and amphipod tested; however, inclusion of the chronic data from the present study and recalculation of the chronic criterion would likely lower the proposed chronic criterion. Environ Toxicol Chem 2018;37:61-69. Published 2017 Wiley Periodicals Inc. on behalf of SETAC. This article is a US government work and, as such, is in the public domain in the United States of America.