David K. Bradley

The experimental plan for cryogenic layered target implosions on the National Ignition Facility—The inertial confinement approach to fusion

Ignition requires precisely controlled, high convergence implosions to assemble a dense shell of deuterium-tritium (DT) fuel with ρR>∼1 g/cm2 surrounding a 10 keV hot spot with ρR ∼ 0.3 g/cm2. A working definition of ignition has been a yield of ∼1 MJ. At this yield the α-particle energy deposited in the fuel would have been ∼200 kJ, which is already ∼10 × more than the kinetic energy of a typical implosion. The National Ignition Campaign includes low yield implosions with dudded fuel layers to study and optimize the hydrodynamic assembly of the fuel in a diagnostics rich environment. The fuel is a mixture of tritium-hydrogen-deuterium (THD) with a density equivalent to DT. The fraction of D can be adjusted to control the neutron yield. Yields of ∼1014−15 14 MeV (primary) neutrons are adequate to diagnose the hot spot as well as the dense fuel properties via down scattering of the primary neutrons. X-ray imaging diagnostics can function in this low yield environment providing additional information about ...

Symmetry tuning via controlled crossed-beam energy transfer on the National Ignition Facilitya)

The Hohlraum energetics experimental campaign started in the summer of 2009 on the National Ignition Facility (NIF) [E. I. Moses et al., Phys. Plasmas 16, 041006 (2009)]. These experiments showed good coupling of the laser energy into the targets [N. Meezan et al., Phys. Plasmas 17, 056304 (2010)]. They have also demonstrated controlled crossed-beam energy transfer between laser beams as an efficient and robust tool to tune the implosion symmetry of ignition capsules, as predicted by earlier calculations [P. Michel et al., Phys. Rev. Lett. 102, 025004 (2009)]. A new linear model calculating crossed-beam energy transfer between cones of beams on the NIF has been developed. The model has been applied to the subscale Hohlraum targets shot during the National Ignition Campaign in 2009. A good agreement can be found between the calculations and the experiments when the impaired propagation of the laser beams due to backscatter is accounted for.

Capsule implosion optimization during the indirect-drive National Ignition Campaign

Capsule performance optimization campaigns will be conducted at the National Ignition Facility [G. H. Miller, E. I. Moses, and C. R. Wuest, Nucl. Fusion 44, 228 (2004)] to substantially increase the probability of ignition. The campaigns will experimentally correct for residual uncertainties in the implosion and hohlraum physics used in our radiation-hydrodynamic computational models using a variety of ignition capsule surrogates before proceeding to cryogenic-layered implosions and ignition experiments. The quantitative goals and technique options and down selections for the tuning campaigns are first explained. The computationally derived sensitivities to key laser and target parameters are compared to simple analytic models to gain further insight into the physics of the tuning techniques. The results of the validation of the tuning techniques at the OMEGA facility [J. M. Soures et al., Phys. Plasmas 3, 2108 (1996)] under scaled hohlraum and capsule conditions relevant to the ignition design are shown ...

X-ray backlighting for the National Ignition Facility (invited)

X-ray backlighting is a powerful tool for diagnosing a large variety of high-energy-density phenomena. Traditional area backlighting techniques used at Nova and Omega cannot be extended efficiently to NIF-scale. New, more efficient backlighting sources and techniques are required and have begun to show promising results. These include a backlit-pinhole point projection technique, pinhole and slit arrays, distributed polychromatic sources, and picket fence backlighters. In parallel, there have been developments in improving the data SNR and hence quality by switching from film to CCD-based recording media and by removing the fixed-pattern noise of MCP-based cameras.

Measuring symmetry of implosions in cryogenic Hohlraums at the NIF using gated x-ray detectors (invited)

Ignition of imploding inertial confinement capsules requires, among other things, controlling the symmetry with high accuracy and fidelity. We have used gated x-ray imaging, with 10 μm and 70 ps resolution, to detect the x-ray emission from the imploded core of symmetry capsules at the National Ignition Facility. The measurements are used to characterize the time dependent symmetry and the x-ray bang time of the implosion from two orthogonal directions. These measurements were one of the primary diagnostics used to tune the parameters of the laser and Hohlraum to vary the symmetry and x-ray bang time of the implosion of cryogenically cooled ignition scale deuterium/helium filled plastic capsules. Here, we will report on the successful measurements performed with up to 1.2 MJ of laser energy in a fully integrated cryogenics gas-filled ignition-scale Hohlraum and capsule illuminated with 192 smoothed laser beams. We will describe the technique, the accuracy of the technique, and the results of the variation in symmetry with tuning parameters, and explain how that set was used to predictably tune the implosion symmetry as the laser energy, the laser cone wavelength separation, and the Hohlraum size were increased to ignition scales. We will also describe how to apply that technique to cryogenically layered tritium-hydrogen-deuterium capsules.

Electronic conduction in shock-compressed water

The optical reflectance of a strong shock front in water increases continuously with pressure above 100 GPa and saturates at ∼45% reflectance above 250 GPa. This is the first evidence of electronic conduction in high pressure water. In addition, the water Hugoniot equation of state up to 790 GPa (7.9 Mbar) is determined from shock velocity measurements made by detecting the Doppler shift of reflected light. From a fit to the reflectance data we find that an electronic mobility gap ∼2.5 eV controls thermal activation of electronic carriers at pressures in the range of 100–150 GPa. This suggests that electronic conduction contributes significantly to the total conductivity along the Neptune isentrope above 150 GPa.

Hot electron measurements in ignition relevant Hohlraums on the National Ignition Facility

On the National Ignition Facility (NIF), hot electrons generated in laser heated Hohlraums are inferred from the >20 keV bremsstrahlung emission measured with the time integrated FFLEX broadband spectrometer. New high energy (>200 keV) time resolved channels were added to infer the generated >170 keV hot electrons that can cause ignition capsule preheat. First hot electron measurements in near ignition scaled Hohlraums heated by 96-192 NIF laser beams are presented.

Capsule performance optimization in the National Ignition Campaign

A capsule performance optimization campaign will be conducted at the National Ignition Facility [G. H. Miller et al., Nucl. Fusion 44, 228 (2004)] to substantially increase the probability of ignition by laser-driven hohlraums [J. D. Lindl et al., Phys. Plasmas 11, 339 (2004)]. The campaign will experimentally correct for residual uncertainties in the implosion and hohlraum physics used in our radiation-hydrodynamic computational models before proceeding to cryogenic-layered implosions and ignition attempts. The required tuning techniques using a variety of ignition capsule surrogates have been demonstrated at the OMEGA facility under scaled hohlraum and capsule conditions relevant to the ignition design and shown to meet the required sensitivity and accuracy. In addition, a roll-up of all expected random and systematic uncertainties in setting the key ignition laser and target parameters due to residual measurement, calibration, cross-coupling, surrogacy, and scale-up errors has been derived that meets the required budget.

National Ignition Facility scale hohlraum asymmetry studies by thin shell radiography

A necessary condition for igniting indirectly driven inertial confinement fusion (ICF) capsules on the National Ignition Facility (NIF) is controlling drive asymmetry to the 1% level [S. W. Haan, S. M. Pollaine, J. D. Lindl et al., Phys. Plasmas 2, 2480 (1995)]. Even flux-asymmetry modes (e.g., Legendre modes P2, P4, P6, and P8) must be reduced by hohlraum design and laser beam pointing. Odd flux-asymmetry modes (e.g., Legendre modes P1, P3, P5, etc.) are theoretically removed by reflection symmetry across the hohlraum midplane [S. M. Pollaine and D. Eimerl, Nucl. Fusion 38, 1523 (1998)], but will be produced by power imbalance, laser beam pointing errors, and target fabrication errors. An experimental campaign is now being conducted on the University of Rochester’s Omega laser to measure higher order (P4 and higher) flux asymmetry modes inside hohlraums that approximate the conditions of a NIF hohlraum during the 90 eV early drive phase [S. W. Haan, S. M. Pollaine, J. D. Lindl et al., Phys. Plasmas 2, 24...

Efficient, 1–100-keV x-ray radiography with high spatial and temporal resolution

Transient x-ray radiography using laser-plasma emission is a powerful tool for diagnosing a large variety of high-energy-density phenomena. Traditional area- and point-backlighting techniques used at inertial confinement fusion facilities such as Nova and Omega cannot be extended efficiently to the future 100-times-larger National Ignition Facility. We have developed an x-ray backlighting technique that uses a backlit pinhole as a source for point-projection radiography. This method incorporates the principal advantages of point projection over traditional area backlighting in that it requires far less backlighter energy and produces data that are free from residual backlighter plasma structure. Moreover, the use of pinholes overcomes the usual disadvantages of point projection from pin targets, namely, degradation of spatial resolution and cooling due to plasma expansion.