Eliza Maria Agueda Russo

Influence of intrapulpal pressure simulation on the bond strength of adhesive systems to dentin

The purpose of this study was to evaluate the influence of intrapulpal pressure simulation on the bonding effectiveness of etch & rinse and self-etch adhesives to dentin. Eighty sound human molars were distributed into eight groups, according to the permeability level of each sample, measured by an apparatus to assess hydraulic conductance (Lp). Thus, a similar mean permeability was achieved in each group. Three etch & rinse adhesives (Prime & Bond NT - PB, Single Bond -SB, and Excite--EX) and one self-etch system (Clearfil SE Bond--SE) were employed, varying the presence or absence of an intrapulpal pressure (IPP) simulation of 15 cmH2O. After adhesive and restorative procedures were carried out, the samples were stored in distilled water for 24 hours at 37 degrees C, and taken for tensile bond strength (TBS) testing. Fracture analysis was performed using a light microscope at 40 X magnification. The data, obtained in MPa, were then submitted to the Kruskal-Wallis test ( a = 0.05). The results revealed that the TBS of SB and EX was significantly reduced under IPP simulation, differing from the TBS of PB and SE. Moreover, SE obtained the highest bond strength values in the presence of IPP. It could be concluded that IPP simulation can influence the bond strength of certain adhesive systems to dentin and should be considered when in vitro studies are conducted.

Infiltração marginal em cavidades de classe V restauradas com materiais estéticos, utilizando diferentes técnicas restauradoras

The purpose of this study was to compare the microleakage of class V cavities restored with composite resin (CR), resin-modified glass ionomer cement (RMGIC) and polyacid-modified resin composite (PAMRC), using different clinical procedures. Thirty-six noncarious human molars were used in this study. A class V cavity, measuring approximately 3 mm x 4 mm x 2 mm, was prepared in each tooth in both buccal and lingual aspects, with a diamond bur (number 1,093) at high speed, with coolant water spray. The occlusal margin was located on enamel and the gingival margin was located on dentin. The teeth were divided into 9 groups with 8 specimens each. The cavities were restored according to different techniques. The specimens from groups 1, 2, 4 and 5 did not receive acid etching. The samples were stored in water at 37 degrees C for 24 hours, subjected to occlusal load, thermocycled and immersed in rhodamine B. The restorations were then washed and sectioned in buccolingual direction. The depth of dye penetration was scored from zero (no leakage) to 3 (maximum leakage). The Kruskal-Wallis test revealed statistically significant differences between the materials (p < 0.05). PAMRC used without acid etching showed the greatest score of leakage in both margins. In the gingival margin, CR showed scores of leakage lower than those of PAMRC and RMGIC. Additional retentions and acid etching were able to decrease microleakage in PAMRC restorations in both gingival and occlusal margins.