E. M. Konchekov

Backscattering of gyrotron radiation and short-wavelength turbulence during electron cyclotron resonance plasma heating in the L-2M stellarator

Backscattering of gyrotron radiation (θ = π) by short-wavelength density fluctuations (k⊥ = 30 cm−1) in the plasma of the L-2M stellarator was studied under conditions of electron cyclotron resonance (ECR) plasma heating at the second harmonic of the electron gyrofrequency (75 GHz). The scattering of the O-wave emerging due to the splitting of the linearly polarized gyrotron radiation into the X- and O-waves was analyzed. The signal obtained after homodyne detection of scattered radiation is a result of interference of the reference signal, the quasi-steady component, and the fast oscillating component. The coefficients of reflection of the quasi-steady component, R=2(Y), and fast oscillating component, R∼2(Y), of scattered radiation are estimated. The growth of the R∼2(Y) coefficient from 3.7 × 10−4 to 5.2 × 10−4 with increasing ECR heating power from 190 to 430 kW is found to correlate with the decrease in the energy lifetime from 1.9 to 1.46 ms. The relative density of short-wavelength fluctuations is estimated to be 〈n∼2〉/〈ne2〉 = 3 × 10−7. It is shown that the frequencies of short-wavelength fluctuations are in the range 10–150 kHz. The recorded short-wavelength fluctuations can be interpreted as structural turbulence, the energy of which comprises ∼10% of the total fluctuations energy. Simulations of transport processes show that neoclassical heat fluxes are much smaller than anomalous ones. It is suggested that short-wavelength turbulence plays a decisive role in the anomalous heat transport.

Application of microwave discharge for the synthesis of TiB2 and BN nano- and microcrystals in a mixture of Ti-B powders in a nitrogen atmosphere

Synthesis of titanium diboride and boron nitride nano- and microcrystals by means of a pulsed microwave discharge in a mixture of Ti-B powders in a nitrogen atmosphere is considered. For this purpose, a new type of reactor with a free surface of the powder mixture was used. The reactor design permits free expansion of the reaction products into the reactor volume and their deposition on the reactor walls. Conditions for the synthesis of TiB2 and BN compounds were studied as functions of the energy input in the discharge, the powder component ratio, the rate of the nitrogen flow through the reactor, and the structure and phase composition of the compounds deposited on the reactor walls. The synthesis of boron nitride and titanium diboride in crystal structures is proven. An important role in the process of synthesis is played by the heating of the mixture due to the titanium diboride synthesis reaction, its behavior in the bulk of the reactor, and the titanium concentration in the powder mixture. It is also found that, as the number of discharges in the bulk of the reactor increases, a dust cloud forms. The luminescence of this cloud indicates that the initiated discharge proceeds not only on the powder surface and in the powder bulk, but also in the reactor volume.

A new MIG-3 gyrotron complex for creation and heating of plasma in the L-2M stellarator and the first experimental results

The characteristics of a new MIG-3 gyrotron complex for creating and heating plasma in the L-2M stellarator are presented. The first experimental results using the complex are reported. The complex consists of two three-electrode GYCOM gyrotrons of the new generation with electron beam energy recuperation, a high-voltage modulator that enables both separate and simultaneous operation of the two gyrotrons, and a control/data-recording unit. The total specific power to be inserted into plasma reaches 5 MW/m3 when both gyrotrons in operation.

Microwave method for synthesis of micro- and nanostructures with controllable composition during gyrotron discharge

Abstract. We introduce an approach toward the synthesis of micro- and nanostructures under nonequilibrium microwave discharges within metal–dielectric powder mixtures induced by powerful microwave gyrotron radiation. A new plasma-chemical reactor capable of sustaining a discharge regime with an afterglow phase of an order of magnitude longer than the gyrotron pulse duration was constructed for these experiments. In the nonequilibrium conditions of such a discharge, plasma-induced exothermic chemical reactions leading to the synthesis of various compounds were initiated. The synthesized structures were deposited on the reactor walls and on the impurity particles within the reactor. This method was tested under gyrotron-initiated discharges within various metal–dielectric powder mixtures of titanium–boron, molybdenum–boron, titanium–silicon–boron, molybdenum–boron nitride, molybdenum–tungsten–boron nitride, and so on. Depending on the powder mixture composition, reactor atmosphere, and other parameters, micro- and nanosized particles of boron nitride, titanium diboride, molybdenum boride, titanium boride, molybdenum, and molybdenum oxide, were synthesized, detected, and analyzed.

Displacement of the electron cyclotron resonance heating region and time evolution of the characteristics of short-wavelength turbulence in the 3D magnetic configuration of the L-2M stellarator

Reflection of the heating extraordinary microwave incident obliquely onto the surface of the electron cyclotron resonance (ECR) at the second harmonic of the electron gyrofrequency in the 3D magnetic configuration of the L-2M stellarator was studied experimentally. The plasma was heated using two gyrotrons with a total power of 600–700 kW, the specific heating power being 2.4–2.8 MW/m3. The displacement of the ECR region in the course of heating was monitored by measuring the phase of the reflected extraordinary wave. It is found that the growth of the plasma density is accompanied by the displacement of the ECR heating region from the center of the plasma column toward its periphery. The coefficient of reflection of the heating microwave beam from the ECR region was measured. The spectra of short-wavelength (ks ≈ 30 cm−1) plasma density fluctuations were explored by analyzing backscattered microwave radiation. A tenfold increase in the energy of short-wavelength density fluctuations and the growth of the spectral density of fluctuations in the frequency range of 0.3–1.5 MHz were observed.

Effect of microwave reflection from the region of electron cyclotron resonance heating in the L-2M stellarator

In experiments on electron cyclotron resonance (ECR) heating of plasma at the second harmonic of the electron gyrofrequency in the L-2M stellarator, the effect of partial reflection of high-power gyrotron radiation from the ECR heating region located in the center of the plasma column was revealed. The reflection coefficient is found to be on the order of 10−3. The coefficient of reflection of an extraordinary wave from the second-harmonic ECR region is calculated in the one-dimensional full-wave model. The calculated and measured values of the reflection coefficient are found to coincide in order of magnitude.

Testing of the spectroscopic method for location of water microleakages in ITER at the L-2M stellarator

Results of testing of a possible method for location of water microleakages in the cooling system of the first wall and vacuum chamber of ITER are presented. The method consists in spectroscopic detection of the emission lines of atoms and ions of the Xe additive dissolved in water. These lines are excited when the water with dissolved Xe contacts the plasma. The high electron cyclotron resonance heating (ECRH) power deposited in a relatively small plasma volume in the L-2M stellarator (P = 0.5 MW, V = 0.24 m3, and the specific heating power ∼2 MW/m3) makes it possible to achieve plasma parameters close to those in the edge plasma of ITER for different operating modes, including the H-mode with an edge transport barrier. In test experiments, several lines of Xe ions were revealed suitable for detection of xenon in plasma with parameters close to those in the edge plasma of ITER at leakage rates at a level of ∼10−6 Pa m3 s−1 and spatial resolution of ∼0.5 cm.

Reflection and backscattering of microwaves under doubling of the plasma density and displacement of the gyroresonance region during electron cyclotron resonance heating of plasma in the l-2M stellarator

Reflection and backscattering of high-power (400 kW) gyrotron radiation creating and heating plasma at the second harmonic of the electronic cyclotron frequency in the L-2M stellarator have been investigated experimentally. The effect of the displacement of the gyroresonance region from the axis of the plasma column under doubling of the plasma density on the processes of reflection and backscattering of microwave radiation has been examined. A near doubling of short-wavelength (k⊥ ≈ 30 cm–1) turbulent density fluctuations squared is observed. The change in the energy confinement time under variations of plasma parameters and characteristics of short-wavelength turbulence is discussed. A discrepancy between the measured values of the reflection coefficient from the electron cyclotron resonance heating region and predictions of the one-dimensional model is revealed.

Effect of electron-cyclotron resonance plasma heating conditions on the low-frequency modulation of the gyrotron power at the L-2M stellarator

Low-frequency modulation of the gyrotron power at the L-2M stellarator was studied at different modes of plasma confinement. The plasma was heated at the second harmonic of the electron gyrofrequency. The effect of reflection of gyrotron radiation from the region of electron-cyclotron resonance plasma heating, as well as of backscattering of gyrotron radiation from fluctuations of the plasma density, on the modulation of the gyrotron power was investigated.

Spectra of low-frequency modulation of gyrotron radiation during electron-cyclotron resonance heating of plasma in the L-2M stellarator

Results from experimental studies of the modulation of the gyrotron power during electron cyclotron resonance heating of plasma L-2M stellarator are presented. It is shown that the modulation spectrum consists of separate spectral bands, among which a 20-kHz peak with a spectral density exceeding by one order of magnitude the spectral density of the other peaks is observed. This can be explained by the gyrotron operation being affected by the wave reflected from long-wavelength plasma fluctuations.